A tank (2m x2mx2m) contains three layers of liquid. The lower layer is water with helght 1m, the second layer is all with height =0.5m (specific gravity 0.9) and the upper layer is oil ( specific gravity = 0.8). Calculate the total force on the bottam of the tank, Density of wacer =1000 kg/M3

A tank (2m x2mx2m) contains three layers of liquid. The lower layer is water with helght 1m, the second layer is all with height =0.5m (specific gravity 0.9) and the upper layer is oil ( specific gravity = 0.8). Calculate the total force on the bottam of the tank, Density of wacer =1000 kg/M3

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Related questions

Q: The density of stainless steel is about 8000 kg/m3 (eight times denser than water), but a razor…

A: (a) The free body diagram of the total mass is given as, In this case, the total maximum weight of…

Q: A circular plate of 9m radius is submerged vertically in a tank of water so that its top is 4m to…

A: Given data: The radius of the circular plate is r=9 m, The mass density of the water is ρ=1000…

Q: Gate AB in Fig. (4) is 1.2 m long and 0.8 m into the paper. Neglecting atmospheric-pressure effects,…

A: Given dataLendth of the gate L AB = 1.2mTo determine the force on the gate and it's center of…

Q: A vertical rectangular gate 3m wide and 1.75m high has water on one side with surface of liquid 3m…

Q: A glass tube of intemal diameter 3 mm is immersed in mercury. The angle of contact of mercury with…

A: Given that, d=3 mm=3×10-3 mσ=0.48 N/m

Q: Find PA. Patm fluid 1 35cm A 12 cm fluid 2

Q: A 4m wide flat plate is submerged such that its top horizontal edge is at the surface of the water…

A: Since you have asked multiple questions in a single request, we would be answering only first…

Q: A sliding gate of height 1.4m and width 2.8m lies in vertical plane that weighs 25kN. When the gate…

A: Height of the sliding gate, h= 1.4 m Width of the sliding gate, b= 2.8 m Weight of the sliding gate,…

Q: watersurface. 1-3 m hinged gate P 3 m

Q: The surface tension of water in air is approximately 0.0072lbf/ft. If the atmospheric pressure is…

Q: A plane is fitted with pontoons for operation on lakes. As it taxies out for take-off, the plane…

Q: A container filled with oil has a weight of 2 kilonewtons and an empty weight of 200 newtons. If the…

A: Given data , Weight of container is W1= 200 N Weight of oil with container is W2 = 2 kN = 2000 N…

Q: Q2: calculate the percentage of the cylinder(m=2kg) that floats in the water tank shown below if the…

Q: A cubical tank is 3 m x 3 m x 3 m and is layered with1 meter of fl uid of specifi c gravity 1.0, 1…

A: Given data

Q: from old wreacks is to attach an inflatable balloon filed with air. Assume that the cannon is a…

Q: er is 1000 kg/m³, then total pressure force on the plate (in kg) is approximately

Q: A block with specific gravity of SG= 1.45 and volume V= 0.75m3, is attached to a spring scale. The…

A: Given:- A block with specific gravity of SG= 1.45 Hence density of the block = 1450 kg/m3 (as…

Q: A layer of gasoline floats on a 88 cm's of water in a tank. The pressure reading at the bottom of…

A: Let us take height of Gasoline as hg. Consider below figure: From the data given in question: hw =…

Q: A Triangular gate having a horizontal base of 1.30 m and an altitude of 2 m is inclined 45o from the…

Q: 3. A 50-ton, 6-m diameter hemispherical dome on a level surface is filled with water as shown in…

Q: For the inverted manometer shown in the figure, all the fluid are at 20 0C. If PB - PA = 687 kPa,…

A: Answer: The height of water H is 5.0983 m (509.83 cm).

Q: Calculate the force F required to hold the gate in a closed position (Fig. 2.53), if R = 0.6 m.…

Q: The belt moves at a steady velocity V and skims the top of oil tank. Assuming a linear velocity…

Q: Triangular gate having a horizontal base of 1 30 m and an altitude of 2 m is inclined 45 o from the…

Q: Q2/ The dam in Fig. below is a quarter circle 50 m wide into the paper. Determine the horizontal and…

Q: The surface tension force, σ, of water in air is approximately 0.00518 lb/ft. If the atmospheric…

Q: A sliding gate of height 1.4m and width 2.8m lies in vertical plane that weighs 25kN. When the gate…

Q: What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.00201 N/cm?…

Q: Hydrostatic Pressure and Force (a) A rectangular daan 20 n high and 10 in wide, Assning p= 1000 kg/m…

Q: A vertical sliding gate is being submerged in a 10 meter water. The gate is 5m wide and 9 m high and…

Q: 4. A sliding gate of height 1.4m and width 2.8 lies in vertical plane that weighs 25kN. Determine…

Q: plane is fitted with pontoons for operation on lakes. As it taxies out for take-off, the plane…

Q: How can you calculate the hydrostatic force FR (magnitude) and its point of application (center of…

A: Case (1) : Vertical Rectangular Plate dF = PdA ....Where P,i.e. P =ρgx is the pressure acting on…

Q: An average adult has a mass of 81 kg, knowing that the average human density is very close to that…

A: Write the given values with the suitable variables. m=81 kgρ=1000 kg/m3sg=1.263 Here, m is the mass…

Q: Gate ABC in Fig. is 1 m square and is hinged at B .It will open automatically when the water level…

A: The gate will open when the hydrostatic force F on the gate above B. That is when…

Q: 1. A block of steel (sg=7.85) will float at a mercury-water interface. What will be the ra- tio of x…

A: As per the bartleby policy we can only solve the first question from the multiple questions. Given…

Q: Consider a 6 m diameter spherical gate holding a body of water whose height equal to the diameter of…

A: Diameter = D = 6m Radius = R = D/2 = 6/2 = 3 m Horizontal Projection Area of Sphere A = 3.14 R2 =…

Q: At the surface of a freshwater spring, a manatee with a small amount of air in its lungs is…

A: Answer : Buoyant Force :- It is defined as the upward force / thrust exerted on a body by any fluid.

Q: A cylinder is formed by bolting two semicylindrical channelstogether on the inside, as shown in Fig.…

A: Apply the Bernoulli equation to find surface pressure.

Q: 3.6 A 125-ml. cube of solid oak is held submerged by a tether as shown. Calculate the force of the…

Q: "Consider a cubical water tank with a side length of 3 m. The tank is half filled with water, and is…

Q: m3 CUBICAL TANK IS FULL OF TWO DIFFERENT FLUIDS OF EQUAL PARTS ECT WAS THROWN AND WAS PARTIALLY…

A: given: specific gravity of liquid first =0.82 specific gravity of liquid second=0.9 height h=3m

Q: A two-dimensional thin flat plate is put against an airstream at 4,731.9 meters height at 1,189.88…

A: Write the given data. H=4731.9 mv=1189.88 m/sθ=16°

Q: Engineers investigate the compressibility of fluid for the aircraft hydraulics. You are required to…

Q: ô FLUID 100cm Figure Q1b 200cm Fluid with weight of 25 kN is filled into a container of width 100 cm…

A: Given data, Fluid weight = 25 KN, width = 100 cm, We have to find density and specific weight of…

Q: A flotation device is in the shape of a right cylinder, with a height of 0.500m and a face area of…

A: Dear student please rate me positive :) Stay safe stay happy ! Data - given h= 0.500 m A= 4.000…

Q: Gate AB in Fig. P2.51 is 1.2 m long and 0.8 m into the paper. Neglecting atmospheric pressure,…

A: Given: Length of gate =1.2 m width=0.8 m SG=0.82 TO determine: The force F on gate and its center of…

Q: U-shaped liquid manometer is connected to a closed tank, which contains water and air. The gage…

A: For solution refer below images.

Question

I need the answer as soon as possible

A tank (2m x2mx2m)
contains three layers of
liquid. The lower layer
is water with helght
1m, the second layer is
all with height =0.5m
(specific gravity 0.9)
and the upper layer is
oil ( specific gravity =
0.8). Calculate the total
force on the bottam
of the tank, Density of
wacer =1000 kg/M3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
Consider a cubical water tank with a side length of 3.5 m. The tank is half filled with water, and is open to the atmosphere. Now, a truck carrying this tank is accelerated at a rate of 7 m/s^2 on a flat road. The maximum vertical rise (in meters) of free surface of the water is ?"
Consider a cubical water tank with a side length of 4 m. The tank is half filled with water, and is open to the atmosphere. Now, a truck carrying this tank is accelerated at a rate of 7 m/s^2 on a flat road. The maximum vertical rise (in meters) of free surface of the water is? only HANDWRITTEN answer needed ( NOT TYPED)
A circular tank with a diameter of 4.5m is filled with two immiscible fluids. Water to a depth of 3m andoil with a relative density of 0,9 to a depth of 2mDetermine the Hydrostatic force acting on the verticalside of the tank and the position of the centre of pressure from the oil-free surface.
Panels AB and CD in Fig. are each 120 cm wide intothe paper. ( a ) Can you deduce, by inspection, which panelhas the larger water force? ( b ) Even if your deduction isbrilliant, calculate the panel forces anyway.
A 10 m x 15 m rectangular plate is submerged in water at 6 m. The plate is inclined at 35deg with the horizontal. The specific weight of water is given by y = 9.81 kN/m3. Obtain the resultant force of pressure on the plate.
A 0.9 m diameter vertical cylindrical tank which is 1 m high and is open to the atmosphere contains water upto 0.3 m height. The tank is rotated about the centerline and the water level drops at the centre, while it rises at the edges. The angular velocity at which the bottom of the tank will be just exposed is _____ rad/s.
A vertical rectangular plate is submerged half in oil (s = 0.80) and half in water such that its topedge is flushed with the oil surface. What is the ratio of the force exerted by water acting on thelower half to that by oil acting on the upper half?
Consider a heavy car submerged in water in alake with flat bottom. The driver's side door of the car is1.1 m high and 0.9 m wide, and the top edge of the door is10 m below: the water surface Determine the net forceacting on the door ( normal to its surface) and the locationof the pressure center if : (a) the car is well-sealed and itcontains air at atmospheric pressure and (b) the car is filledwith water. (Ans:102.5 kN)
An oil tanker 3m wide 2 m deep and 10 m long contains oil of density 800 kg/m3, if the tanker is closed and completely filled with the oil and accelerated horizontally at 3m/s2. a.) determine the total liquid thrust (hydrostatic force) on the front end. (in kN) b.) determine the total liquid thrust (hydrostatic force) on the rear end. (in kN)
A flotation device is in the shape of a right cylinder, with a height of 0.500m and a face area of 4.00m2 on top and bottom, and its density is 0.400 times that of fresh water. It is initially held fully submerged in fresh water, with its top face at the water surface.Then it is allowed to ascend gradually until it begins to float. How much work does the buoyant force do on the device during the ascent?
What is the pressure at the bottom of 0.5m height fluid if the container moves 5m/s2 upward? Fluid has a density of 2000kg/m3 a. 13665Pab. 13258Pac. 14810Pad. 16145Pa