Answered: A thermal station has a maximum demand…

Engineering

Electrical Engineering

A thermal station has a maximum demand of 20,000 kW and a load factor of 40%. Units generated per annum will be?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.15P: Let a voltage source v(t)=4cos(t+60) be connected to an impedance Z=230. (a) Given the operating...

See similar textbooks

Related questions

Q: Handwritten needed. What is the required resolution of an instrument if the product characteristic…

A: Resolution is the extent to which an instrument can detect a quantity's fluctuation. With a change…

Q: Problem 2 The voltage across a 20 resistor is given by u(t)= 6 sin(2πt) V. Determine the power and…

Q: 2. Determine the voltage , across the 20-ft resistor. 15 V 4012 www 15f2 www 2012

A: Given data, Circuit diagram is given as,

Q: 12). A motor in a building system has rated power input of 4200 W with power factor of 0.65 and an…

A: Power input to motor =3×line voltage×line current ×power factor. Efficiency =output powerinput…

Q: The true value of a current Is 25mA and It is indicated in a digital Ammeter as 28 mA. The absolute…

A: Given : True value, x= 25 mA Measured Value, x0=28 mA

Q: Q5) Find the Thevenin equivalent circuit for the network in Fig. 5. Then, under the maximum power…

Q: B- For binary data (10011010) draw the (ASK, PSK, Bipolar NRZ, Unipolar RZ, AMI, Manchester) signals…

A: ASK: The Frequency of the signal is high for a 1 and relatively low for 0. PSK: V(t)=+v(a,1) , ϕ(t)…

Q: 3. If I,- 14 A, R₁ = 22, R₂ = 4 52, and R3-82, find the current 13 (in amperes). R₁ P2 P3

A: Given circuit: Here, Is=14 A,R1=2 Ω,R2=4 Ω,R3=8 Ω.

Q: current (A) Resistance (Ω) Voltage drop (V) 24cm 1 17.8 0.238 22cm 1 17.8 0.217 20cm 1…

A: Given: The current is 1 A The value of the resistance is 17.8 ohm The values of the length and…

Q: A line charge has a charge density of 10μ C/m and its length is 10 cm. The electric flux of this…

A: Given data, Line charge density λ=10 μC/m Length of line l=10 cm = 0.10 m.

Q: 1. 5. 2. 6. 七 3. 7. 4. 8.-

A: Given: Required: Names of the given diodes.

Q: Explain in not less than 6 sentences with mathematical equations the relationship of Laplace…

Q: Consider the unit impulse response of discrete time system h(n) = 8(n)-as(n-1). Find the phase delay…

Q: Consider a uniform sampling of a sinoisoidal signal: g(t)= 4sin(16000nt)/ a) What are the Nyquist…

A: Given data, gt=4sin16000πt=4sin2π×8000t

Q: Determine,if it exists,a state feedback gain K such that the closed loop poles are located at −5 and…

Q: QUESTION 13 If the output of a transistor amplifier is 5 V rms and the input is 100 mV rms the…

Q: Distinguish between ‘point-to-point’ and ‘broadcast’ modes of communication.

A: Modes of communication:- The term "modes of communication" refers to interpersonal communication…

Q: 2.) What is the decimal equivalent output of the register shown in the figure below +5V pos 4 LSB…

Q: Consider the following circuit (See image): Show that it is a unity gain absolute value circuit,…

Q: Q2: For a (3-0) medium transmission line model (T cct) as shown in next figure, find the, current…

A: Given parameters are:…

Q: If C=0.1 F and w = 10 radians/s, The impedance of an ideal capacitor in 2's is 0.1j -5j -0.1j -1j…

A: Given, Capacitance, C=0.1 μF. Angular frequency, ω=10 rad/s.

Q: (a) In cylindrical coordinates, 1 mm1.5 mm. Find D at r-2mm (b) Plane y-1 carries current K-30 a,…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: The magnetic field set up in the iron core of a transformer comes from the (A) active B) reactive…

A: Transformers are supplied with ac voltage on the primary side Transformers doesn't work with dc…

Q: 2. Determine the voltage , across the 20-12 resistor. 15 V 4011 www 1502 www 2002

Q: Q.5: Determine the inductor current for t<0 for circuit in Figure. 25 V 392 1=0 292 4 H

A: Given, The circuit is,

Q: 2. Compute the kinetic energy of an 1800 lb automobile traveling at 30 mi/hr, How many times as…

A: We need to tell about kinetic energy .

Q: 33. What is the name given to radio signals in the high-frequency range?

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: Find the capacitor voltage in the network shown in Figure P4.2 if the switch closes at t = 0. Assume…

Q: Consider the circuit shown in the figure. For sustained oscillations, find the value of attenuation…

Q: 1. Explain the operation of clippers circuit. 2. List at least 3 applications of waveshaping…

A: 1) Clipper circuit: Electronic circuits known as clipper circuits eliminate a piece of an AC signal…

Q: For the circuit shown, v1 = -3 V, v2 = 6V, determine the value of the current i V1 692 V2 $₁0

A: Given data, Circuit diagram is given as,

Q: Q3) Using the superposition theorem, find the current, voltage and the power dissipated through R,…

A: Given- Source voltage = 12 Volts and 8 Volts Source current= 6 A Resistance R1 = 6 ohm To find-…

Q: Consider Figure AA. Solve for VG if VDD = 24 V, R1-6.4Mohms, R2=4.0Mohms, RD=2.5kohms, and…

Q: i) ii) R(s) 5 G₁ G₁ G₂ G₁ G 10 -Y(s) Figure 4. Use the block diagram reduction technique to…

Q: Given that E = (3x² + y)a¸ + xa, kV/m, find the work done in moving a −2 µC charge from (0, 5, 0) to…

Q: 4. Unless the state of a NAND gate latch is being change, its inputs should both be b. low a. high…

Q: Sad Jindaleevel equivaleHetWors Fig. 1. Then, find the current through R. for values of 12 and 382,…

Q: Vin (a) Vin +12 V t 0- TALK -12 V (c) R₁ www 4.7 ΚΩ R₂ * 4.7 ΚΩ negative half cycle peak Vout= - =)…

Q: Q1) Find the Thevenin equivalent circuit for the network in the shaded area of Fig. 1. Then, find…

Q: 13). A motor with power factor of 0.85 is served by a single- phase 120 V source; the motor requires…

A: In this question we need to find a efficiency of motor and line current drawn by the motor.

Q: A hydroelectric station has an average available head of 100 meters and reservior capacity of 50…

A: It is given that: h=100 mV=50×106 m3ηe=0.9ηh=0.85

Q: Given the following circuit where Vs = 3 V, IT = 0.87 mA, R₂ = 6 k2 and R3 = 15 KQ, find R₁. Vs SR2…

Q: Write down the creation of Pulse Code Modulation and became the only digitally encoded modulation…

A: To write: the creation of Pulse Code Modulation

Q: For the circuit shown in the figure, the Thevenin voltage (Vth) at terminals a-b is: 492 ww 502 O a.…

Q: In Figure shown below, use Thevenin's Theorem to Determine RTH. VTH IN & Maximum power transfer at…

Q: The __________ ___of a differential equation can be written as linear combination of the elements of…

A: Explanation:- a) Free response:- Free response of a differential equation of a system is nothing but…

Q: What is the number of overall systems?

A: SOLUTION If we talk in reference of ELECTRICAL CONTROL SYSTEM there…

Q: If C=0.1 F and w = 10 radians/s, The impedance of an ideal capacitor in Q's is 0.1j - 5j -0.1j -1j…

A: Given, Capacitance of capacitor, C=0.1 μF. Angular frequency, ω=10 rad/s.

Q: 12. Draw the Timing diagram for INR M. > Fetching the Opcode 34 from the memory 4105H. Let the…

A: Solution !!

Q: A 3-core cable (3-Øline) transfer 33 kV and 50 Hz, If the conductor-earth capacitance (Ce) is 0.23…

Question

A thermal station has a maximum demand of 20,000 kW and a load
factor of 40 %. Units generated per annum will be?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

A 200 MW power station delivers 200 MW for 3 hours, 70 MW for 6 hours and is shut down for the rest of each day. It is also shut down for maintenance for 60 days each year. Calculate its annual load factor.
A power station has two 50MW units each running for 8500 hours in a year and one 30 MW unit running for 1250 hours in a year. The station output is 650 GWh per year. Calculate the utilization factor.
A base load station having a capacity of 18 MW and a standby station having a capacity of 20 MW shares a common load. Determine the annual load factors and plant capacity factors of two power stations from the following data: Annual standby station output = 7·35 × 106 kWh Annual base load station output = 101·35 × 106 kWh Peak load on standby station = 12MW Hours of use by standby station/year = 2100+67 hours
A 55 MW thermal plant of NGCP delivers an annual output of 356 GWh with a peak load of 39 MW. What is the capacity factor?
A 174000W substation delivers 76000 W for 7 hours and it shut down for the rest of the day. Every 52 day of the year the station is shut down for maintenance. Calculate its percentage annual load factor Percentage Annual Load factor=_______________
A generating plant has a maximum capacity of 100 kW and costs Rs 1,60,000. The annual fixed charges are 12 %. If the load factor is 50 %, the fixed charges per kWh will be ?
The feeder demand load for four 14 kW residential ranges is _____? [Reference Table 220.55 and Note 2]
A customer connected to a substation has a connected load of 45,000 KW at a demand factor of 55%. The total unit consumed annually is 85 x 10*6 kWh. Determine the annual load factor of the station.
q1: Discussion of power quality aspects that need to be considered before installing the power factor correction unit
A power plant has a capacity factor of 40.9% and a plant use factor of 45.2%. How many hours per year was the plant not operating?
ist out all the major components in a thermal power plant
A GENERATING STATION HAS A CONNECTED LOAD OF 40 MW AND A MAXIMUM DEMAND OF 20 MW : THE UNITS GENERATED BEING 60×10^6. CALCULATE THE DEMAND FACTOR .