a turbine f

Q: A reversible reaction A+B⇒R+S was performed in a liquid-phase batch reac- tor. Several samples were…

A: Given reaction in a liquid batch reactor is- A+B⇔R+S Solution concentration normality=0.675 N Volume…

Q: Solve!

A: Given  cp = ∂qdT →dS=∂qrev → ∂q=TdS Cp=T∂S∂T Pressure derivatives- ∂∂PCP=T∂∂P∂S∂T To find- the…

Q: Dry air is blown through acetone at 285 K and a constant pressure of 101.3 kPa. If it is desired…

A:

Q: Hydrogen cyanide may be produced from methane, ammonia and oxygen by the Andrussov process: NH3(g) +…

A:

Q: You are working for a power plant that makes use of coal tar, a type of liquid fuel, as its raw…

A: Coal is burnt with wet air.

Q: Aqueous hydrobromic acid (HBr) reacts with solid sodium hydroxide (NaOH) to produce aqueous sodium…

A: The balanced reaction between HBr and NaOH to produce NaBr and H2O is written as, HBr (aq) + NaOH…

Q: If you know pure nitrogen gas has a pressure of 1 atm, how many intensive degrees of freedom does…

A: Write the expression for the intensive degrees of freedom as follows: f = c-p+2     ......1   Here,…

Q: In an experiment to determine the rate constant of hydrogen peroxide hydrolysis reaction, which…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: write the chemical formula for the Com Pounds. lead coffer Zinc Cadmium cyanides acid Alkalies…

A: Given Information: The chemical formula for the given compounds Lead, Copper, Zinc, Cadmium,…

Q: (a) Write equations for the thermodynamic potentials dU, dH, dA and dG as a function of natural…

A:

Q: The water-gas shift reaction is an important industrial reaction used to generate useful hydrogen…

A: Given that  CO (g)   +  H2O   (g)       ↔   H2   (g)    +    CO(2)       (g)     Flow rate of feed…

Q: Acrylonitrile is produced in the reaction of propylene, ammonia and oxygen C₂H6 + NH₂ + O₂- C₂H₂N+…

A: Given that- Acrylonitrile production reaction is- C3H6+ NH3+ 32O2→C3H3N + 3H2O Basis feed= 100 mol…

Q: 2C is carried out isothermally Q3// The gas phase reaction 2A + B isobarically. The reaction is…

A: Given reaction is- 2A+B→2C Specific reaction rate constant, k=4.0 dm3/mol.s Conditions are…

Q: Calculate the Orsat analysis of the flue gas

A:

Q: Which of the following materials combinations are most likely to fail due to excessive wear in the…

A: To find The material combination most likely to fail due to excessive wear in the short-medium term…

Q: Derive a mathematical representation of the mass flow rate of species I entering or exiting the…

A:

Q: A 10 g food sample was dried, then ashed, and analyzed for salt (NaCl) content by the Mohr titration…

A: Given data: Mass of the sample = 10 g Volume of AgNO3 consumed = 6.5 mL Amount of KCl used to…

Q: و شان N Cont sruller with ITC Characters oyun : =) (25+1) (35+1) + 51TC = (2541) (35-1) (les) + 5…

A: The closed transfer function and the value of Kc for stable operation is to be determined.

Q: 10-4 1.084 0.249 1 1 + 9 9 29- mol mol/ N (1013252) (0.416 nm)² (0.595) 1 46.07 (273 K)³/2 1 9 46.07…

A: Given equation is 10-41.084-0.249146.07+129273 K3/2146.07+129101325 Nm20.416 nm20.595   We know,  N…

Q: The elementary gas phase reaction: (CH3)3 COOC (CH3)3 → C2H6 + 2CCH3 COCH3 is carried out…

A: Given that n=1k1  =10-4 min-1T1=50 C=323.15E=85 KJmolT2=127 C=400.15 k

Q: ____tL ft ft SG=0.76 SG=1.0 A 9.6 ft B Air

A:

Q: 2. Using the compressibility data shown below, determine the residual entropy (SR) at 4.5 bar and…

A: Given Temperature T = 481K Pressure P = 4.5 bar From given table  At this temperature and pressure…

Q: In this question, I did not understand the value of YAN+1. How was it calculated? Is it 0 or 0.02?

A: A mixture of acetone, 1,1,2-trichloroethane is contacted with a mixture of water and…

Q: Ethylene gas and steam at atmospheric pressure are fed to a reaction process as an equimolar…

A: Given reaction of ethylene and steam is  C2H4(g)+H2O(g)→C2H5OH(l) Also given data are as follows:…

Q: benzene -toluene containing 55% benzene is desired to be separated at a pressure of latm in a…

A: A mixture of benzene and toluene is separated in a continuous fractionating column.

Q: 68: A fluid flows over a heated horizontal plate maintained at temperature Tw. The bulk temperature…

A:

Q: A pump draws 71 gal/min of a liquid solution having a density of 114.8 lb/ft³ from an open storage…

A: Volumetric flow rate = 71 gal/min Density = 114.8 lb/ft3 Diameter of suction line = 3.068 in…

Q: The following mechanism has been proposed for the formation of phosgene, COCl2: Use the steady…

A: Rate equation for the formation of phosgene is to be calculated.

Q: A sealed container shown in Fig. Q1 contains 1.5 mol CO₂. The pressure is 2 bar and the temperature…

A: For the given figure (Q1),  Initial temperature, T1=270C=300 K Pressure, P=2 bar Volume of…

Q: A producer gas has the following percentage volumetric composition: CO2 = 10.8 %, CO = 18.3 %, CH4 =…

A: Volumetric composition of a producer gas is given.

Q: er, 4 mm thick, k-120 W/m. C disc is welded to 10 (heater). The system is exposed to air at 20 °C,…

A:

Q: The reactants A form the product D and E at 1620 K. for a reaction rate expressed in gmol/L.s and…

A:

Q: Which of the following pairs of metals would show the highest rate of corrosion in seawater and why?…

A: The correct answer is to be identified.

Q: A pressure measuring device has been analyzed and it has been determined that the response of the…

A: “Since you have posted a question with multiple sub-parts, we will provide the solution only to the…

Q: If E> 0, in which direction will the cell reaction proceed, and conversely if E<0, in which…

A: Effect of E on the direction of cell reaction is to be discussed.

Q: A steam pipe of i.d. 7.62cm and o.d. 10.2cm passes 1360 kg/hr of superheated steam at 260°c. The…

A: Given, The inner diameter of the pipe, di = 7.62 cm The outer diameter of the pipe, do = 10.2 cm The…

Q: Q.4 Liquid methanol is pumped from a large storage tank through a 1.5-in. ID pipe at a rate of 5.00…

A: Given data: Internal diameter of pipe = 1.5 in Volumetric flow rate of fluid = 5 gal/min

Q: The ability to produce proteins through genetic engineering of microbial and mam- malian cells and…

A: Recycle flow rate is to be calculated.

Q: P is carried out in an Coll An irreversible aqueous phase reaction A + B adiabatic mixed flow…

A:

Q: Calculate the heat needed for the expansion of a quantity of 0.073 Kg of saturated dry steam to a

A: For saturated dry steam, the specific heat can be determined using the Steam Tables. At a pressure…

Q: The cubic EOS which follows the three parameter corresponding states theorem is   a.Soave Redlich…

A: To find The cubic EOS, which follows the three-parameter corresponding states theorem. Given…

Q: A triple effect forward feed evaporator is being used to remove water in an aqueous NaOH. The…

A: Given that- for a triple effect evaporator with forward feed flow mechanism. Required achievement=…

Q: During fractional distillation of a binary mixture, you start distilling component A at a certain…

A: Distillation is a separation process in which the light key components are separated from heavy key…

Q: A handbook gives Z =0.9764 for CO2 gas at 100°C and 10 bar. Estimate Z for 100°C and 20 bar. The…

A: Temperature = 100 0C or 373.15 K Pressure = 20 bar

Q: 1. The unknown hydrocarbon is burned with 40% excess air. the Orsat analysis is 8.86% CO2, 0.99% CO,…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: In a solid - liquid extraction process operated according to the principle of continuous reverse…

A: A mixture of solids, hexane and oil is to be extracted with the help of pure hexane in a…

Q: A 1,1,2-trichloroethane - acetone solution containing 42% acetone by weight at a flow rate of 1200…

A: A mixture of acetone, 1,1,2-trichloroethane is contacted with a mixture of water and…

Q: Q.3 Two Infinite Black plates at 1800k and 180C² exchange = heat by radiation calculate heat…

A: Given that- Two infinite black plates are at, temperatures T1=1800 K T2=1800C= 453 K The diagram can…

Q: For an ideal gas in a closed system with constant Cp and Cv, which of the following statements is…

A:

Q: 4.22 A heat engine absorbs 260 kJ of heat from a source at 325 K and yields a work output of 72 kJ…

A: Given data for the heat engine are as follows: Heat absorbs from source of 325 K = 260 kJ Work…