A thyristor string is formed in series and parallel connections. The thyristors used have voltage and current ratings 2 KV and 1.5 KA and the ratings of string are 10 KV and 6 KA connections. How many thyristors in total are required?

Q: H.W: Find (HPBW) and (FNBW), in radians and degrees, for the following normalized radiation…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: A magnetic ring has a mean circumference of 20 cm and a cross-section of 20 cm² and has 800 numbers…

A: Given- A magnetic ring- Mean circumference l=20 cm, Cross-section area A=20 cm2, Number of turns of…

Q: The auto-correlation function a(t) associated with the signal x(t) is given as y(t) x(t) * x*(-t). -…

A: Given, Auto correlation of signal x(t) is y(t). i.e y(t) = x(t) * x*(-t) We need to determine the…

Q: Problem 10. An alternating voltage is given by v = 75 sin(200лt - 0.25) volts. Find (a) the…

A: Given Data:-v=75sin(200πt-0.25) voltFind:- a. Amplitudeb. peak to peak valuec. rms value

Q: Three halogen lamps are connected on the same terminal node across 115-volt, 60-Hz source. If each…

A: The three LED lamps are connected in parallel to the AC source battery which is given as: Vrms=115V…

Q: Problem 9. An alternating voltage is given by 282.8 sin 314t volts. Find (a) the rms voltage, b) the…

A:

Q: A single-phase transformer is required to step down the voltage from 1100 V to 230 V at 50 Hz. The…

A: Given:…

Q: E9.19 Find the power factor of the source and us(t) in Fig. E9.19 if f = 60 Hz. Figure E9.19 Ο.ΖΩ Us…

A:

Q: A single phase transformer is required to step down the voltage from 1100 V to 230 V at 50 Hz. The…

A:

Q: The armature of a d.c. The machine has a resistance of 0.25 ohm and is connected to a 300V supply.…

A: Resistance = 0.25 ΩΩ Voltage = 300 V As a generator Ia = 100 As a motor Ia = 80

Q: 6. By using mesh analysis, find 1₁ and 1₂ in the circuit depicted. www 202 j4 Q 30<20° V 30 20 k j10…

A: In this question,  We need to determine the current I1  and I2  as shown the circuit using the mesh…

Q: Whats is an ac circuit? Determine and explain the electrical power in AC circuits and how it works.…

A: Introduction - AC Circuit -  Alternating Current (AC) Circuits are basically circuits that are…

Q: For the circuit below, what is the Thevenin's resistance (in 2) at terminal a and b? 50 V 5Ω www ww…

A: In the case of an RLC type of circuit, a circuit can be represented by a single phase and resistor…

Q: The inverter 74 ALSO4 has the following specifications IOHmax = -0.4 mA, IoLmax = 8 MA, IiHmax = 20…

A: Given, The currents IOHmax=-0.4 mA=400 μAIOLmax=8 mAIiHmax=20 mAIiLmax=-0.1 mA

Q: find the exponential Fourier series, then sketch E(v)- 1. V 0.01 0-02 0.03 t

A:

Q: Problem 1: The switch in Fig.1 has been closed for a very long time. What is the charge on the…

A:

Q: Explain the efficiency of increasing the electrical power system of parallel transformers?

A: Given &amp; to find: Explain the efficiency of increasing the electrical power system of parallel…

Q: A circuit is shown to the right. a. Is this an example of positive feedback or negative feedback? b.…

A: Given: An op-amp circuit. To find: a) this example is of positive feedback or negative feedback? b)…

Q: Consider the system below with inputs 2₁ (t) and r₂(t): 10.4 X₁ (t) 20000 x₂ lts H₁ (jw) - 20000 t…

A: The given system is shown below,

Q: 20. Refer to Fig. 6-2-5-E7. What is the value of the current flowing through the 5 ohm resistor in…

A: B. 2.56A

Q: Solve for the transfer function, G₂ (s) = = c (t) = 3 (1+2e-2t); r(t) = 2 C(s) if: R(s)

A:

Q: a. Is this an example of positive feedback or negative feedback? b. If the circuit is an amplifier,…

A: If the output is connected to non inverting terminal of the operational amplifier then it is said to…

Q: other solution

A:

Q: Question 3: Find the Complex Power absorbed by the a. 10 resistor b. -j10 capacitor c. 5+j100…

A: NODE:  The meeting point of more than two branches in a circuit is referred to as a node. At that…

Q: Sketch a phasor representation of a three-phase source in equilibri connected in delta in the abc…

A:

Q: Given G₁ = 4(s+8) /(s+3)(s+7) and G₂=2s /(s+10) function write an m-script to determine the final…

A: Given that  G₁ = 4(s+8) /(s+3)(s+7) G₂=2s /(s+10)

Q: | Find Va- 12V Μ ΖΩ ΖΩ + 2· να Va ΖΩ

A:

Q: Question 1: Use Nodal Analysis to find the node voltages V₁ and V₂. Note: S - Siemens 20/0° mA (…

A: The circuit diagram is shown below,

Q: ow work Antennas Transmit ?

A: Introduction - A metallic arrangement that collects and/or transmits radio electromagnetic waves is…

Q: Simplified the following equations using K-map, show your Truth Table and Logical Diagram.

A: Simplify the following equations using K-map, show your Truth Table and Logical Diagram.…

Q: Exampleu Find F[et sin(wot) u(t)]

A:

Q: What is the induced voltage in the inductor if it has an inductance of 100 mH and the instantaneous…

A: The given problem is from circuits. The detailed solution is given in the next step

Q: Question 3: Using Superposition Theorem for Question 1, Find V₁ with only one of two sources is…

A: When multiple source act on circuit then circuit parameter can be obtained by using superposition…

Q: I Consider the causal discrete-time LTI system described by the following constant coefficient…

A:

Q: 6. Determine the inductor currents i₁ and i and the capacitor voltages v₁ and v₂ in the circuit…

A:

Q: Using the diagram, solve for the Rth, Vth, and load current (IL) through each resistance using…

A:

Q: G(s) = 2 12 (5+1) S² (5+6)

A:

Q: Two rings of radius R=5 cm are 34 cm apart and concentric with a common vertical axis (figure…

A: “Since you have asked posted a question with multiple sub-parts, we will solve the first three…

Q: Find Va

A: The given circuit is:

Q: 7. For a distribution system with suspension type insulators of 5 disc and string efficiency of 0.8.…

A: Given: Total number of disc, n = 5 String efficiency, η=0.8 Voltage across disc nearest to conductor…

Q: For loss less line, find the ratio of length to the wave length of a signal for a phase shift of…

A: Given: For a loss less transmission line phase shift, β=0.05 radians.

Q: Q1: The total harmonic distortion of a closed loop system is 5%. Distortion without feedback is 10%.…

A:

Q: Problem 9. An alternating voltage is given by v=282.8 sin 314t volts. Find (a) the rms voltage, (b)…

A: Alternating voltage v = 282.8 sin314t volts

Q: z Two extensive homogenous isotropic dielectrics meet on a plane z=0. For ≥0, ₁₁ = 4 and for = ≤0,…

A: Given- For z≥0 Dielectric, εr1=4 Uniform electric field, E→1=15a^x-2a^y+3a^z kWm For z≤0 Dielectric,…

Q: 4. Calculate Zeq for the circuit below. 1Ω , ΖΩ 60 -j2Q j4Q

A: We need to find out equivalent impedance for given circuit . We will find out it by using of series…

Q: The frequency (in Hz) of the power wave associated with an electromagnetic wave having an E field as…

A: Given- Electric field- E=e-zδcosωt-zδ, To Find- The frequency of the power wave.

Q: In a series circuit of R = 5 ohms and L = 0.03H the current lags the applied by 80 deg. What is the…

A: Given, In a series RL circuit, R = 5 ohms L = 0.03 H Current (i) lags voltage (V) by θ = 80° We need…

Q: What happens when you measure the resistance of the resistor plugged this way?

A: By the connections of the resistance from the image attached,

Q: Calculate the out Put y(t) of the (LPF) show belwo if X+) = te Ắc Xit) R www 4(E)

A:

Q: ● Suppose the initial physical address of a segment register is given by: OCDF:AE90H. Determine the…

A: Given data, Physical address, 0CDF:AE90H

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.