a) Using a catalyst b) [D] is decreased c) Volume is increased

Q: Determine what would happen if saturated liquid feed is replaced with a subcooled liquid feed and…

A: When feed is subcooled  When a subcooled feed at feed tray then vapor coming from bottom condense at…

Q: Problem 3 What would be the terminal velocity of a commercial adsorbent bead, if dropped into a…

A: Given Data  The density of amyl acetate (ρ) = 876 Kgm3The viscosity from the X and Y coordinates are…

Q: Example Design a rapid Sand filter units ter treating (9+i6) elday as daily demand, assumed rate of…

A: Here by designing the rapid sand filter it means we have to calculate the area of sand filter. The…

Q: 4. A bilayer polymer slab (1.2m long, 1.4m wide, 5 cm thick) is placed on a hot plate, which keeps…

A: Given data: Dimension of bilayer polymer slab = 1.2 long, 1.4 m wide, 5 cm thick Temperature of slab…

Q: 6) Problem 4.7-6 (Page 350): Natural Convection Heat Loss in Double Window. 4.7-6. Natural…

A: Given that T1 =25 CT2 =10 Ch=2 mw=1.2 m Ra

Q: Q3.Define the substitutional solid solution types with diagram.

A: Substitutional solid solution: It is a solution when the atom of solute is substituted in place of a…

Q: We are planning to operate a batch reactor to convert A into R. this is a liquid phase reaction, the…

A:

Q: A sample of Al203 with an available surface area of 871 m2 is suspended in 148 mL of 0.01 M KNO3.…

A: Initial surface area=871 m2 Moles of KNO3=1.48 x 10-3moles KOH required later=1.473 x 10-3moles…

Q: Example 3.5: A liquid mixture of benzene-toluene is to be distilled in a fractionating tower at…

A: A mixture of benzene-toluene is to be separated in a fractionating tower.

Q: 13. An orifice meter is used to measure the rate of flow of a fluid in pipes. The flow rateis…

A:

Q: Pathway: Production of glutamic acid from sugarcane molasses by Corynebacterium glutamicum Chemical…

A: Given in question, the Production of glutamic acid from sugarcane molasses by Corynebacterium…

Q: A +B the equilibrium conversion is 0.8 at 127°C and 0.5 at 227°C. What is the heat of reaction?

A:

Q: 4. Calculate the heat loss per linear foot from a 10.3 in. nominal pipe (outside diameter=10.75 in.)…

A: Given that  pipe diameter inner = din = 10.3 in pipe diameter outer = do = 10.75 in insulation 1…

Q: When a tertiary alcohol reacts with HBr, what is the best description of the major product; and also…

A:

Q: 7-43 Refrigerant-134a at 240 kPa and 20°C undergoes an isothermal process in a closed system until…

A:

Q: Calculate the AS (system) for the reversible heating of 1.0 mol of ethane from 300 K to 1800 K at…

A:

Q: 1. An insoluble crystalline solid wet with water is placed in a rectangular pan 0.7 m by 0.7 m and…

A: Given data: Dimension of pan = 0.7 m × 0.7 m Thickness of pan = 0.8 mm Temperature of air = 65 0C…

Q: When liquid–liquid extraction is used, are other separation operations needed? Why?

A:

Q: What is the equivalent value of T= 50°C in degrees Fahrenheit, Rankine, and Kelvin?

A:

Q: A rigid vessel, filled to one-half its volume with liquid nitrogen at its normal boiling point, is…

A:

Q: These data are given: w = 250 lb/min; density = 62.5 lb/ft3;V1 = 4 ft3:V2 = 5 ft3,V3 = 6 ft3; Cp = 1…

A: A transfer function is also known as a network function or system function. These functions are…

Q: 10. The freezing range for a Bi-20% Sb alloy is about 650 630.6 °C 600 550 Liquid 500 450 400 350…

A: Given Figure-Phase diagram Find Freezing range For Bi-20% Sb alloy

Q: 1. Consider two cases involving parallel flow of dry air at V = 1 m/s, T = atmospheric pressure over…

A: Given data: V=1 ms T∞=45 °C Ts=20 °C Rexc=5x 105 Ratio of thermal and hydrodynamic boundary layer…

Q: A gas storage tank initially contains 40 wt.% i-butane, 40 wt.% n-butane, and the rest is propylene.…

A: We are given the following information: Total moles = 100 moles of gases weight percent of diffrent…

Q: 2. A 0.72 g sample of polyvinyl chłoride (PVC) is dissolved in 250.0 mL of a suitable solvent at…

A: Given Data Mass of polyvinyl chloride (PVC) (m)= 0.72 gThe amount of solvent used to dissolve PVC…

Q: A gas storage tank initially contains 40 wt.% i-butane, 40 wt.% n-butane, and the rest is propylene.…

A: Given that  i-butane = 40 wt%  n-butane = 40 wt% propylene = 20 wt% the required n-butane = 50 mol%…

Q: Consider two isothermal processes: liquid vapor Heat evaporates all the liquid feed. Q1 liquid vapor…

A:

Q: Qyt asecondorder Polynominal tothe data x1213 319| 21415 3/91 4/75-6/24

A: Given, Second order polynomial

Q: The vapor pressures of the pure liquids A and B are 58.013 and 53.075 kPa respectively at 330.774 K.…

A:

Q: given in table below. Calculate the kg moles per hour distillate, kg moles per hour bottoms, and the…

A:

Q: We use a steel cylinder with a cross-sectional area of 0.0290 m² and containing 1.24 x 10¬2m³ of…

A: (a) Write the expression for coefficient of volume expansion as follows: β = ∆VV∆T      ......1…

Q: The following information are provided Sulfur dioxide, Temperature = 600 K and pressure is 300 bar.…

A: Note:  we are supposed to answer only three subparts of a question. please send the other questions…

Q: What chemical processes in which optimization can be applied?

A: Optimization in a chemical process refers to either maximizing or minimizing the output variable of…

Q: a. Write a reaction table. b. Show the assumption. c. Calculate concentration of each substance at…

A:

Q: Calculate the number of vacancies per cubic meter in iron at 855 °C The energy for vacancy formation…

A: Given  Temperature = 855 oC                         = 1128.15 K Density = 7.65 g/cm3 Atomic weight =…

Q: think a molecule with VSEPR label ABXe is Why do you linear while one with the label Ab2X2 is bent?…

A:

Q: What are the external environmental weakness/threats to yeti holdings inc?

A: YETI Holdings Inc can use the SWOT matrix to exploit the opportunities and minimise the threats by…

Q: give sample problem with a solution regarding the interchange of radiations between two parallel…

A:

Q: A 20 cm-diameter copper sphere (k = 386 W/m°C, a = 11.234 ×10-5 m 2 /s, p = 8.954 g/cm3 cp = 383…

A:

Q: Tert-butyl chloride has a normal boiling temperature of 350 K. The vapor presuure at 298K is 101…

A:

Q: What is the condition of water at 300°C and 15 MPa pressure? 50 40 (400°C 30 supercritical 20- 10+…

A:

Q: Two liters of a liquid mixture that is 50 mol% pentane and 50 mol% heptane is injected into an…

A:

Q: valuate the enthalpy change, in kJ, as 4 mole of methanol go from vapour at 264°C to liquid at the…

A:

Q: Lead shot may be manufactured by dropping molten-lead droplets into water. Assum- ing that the…

A: Given that h = 5000wm2 Cd = 1.5 mm = 1.5 x 10-3 m

Q: What is the correct equilibrium constant expression for the following reaction? H2(g) + I,(s)=…

A:

Q: A continuous fractionating column, operating at atmospheric pressure, is to be designed to separate…

A:

Q: 2.15 The van der Waals equation of state is given as (V - b) = RT where a and b are known as the van…

A:

Q: 5. m long, 2 cm ID, 2.75 OD, thermal conductivity of 4.7 W/mK). The pipe is directly under an HVAC…

A:

Q: 15. A tensile specimen has an elastic modulus of 50 GPa. If the length of the specimen before being…

A:

Q: Find the Laplace Transform of g(t) = e + cos(6t) - e cosát S+3 (A) G(s) s- 3 s2+ 36 (s+ 3) ²+ 36 6 B…

A: