A uniform, 8.0-m, 1,150-kg beam is hinged to a wall and supported by a thin cable attached 2.0 m from the free end of the beam. The beam is supported at an angle of 30.0 above the horizontal. Draw a free-body diagram of the beam. Calculate the tension of the cable? (Non-anonymous questionO)

A uniform, 8.0-m, 1,150-kg beam is hinged to a wall and supported by a thin cable attached 2.0 m from the free end of the beam. The beam is supported at an angle of 30.0 above the horizontal. Draw a free-body diagram of the beam. Calculate the tension of the cable? (Non-anonymous questionO)

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.125P: The figure shows a three-pin arch. Determine the horizontal component of the pin reaction at A...

See similar textbooks

Related questions

Q: Fig structure carrying weight. The uniform bar AB weighs 1.1.4.4 shows a 300 N and carries a 500 N…

Q: A 100.kg box suspended from the extreme side of the horizontal truss. Assume that the truss’s weight…

Q: In the diagram below, The raccoon has a mass of 40kg and is 5m from the hinge. The beam is 8m long…

A: The racoon or any other part of the system is not moving so the system is in equilibrium condition.…

Q: Question 4. A uniform, 8 m long beam with a mass of 1150 kg is hinged to a wall and supported by a…

A: a) Free Body Diagram: b)To calculate Tension take moment about Point O: mg*L2cos30=T*(8-2)cos…

Q: A uniform 30-lb beam, 10 feet long is carried by two men A and B, one at each end of the beam. a) If…

A: Given Data Weight of uniform beam WD=30lbs Length of beam l=10ft Weight of load, Wl=50lbs Force…

Q: Is it possible for the internal reaction force in a truss to exceed that applied on the system of…

A: Given Truss To find The internal resistance forces are greater than applied force

Q: An elastic string of natural length 4l and modulus of elasticity 4mg is stretched between two points…

Q: Problem 2: For the frame shown, find the horizontal and vertical components of the reactions at A…

Q: 3/4 The 450-kg uniform I-beam supports the load shown. Determine the reactions at the supports. 5.6…

A: Weight of the beam, W=mg=450(9.81)N acts 4m from A Weight of the drum, Wd=mg=220(9.81)N acts 5.6m…

Q: Two identical rollers, each of weight W = 100 lbf, are supported by an inclined plane and vertical…

A: Given; W=100 lbf Angle θ=30° To Find, RA,RB and RC

Q: In the figure below, a diver who weighs 65kg stands at one end of a diving board preparing for a…

A: Given Data: Mass of diver, md=65 kg Mass of board, mb=20 kg

Q: 4- For the structure shown, calculate bearing reactions. 10 1200 Ib 2000 lb 100 lb/ft M 4' 8' 6' 2'

Q: Determine the horizontal and verticalcomponents of reaction for the beam loaded. Neglect the weight…

A: To find The vertical and horizontal reactions:

Q: Q4) A 500 lb buoy, with a 2 ft radius is tied to the bed of a lake using a steel cable. What is the…

A: Given, m = 500 lb r = 2 ft ρw = 62.4 lb/ft3

Q: 6. A truss which consists of a single, equilateral triangle, is supported by a pin and roller as…

A: Given Data: The weight acting at B is P =520 lb. The free body diagram of Truss can be drawn as,…

Q: Problem 1. A walkway from a pier to a float is supported by two rollers and connected to bollard…

Q: Q3\ A beam AB, 6 m long, is simply supported at A and D (where D is 1.5 m from B). It carries a 24…

A: Sign Convention SFD 1) Right Upwards Negative 2) Right Downward Positive 3) Left Upwards Positive 4)…

Q: (1) Calculate the support reaction. Draw the N, M, T diagrams of the figures given below. 10 kN 3 m…

A: A beam's shear force diagram (SFD) and bending moment diagram (BMD) depict the variation in shear…

Q: Problem 14: The 1.2 m wide gate hinged from C point is shown in the Figure. The weight of the gate…

A: Given Data, w= Width of the gate = 1.2 m Wgate = Weight of the gate = 80 x103 N To determine the…

Q: Q/Draw free body diagram then find reactions at pin support (O) and smooth surface (B) take beam OB…

Q: A uniform beam that 10-m long is being supported by two men, one man at each end. The weight of the…

Q: Calculate the reaction forces at points P and Q as [kN] using the information given in the figure.

Q: With complete computation and solution A non-uniform bar weighs 400N and is 4m long. When it is…

A: Given data Mass of non uniform rod = 400 NLength of non-uniform rod = 4 mLoad required to balance…

Q: A cable with supports at the same elevation carries a uniformly distributed load of 500 Ib/ft along…

A: The cable is subjected to UDL along the horizontal span.

Q: A uniform beam ( weight 71 N, length 6m) is being supported by cable and a hinge on a wall. The…

Q: A 6.8kg cat is standing on a uniform beam that weighs 245.0 N. The beam is supported by a hinge…

Q: A 100-lb uniform beam 16 ft long lies against a cor- Determine the maximum force ner as shown in…

A: In triangle ACB, Using the trigonometry rule, The hypotenuse is:

Q: A 10.7 m long beam is loaded as shown below and the hinge support is at x-2.4 distance from the left…

Q: A crane boom which weighs 200 lbs and which is 10 feet long is supported so that it makes an angle…

A: Diagram Considering the FBD of whole from AB=10ft AO = ABsin40 = 10sin40 = 6.43 ft OB = ABcos40 =…

Q: Example The beam ABC is loaded via a 500 N.m couple and a 600 N force as shown. The beam is…

Q: Find the force acting in each of the members of the truss shown below. Remember to specify if each…

Q: 4. For the beam shown below, calculate the support reactions and tension in the cable.

A: Given data Given force system

Q: For the beam shown below , Find the support reactions at A and B* 60 lb /ft 690 lb 40 lb/ft 12 15 ft…

Q: A object having a mass M- 26 kg, is in equilibrium and is supported with a tie back brace member…

Q: A loading car, as given in figure, is at rest on a track forming an angle of 25 with the vertical.…

Q: Four sets of flexible cables, spaced at 120° intervals, are used to stabilize a 400-ft…

A: Draw the free body diagram of the section containing point A: The axial force transmitted through…

Q: B: A 30 m long vessel with cross section shown in Fig.4 is to carry a load of 6006 kN. If the free…

Q: A 1,400-N uniform boom at o = 58.5° to the horizontal is supported by a cable at an angle 0 = 31.5°…

A: Given Data: The weight of the bloom is w1 = 1400 N The weight of the object is w2 = 1850 N The…

Q: Ecample The figure shows a laterally loaded beam which is supported by two rollers and in…

A: From the given information,

Q: M 1 m Figure 4 In the space truss shown in Figure 4, member BC, CD and DB form an equilateral…

A: A position vector for a line representing with two end points can be obtained by subtracting the…

Q: A crane boom which weighs 200 lbs and which is 10 feet long is supported so that it makes an angle…

A: Write down the given values using suitable variables. Here Wc signifies crane boom, l signifies…

Q: A 150 kg box is supported by a beam Z and cable K as shown in the figure below. Determine the forces…

A: Given data: Mass of the box, m = 150 kg. Draw the free-body diagram of the system, Apply Lami's…

Q: The picture below shows a flagpole (9.1 kg) attached to the side of building. The base of the pole…

Q: Fig 3 5m 3m 3m 5000 N 5000 N Q3: As Engineer, you have been asked to calculate only the forces in…

A: Solution: To calculate support reactions at A and H, Consider the truss in static equilibrium,then…

Q: 3. A block with a mass of 160-kg is supported EDI by a cable which passes over a 150-mm diameter…

Q: A traffic light of mass 5 kg hangs from two lightweight cables, one on each side of the light. Each…

Q: b) Each member of the truss is a uniform 20 m long bar weighing 400 kg. Calculate the a average…

A: Given: The mass of each member, m = 400 kg The length of each member, L = 20 m

Q: A uniform beam of length 20 m and mass 100 kg is supported by pylons on cither end. A 200-kg box is…

Q: A uniform ladder, 4.8 m long and weighing 220 N, rests against a smooth vertical wall. By taking…

Question

A uniform, 8.0-m, 1,150-kg beam is hinged
to a wall and supported by a thin cable
attached
2.0 m from the free end of the beam. The
beam is supported at an angle of 30.0
above the horizontal. Draw a free-body
diagram of the beam. Calculate the tension
of the cable? (Non-anonymous questionO)
4-

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The figure shows a three-pin arch. Determine the horizontal component of the pin reaction at A caused by the applied force P.
The simplest truss consists of two rods and is loaded by the block. Given: block weight Q = 9,4 kN. Angle α = 31 degrees. Find: the algebraic (positive or negative) value (in kN) of normal force N1 in the rod 1, considering that N1>0 for tension and N1<0 for compression.
A 10-m uniform beam of weight 100 N is supported by two ropes at its ends. If a 400-N person sits at the center of the beam, what is the tension in the right rope?
A uniform, 7.5-m-long beam weighing 6490 N is hinged to a wall and supported by a thin cable attached 1.5 m from the free end of the beam. The cable runs between the beam and the wall and makes a 40° angle with the beam. What is the tension in the cable when the beam is at an angle of 30° above the horizontal?
Find the support reacions and joint force of the construction shown on the figure, if; P=12 kN q=9 kN/m M=12 kN and L=2 m
The simplest truss consists of two rods and is loaded by the force F. Given: F = 5,1 kN. Angle α = 69 degrees. Find: the algebraic (positive or negative) value (in kN) of normal force N1 in the rod 1, considering that N1>0 for tension and N1<0 for compression.
4.3 A steel cylinder having a mass of 120 kg is supported by two inclined planes, as shown. Sketch the free-body diagram for the cylinder.
Consider the force P applied at point A on the plate of the figure shown (image 1). Assuming that the weight of the plate is negligible, and that the horizontal force F, as well as the reactions Dy and Dx in the joint D balance the plate shown in the figure. Note: the x-axis is horizontal and the y-axis is vertical and both have their origin at point D. Data: P = 332N Which option is right? a) if the plate had a weight of 332N (applied vertically downwards in the center of the plate), the reaction Dy on the plate should be vertical downwards so that the plate still remained in balance in that position or b) if the plate had a weight of 332N (applied vertically downwards in the center of the plate), the reaction Dy on the plate should be vertical downwards so that the plate still remained in balance in that position
Two smooth spheres of weight W and radius r each are in equilibrium in a horizontal channel of A and B vertical sides as shown in the figure. Find the force exerted by each sphere on the other. Calculate these values, if r=250mm, b=900mm and W=100N.
A crate with dimensions l = 0.50 m and h = 0.75 m rests on a plane that is inclined by θ = 30◦ from thehorizontal. The crate is in equilibrium, but if the crate were too tall, it will fall over down the slope.Find the effective point of application of the normal force on the crate, i.e., where is the normal force actingon the crate, keeping the crate in equilibrium? Hint: choose the crate’s center of mass as the axis of rotation.
Two weights are connectedby a very light, flexible cord that passesover an 80.0 N frictionless pulley of radius0.300 m. The pulley is a solid uniformdisk and is supported by a hookconnected to the ceiling (Fig.).What force does the ceiling exert on thehook?
Draw the free-body diagram of the smooth uniform bar shown in Fig. 2. The bar has a mass of 20 kg.