a) The Electricity Company of Ghana (ECG) has noticed two different values of voltage between the No- load Voltage and the load Voltage aa the end of one of their distribution feeders. One is 80% and the 4 other is 2%. Which of these two values would you recommend to ECG to use and why?

a) The Electricity Company of Ghana (ECG) has noticed two different values of voltage between the No- load Voltage and the load Voltage aa the end of one of their distribution feeders. One is 80% and the 4 other is 2%. Which of these two values would you recommend to ECG to use and why?

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter20: Special-purpose Outlets For Ranges, Counter-mounted Cooking Unit , And Wall-mounted Oven

Section20.1: Counter-mounted Cooking Unit Circuit

Problem 6R

See similar textbooks

Related questions

Q: Set three of the most important electrical generation stations, and give at least one advantage and…

A: Nuclear power plant: Nuclear power plant are the kinds of power plant that uses the nuclear…

Q: List typical values of working voltages for Generation, Transmission and Distribution seen in the…

A: Given We need to list out typical values for generation, transmission and distribution voltages in…

Q: Additional information of Wind Power System?

A: Wind energy is also a form of solar energy. Wind energy describes the procedure by which air is used…

Q: |Fill in the table for a correctly wired duplex outlet (U.S. National Electric Code standards for…

A: The answer to the above problem is given below.

Q: Write the report about the different electricity companies available in Sultanate of Oman for Power…

A: In the MIS and Dhofar Systems, the Oman Electricity Transmission Company SAOC (OETC) is the sole…

Q: (a) With an appropriate block diagram, briefly describe the function of the main system available in…

A: Power is the basic need for the economic development of any country in the world. Availability of…

Q: 25- A) With a neat sketch discuss the working of a Grid-connected system for power generation and…

A: Grid connected system for power generation- An electrical grid is defined as an interconnected…

Q: (b) Use labelled diagrams to illustrate the differences between a stand-alone and a power-grid…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: What is HT supply?

A: What is HT supply?

Q: . Explain the environmental impacts of Hydropower plant?

Q: Evaluate the factors affecting the selection of a renewable energy system against traditional…

A: Renewable energy system: A renewable energy system is a system that uses renewable energy sources…

Q: how does Wholesale Electricity Spot Market works?

A: The wholesale electricity exchange (WESM) could even be a venue for commerce electricity as a…

Q: Question : what is the current ability of home-owner to utilize wind or install wind turbines/wind…

Q: What are the benefits of flue gases in thermal station?

A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again. The…

Q: The Electricity Company of Ghana (ECG) has noticed two different values of voltage between the No-…

A: As per the policy, i can answer only one question at a time. Given data: The difference between…

Q: Mention 3 disadvantages of renewable energy source.

A: In this question we need to mention 3 disadvantages of renewable energy source.

Q: (i) Sketch the typical single line diagram for a modern electrical power system, starting from the…

A: Here it is asked to draw the single line diagram of typical modern electrical power system. Also we…

Q: To what extent does electrical grids represent both a natural monopoly and an essential facility?

A: A natural monopoly might arise from a severe need for economies of scale coupled with high fixed…

Q: Two persons are standing near a HV equipment and working on it, when an arc flash occurred. Person A…

A: According to the given information, person A was standing directly in front of the high voltage (HV)…

Q: 5.3 A small power system consists of two buses connected by three transmission lines. Assuming that…

A: According to the guidelines solve first three subparts of question you can post other subparts in…

Q: (a) What is distribution system? (b) Explain the distribution system with neat diagram clearly.

Q: Draw the basic block diagram of a grid connected solar power generation system

A: According to the given question, it is required to draw the basic block diagram of a grid connected…

Q: a) Explain the term “suppressed demand “, and give THREE instances in which suppressed demand occurs…

A: answer a) Supressed demand is the situation where energy services provided are insufficient- due to…

Q: With a sketch of block diagram, describe the importance of smart grid in modern electric power…

A: Smart power grid integrate the various renewable energy resources such as wind farm,hydro electric…

Q: What is the percentage voltage drop for a 208V, three-phase feeder serving a load of 200A at a…

A: Given data, Voltage V = 208 V Load current i = 200 A Distance l=290 feet = 88.4 m For 4/0 copper…

Q: .) When a live conductor of public electric supply breaks down and touches the earth what will…

A: Part (a) When a live conductor of public electricity supply breaks down and touches the earth, it…

Q: Explain how electricty power is generated and tramnsimitted to customer unit. Show The single line…

A: The electrical power is generated and transmitted to the consumer : The electrical power is…

Q: Identify the parts of the wind power system shown.

A: To identify the parts of a wind power systems

Q: Assess the reasons for this drastic change in the generation fuel mix composition from 2009 to 2019.…

A: As the given pie chart shows, Coal is the largest fuel source of power generation in peninsular…

Q: With a neat sketch, explain the working of Floating gas holder type biogas plant. List any two…

A: Diagram of floating Gas holder type Biogas plant In a floating gas holder type bio gas plant, we…

Q: With a sketch of block diagram, describe the importance of smart grid in modern electric power…

A: Smart power grid integrate the various renewable energy resources such as wind farm,hydro electric…

Q: Identify a specific place where you can possibly install a micro-hydro power plant. Discuss why?

A: The explanation is as follows.

Q: What is the importance of determining power ratings of the electrical appliances and devices we use…

A: Every electrical appliance has a power rating that indicates how much electricity it requires to…

Q: A) With a neat sketch discuss the working of a stand alone system for power generation and explain…

A: A stand-alone power system is a system that is not connected to the grid power and depends only on…

Q: What is the system called if current flows through its neutral conductor? a)Balanced b)Unbalanced…

A: When system is balanced there will be no current through the neutral conductor.

Q: What is the importance of the power distribution system in the country?

A: Power distribution is very essential for any country as power generation is done in bulk always but…

Q: Transient stability of the power system can be improved by using? O single Lines O Parallel

A: Transient stabilty refers to the ability of power system to restore synchronism after large…

Q: Draw and label a single line diagram of a simplified power system

A: Any typical power system consists of a generator to generate power . It has transmission lines to…

Q: What is usable voltage of secondary distribution?

A: The usable secondary voltage distribution system is as great as 2300 V

Q: fifty unit apartment building has a 4.5-kW electric clothes dryer in each apartment. by using the…

A: In this question we will find service demand load for given question....

Q: phase-to-phase or phase-to-neutral voltage

A: Fault in Transmission line 3 phase fault Phase to phase fault Phase to ground fault Phase to Phase…

Q: (ii) Outline the considerations involved in planning a main distribution board

A: (ii) CONSIDERATIONS INVOLVED IN PLANNING THE MAIN DISTRIBUTION BOARD: Present-day structures are…

Q: 1. Explain the reasons for the low power factor in the power system network.

A: In power system, power factor become low only because of the use of highly inductive or capacitive…

Q: Briefly explain the Vertical integration in electricity regulation

A: The traditional definition of a "vertically integrated" in electricity regulation is that which owns…

Q: 41. What are the Salient Features of Indian Grid Codes for Wind Power Generation?

A: (41) The salient features of Indian Grid Codes for Wind power generation are: a. IEGC stands for…

Q: Q1 With the aid of a suitable diagram, describe an electrical system consisting of an electrical…

A: Here it is asked to describe an electrical system that consists of an electrical source, electrical…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

a) The Electricity Company of Ghana (ECG) has noticed two different values of voltage between the No-
load Voltage and the load Voltage aa the end of one of their distribution feeders. One is 80% and the
4
other is 2%. Which of these two values would you recommend to ECG to use and why?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Describe the structure and components of a power system.
Write the report about the different electricity companies available in Sultanate of Oman for Power Transmission and Distribution. Also explain about the power flow analysis in anyone of thecompany
The feeder demand load for four 14 kW residential ranges is _____? [Reference Table 220.55 and Note 2]
(a) Give the condition for the loss of load in a power generation system in terms of outages in generation units (b) Give the assumption taken for the calculation of LOLP? [Write relevant Answers in 1 or 2 sentences in each part)
Why in high voltage system, we prefer direct or small resistance? How to define the classes of load? Why we should to do such classification??(find answer from website) what are the main load curves of the power system? What is the maximum load utilization hours? What are the applications of load curve and annual load curve in the design and operation of power system? (find answer from website)
Describe the key technologies and strategies for reducing power losses during electricity transmission and distribution.
Describe the challenges and solutions associated with integrating renewable energy sources like wind and solar into the power grid.
Mention 3 disadvantages of renewable energy source.
Explain the concept of power system stability and its importance. What are the different types of power system stability, and what measures can be taken to maintain or improve stability in a power grid?
Define power quality and describe the factors that can affect it in a power distribution system.
Describe the process of power transmission and distribution in an electrical grid.
What is GMD in power system, explain in breif.