A swimming pool whose dimension is width=2650mm Length =11200mm is covered with movable platform . The gap between the bar of platform is 30mm. what should be speed of movable platform so that when it move upward it does not carry water with it.

A swimming pool whose dimension is width=2650mm Length =11200mm is covered with movable platform . The gap between the bar of platform is 30mm. what should be speed of movable platform so that when it move upward it does not carry water with it.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter8: Time And Time-related Variables In Engineering

Section: Chapter Questions

Problem 45P

See similar textbooks

Related questions

Q: Determine the magnitude of W so that the 400 N body will have an acceleration up the plane of 1.2…

Q: The elevations of the ski jumping hill are as follows: hA = 44 m hB = 1.6 m hC = 4.9 m If the…

A: Given: hA = 44 mhB = 1.6 mhC = 4.9 m Velocity at point B = 27.9 m/s

Q: Suppose that you throw a ball straight up at 10 m/s and release it at 2 m above the ground. (a) What…

A: Given, Initial heighth = 2 m, initial velocityv0 = 10 m/s We know, acceleration due to gravityg =…

Q: An open cylindrical tank 30 cm in diameter and 80 cm high is 3/5 full of water. If it is rotated…

Q: 2. A boy is flying a kite at a height of 50 meters. The kite is moving horizontally away from the…

Q: A man can row a boat at 5 m/s in still water. He wishes to cross a 50-m wide river to point B 50m…

Q: an open cylindrical tank 45 cm in diameter and 135 cm tall is full of water and revolved about its…

A: Given Data: Given Data:Diameter of the tank (d) = 45cm = 0.45mheight of tank (z) = 135cm =…

Q: Water flows into a cylindrical tank at the rate of 20 m^3 /s. How fast is the water surface rising…

A: The water will rise inside the cylindrical tank with a velocity of 1.6m/s For explanation please see…

Q: Water is flowing through a venturimeter shown. The difference in pressure between A (D = 5cm) and B…

A: Given data in question Diameter Head loss To find out Velocity head at A

Q: An open cylindrical tank having a radius of 0.43 m. and a height of 1.9 m. is filled with water at a…

Q: Determine whether the flow is turbulent or laminar if a fluid flows at 0.001?^3/? through a 100mm…

Q: Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level…

Q: A tank 1.5 m square contains 1m of water. How high (in m) must its sides be so that no water is to…

Q: The 70-kg boy slides down the smooth water slide. If he starts from rest at A, determine his speed…

Q: A tank 2.0 m by 2.5 m is filled with water through a 250-mm diameter pipe. Determine the average…

Q: What is the water velocity V (m/s) inside the given pipe? the liquid specific gravity S-9.8. 40 cm…

A: Given data in question Specific gravity Deflection of manometric fluid To find out Velocity of…

Q: A container carrying water is moved in a horizontal direction with acceleration of 2.45 m/s². The…

Q: A siphon is used at point A to draw the water from large reservoir and discharge it to the point B…

A: Given data- Difference of points A and B hL=10 mTo Find-the velocity v at point B

Q: a). A cannon located 10 m from the ground is used to shoot a metal ball directly upward into the air…

A: a ) Maximum height the ball will travel measured from the ground Maximum height the ball will…

Q: A truck is mounted with an open tank 10 m long x 2.75 m wide x 2.50 m high. The tank is 3/5 full of…

Q: a speed of (50 cm/sec) through the first section of a pipe with a diameter of (25 cm). The diameter…

Q: The tank shown in figure is of a depth d = 48.8 cm and width w =24.4 cm accelerated by ax =…

A: Depth of tank, d=48.8 cm Width of tank, w=24.4 cm Horizontal acceleration of tank, ax=3.43 m/sec2 No…

Q: Determine the relationship which governs the velocities of the three cylinders, and state the number…

A: The given values are as follows,VA=2.38M/SVC=1.93m/sTo determine ,Degree of freedomThe velocity of B

Q: A jet of water is flowing through a nozzle and hits a revolving flat surface shown below. The flow…

A: Given: The mass flow rate is 35 kg/sec. The flow velocity is 8 m/sec. Consider the figure,

Q: - Diameter 1 ft V =10 t/s -4 ft-

A: Using the continuity equation. The discharge in the tank will be equal to discharge through the…

Q: Example. A pump lifts water from a large tank at a rate of 30 Ls. If the input power is 10 kW and…

A: Q=30lpsP=10kWη=40%so,η=output input×1000.4=output 10×100output=4kW

Q: A body is falling from a high minaret, travels 40 metres in the last two seconds of its fall to…

Q: A volleyball player throws the ball with an initial velocity that makes an angle ?= 35º with the…

A: Given,θ = 30o, L = 12 mh = 2.40 m, Y = 2.15 mHorizontal component of initial velocity, Vox =…

Q: 2. An open cylindrical vessel 1.2 m in diameter and 2.1 m high is 2/3 full of water. Compute the…

A: Buoyancy force: The upward force which is exerted by the fluid which opposes the weight of the fully…

Q: Three pipes are connected in parallel. The difference in heads in each pipe is 40 m. Pipes Diameter…

Q: What would be the critical velocity (in m/s, up to two decimal places) of the water flowing through…

A: given- discharge Q=20 m3/swidth B=10 mg=10 m/s2top width T=B=10 m

Q: The height of water above the 5 mm diameter orifice stands 180 mm. What is the theoretical velocity…

Q: What is the water velocity V (m/s) inside the given pipe? the liquid specific gravity s=9.5. 40 cm…

A: Given data Deflection of fluid Specific gravity To find Velocity

Q: water is flowing into a conical vessel 21 cm deep and 13 cm across the top. if the rate at which the…

Q: A pipe 200 mm in diameter and 60 m long having a sharp cornered entrance (K.=0.5) draws water from a…

Q: (Fluid mechanics subject) 1. An open rectangular tank mounted on a truck is 5m long, 2m wide and…

Q: As shown in Figure, a stone is thrown vertically into the air from the top of tower 100 ft. high. At…

Q: Water flows at a rate of 6 cubic meter per second in a 2 m diameter pipe. The depth of the its water…

A: This question is related to the Fluid mechanics from Civil Engineering. In this question we…

Q: Water is pumped at a steady uniform flow rate of 0.01 m2/s through a horizontal smooth circular pipe…

Q: A pipe has a length of 331 meters. Water is flowing in the pipe at a rate of 0.2 m3/s. If the…

A: solution Given pipe length L =331mts Pipe rate Q=0.2 m2secco-efficient of friction is given as…

Q: A tank 50 cm in height is half-filled with oil. It is brought up by an elevator. Find the…

Q: An orifice having an area of 0.0003 m² is located on the vertical side of a tank. The tank has a…

A: given data: An orifice having an area of 0.0003 m² is located on the vertical side of a tank. The…

Q: 6. A ball was thrown straight upward and after 1 second it reaches its maximum height then it does…

Q: 2. Two blocks with masses m1 5 kg and m2 15 kg are connected by a rope as shown. The horizontal…

A: Free body diagram of blocksT = m.a --(i)m,g - T = m2aa = m2 gm1+m2 = 15×9.81(15+5)a = 7.3575 m/sec2

Q: A student with a mass of 80.0 kg runs up three flights of stairs in 12.0 sec. The student haa gone a…

A: Solution Given Data Mass= 80 kg Time= 12 sec Vertical Distance= 8 m

Q: 1. A block resting on a horizontal ground weighs 80 N and inclined force with a slope of 5V:12H is…

A: The given data is shown below: Weight=80NSlope=5V:12HVelocity=12m/sDistance=40mCoefficient of…

Q: A 1.5m square tank, 3m tall is drained by a 25mm-diameter orifice located at its bottom. If the tank…

A: Time(t) =45min Initial head H1=3m To find final head H2

Q: flowing through a venturimeter shown. The difference in dusing open tubes. If h is 50cm, solve the…

Q: An open cylindrical vessel 1.3 m in diameter and 2.1 m high is 2/3 full of water. If rotated about…

A: Open channel is useful for the flow of water and to get output from the power generated. Thus…

Q: 9 An open rectangular tank of dimensions 4m x 3m x 2m contains water to a height of 1.6m. It is then…

Concept explainers

State Plane Coordinate Systems

The state plane coordinate system (SPCS or SPS) is a collection of 124 coordinate systems or geographic zones prepared for particular regions of the U.S. Every state consists of one or more than one state plane zone, the boundaries of which generally follow the county lines. Inside the U.S., there are 110 zones in total, 10 more zones in Alaska, 5 in Hawaii, and 1 for Puerto Rico and US Virgin islands. The system is extensively used for geospatial and geographic data assembling by the state and local governments.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

An square open tank with base length of 1.8 meters contains 0.9 m of water. It is translated horizontally to the right with an acceleration of 4 m/s^2. (a) How high should the tank be so that no water will be spilled? (b) If acceleration is increased to 7 m/s^2, how much water will be retained?
(Fluid mechanics subject) 1. An open rectangular tank mounted on a truck is 5m long, 2m wide and 2.5m high is filled with water to a depth of 2m. C. )If the acceleration is increased to 6m/s^2, how much water is spilled out?
An open rectangular tank mounted on a truck is 5m long, 2m wide and 2.5m high is filled with water to a depth of 2m. (a) What is the maximum horizontal acceleration can be imposed on tank without spilling any water and (b) determine the accelerating force on the liquid mass? (c) If the acceleration is increased to 6 m/s2, how much water is spilled out?
Water enters a large rigid tank steadily at a rate of V . = 0.5 m3/s, and exits through a large rectangular opening through which the velocity changes linearly in the vertical direction from 4 m/s to 5 m/s. Knowing that the tank is full, determine the magnitude of the velocity through the circular opening at the top whose diameter is D = 15 cm.
an open cylindrical tank 45 cm in diameter and 135 cm tall is full of water and revolved about its own vertical axis at constant angular speed. what will be the depth of water (in meters) in the tank when it is brought to rest from an angular speed of 200 rpm.
A vertical cylindrical tank is 9 m high and 5 m in diameter. It is two thirds full of water and is rotated uniformly about its axis until on the point of overflowing. Compute the linear velocity at the circumference of the tank.
A cylindrical tank containing a fluid (sg = 0.75) is accelerated upward by a net force of 40 lb. The volume of the fluid is 1.60 cu. ft. If the depth of the fluid is 3 ft, determine the force acting on the bottom of the tank. 4 decimal places answers
A boy slides down a water chute starting from rest at A. Neglecting friction. a. which of the following gives the velocity at the end of the chute at B in ft/s. b. which of the following gives the velocity on entering the water at C in ft/s. C. which of the following gives the horizontal distance of C from B in miles.
Open cylindrical tank 1 m in diameter and 2.5 m high is three-fifth full of water. If the tank is rotated about its vertical axis, which of the following gives the angular velocity in rpm so the depth of water at the center is zero?
4. An open cylindrical tank 2 m in diameter and 4 m high contains water to a depth of 3 m. It is rotated about its own vertical axis with a constant angular speed. a. If w = 8 rad/s, how much water is spilled out and to what depth will the water stand when brought to rest?b.What angular speed w (in rpm) will just zero the depth of water at the center or the tank?c.If w = 100 rpm, how much area at the bottom of the tank is uncovered?
If the body starts from rest at A and slides 200 ft down the 30° incline, how far will it then move along the other incline? What will be the velocity when it returns to B? Coeff fr= 0.20. please use energy-work method.
A parachute rises from the ground with a constant acceleration of 2.6 m/s2. 6 secondslater, a ball is thrown vertically upward. What must be the initial speed of the ball for itto touch the parachute? Note that at point of contact their velocity is equal.