A water jet leaves a nozzle at a speed of 60 m/s and a flow rate of 120 kg/s. It is used to generate power by striking the buckets located in the perimeter of a wheel. The work generated by this water jet if all the kinetic energy of the water is converted to work equal to . Shaft Nozzle

Q: Question 12 A certain electrochemical reaction requires the use of an external power source. What ot...

A: As the electrochemical reaction requires external power so the reaction is non spontaneous and for n...

Q: Show all working and steps please.

A: CO + 2 H2 ----> CH3OH Feed rate : 100 mole/h Recycle rate: 500 mol/h CO = 32% H2 = 64 % N2 = 4% A...

Q: Solve the following questions: 1- Convert the following pressure. a. 5 m H2O to mm Hg gauge. b...

A: HERE, as per BARTLEBY guideline, as you not specified which question to be solved, I have to answer ...

Q: Q2: A spherical vessel of 0.9 m³ capacity contains steam at 8 bar and 0.9 dryness fraction as shown ...

A: Given, Capacity of the spherical vessel,V=0.9 m3 Presssure of the steam, p1=8 bar Dryness fraction o...

Q: I only want number 2 answered. The question is based on number one

A:

Q: A chemist titrates 140.0 mL of a 0.1752 M ethylamine (C,H NH, solution with 0.1969 M HBr solution at...

A: Given that: Volume of  base, ethylamine (C2H5NH2) = 140 mL, concentration = 0.1752 M Concentration o...

Q: Discuss the relationship between drying and quality.

A: In this question relationship between drying and quality is to be discussed.

Q: 3 solve The following Lim メキ

A: The following limit function is to be solved.

Q: 1. Calculate how much energy (kJ) is required to heat a liter of water from 30°C to saturated liquid...

A: Given data: Volume of water, Vwater=1 L=1000 ml Initial temperature of water, Ti=30°C=30+273=303 K C...

Q: Discuss the uses and economics and also manufacturing process of Acetylene

A: The uses, economics, and manufacturing process of acetylene is to be mentioned.

Q: If the thermal efficiency of a Carnot heat engine working between two temperature reservoirs is 0.33...

A: Thermal efficiency of a Carnot heat engine = 0.33 COP of a Carnot heat pump working between the same...

Q: CaCO3 precipitate is made by reacting CaO with an aqueous solution ofNa2CO3, the by-product being Na...

A: The given process can be shown as

Q: Mangrove bank containing 48% tannin and 13.5% water soluble non-tannin material, on a dry basis, is ...

A:

Q: Convert a pressure of 800 mm Hg to the following units: a. psia b. kPa c. atm d. ft H2O

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: Please help me

A: Given that: Ground water sample volume= 244 mL It is contaminated with tin(V) chloride which is [SnC...

Q: Oxygen at a pressure of 2 atm and 27◦C blows across a 50-cm-square plate at a velocity of 30 m/s. Th...

A:

Q: 100 g of F gas is stored in a cylinder in equilibrium with an external pressure of 1 atm and tempera...

A: Given: Mass of the gas, m = 100 g Pressure, P = 1 atm = 101325 Pa Temperature, T = 305 K Exothermic ...

Q: Entering in confined space can prove fatal for an employee when the oxygen level is _________ a. Be...

A:   Answer is b. b.oxygen level is below 19.5 per Entering in confined space can prove fatal for an em...

Q: Q2: A spherical vessel of 0.9 m³ capacity contains steam at 8 bar and 0.9 dryness fraction as shown ...

A: Hello. Since your question has multiple parts, we will solve the first question for you. If you want...

Q: q2

A:

Q: Give answer all questions with explanation

A: This question is based on the rate of arrival of X+ ions at the cathode. 5 options are given.  

Q: List three methods by which the octane number of gasoline can be improved.State one advantage and on...

A: Asked To list three methods by which the octane number of gasoline can be improved and their one adv...

Q: What is the important of the research paper of shell and tube heat exchanger and how can be use this...

A: In heat transfer, a heat exchanger is a machine used to transfer heat between two or more fluids. Th...

Q: Sulfur dioxide, So,(g), can react with oxygen to produce sulfur trioxide, SO, (g), by the reaction 2...

A: The heat of formation is the difference between the heat of reaction of products and the heat of rea...

Q: On a standard extruder screw, there are three sections – what are they called?

A: The three sections of the standard extruder screw are to be mentioned.

Q: A semi-permeable, immovable membrane separates two compartments of equal volumes V . Initially NA mo...

A: The process can be shown as Given  The membrane is impermeable to gas B but permeable to  gas A( mo...

Q: PLEASE ONLY DO D,E, F and G A sample of 3 mol of Argon is put through the following cycle :        a...

A: Note: Since we are entitled to answer only 3 subparts, we’ll answer the first three of the mentioned...

Q: (a) Figure Q2.1 illustrates the Process Flow Diagram (PFD) to produce ethane from ethanol. Throughou...

A: Block Flow Diagram of the process is asked. And explanation of group of valves used is to be provide...

Q: This is all part of the same question.

A: Note: Since we are entitled to answer only 3 subparts, we’ll answer the first three. Please resubmit...

Q: Determine the vapor pressure, specific internal energy and specific enthalpy of saturated steam at 1...

A: 1. Given: T = 133.5 °C

Q: Compute the heat transfer through the air condition if the outside temperature is outside temperatur...

A: Given, The outside temperature, T0 = 5 °C The inside temperature, Ti = 20 °C length of the room, l =...

Q: The feed to a compressor is superheated steam at 300°C and 20 bar abso- lute pressure. It enters the...

A:

Q: determine the heat of evaporation of a certain compound, given the below graph 6.5 6. 5.5 5 4.5 4. 0...

A: A plot between ln P vs 1/T To Calculate the heat of evaporation using the given plot.

Q: A student wishes to determine the chloride ion concentration in a water sample at 25 °C using a galv...

A:

Q: How does pressure and crystallinity affect density of a material?

A: Density of material : Density of any material represent the amount of mass of material available in ...

Q: How does pressure and crystallinity affect density of a material?

A: Pressure is defined as the force acting per unit area. Pressure = forcearea   The density of the mat...

Q: 7-Combustion of 0.2121 grams of an organic substance sample with oxygen gasCO2 is kept in barium hyd...

A:

Q: fluid mechanics 1 plz answer this question thaaaank you

A: The velocity of a fluid from a hole in a container increases as the height of the liquid increases f...

Q: 4-The average speed of an ideal gas molecule at 27°C is 0.3 m/s. The average speed at 927°C will be ...

A: The average speed of the ideal gas at the given temperature is to be calculated.

Q: Chemical Engineering Question

A: 1) Given:Acetone from a waste gas is to be removed using an oil;Consider the below figure for the gi...

Q: Assuming that the 1-octen fits the viral state equation, calculate its fugacity at 450 K and 15 bar.

A: Given the following data: • Temperature (T) = 450 Kelvins • Pressure (P) = 15 bar = 15×10⁵ Pascals. ...

Q: part a)

A:

Q: 2- Determine the properties of propane in gaseous state with the help of generalized compressibility...

A: Given data: The properties of propane (temperature, pressure, and specific volume) are given.

Q: 2) At 20 centigrade degree, half-life is 22.5 hour and in 40 centigrade degree, half-life is 1.5 hou...

A:

Q: The reaction of carbon monoxide(g) with water(l) to form carbon dioxide(g) and hydrogen(g) proceeds ...

A: Here, 10.2 gm of CO react with H2O. CO(g) + H2O(l)  ---> CO2(g) + H2(g)

Q: Locking out the circuit breaker prevents the accident switching of electricity. Select one: True Fal...

A:   Answer is True Locking out the circuit breaker prevents the accident switching of electricity is a...

Q: he vapor pressure of liquid ethanol, C,H&OH, is 100. mm Hg at 308 K. A 0.153 g sample of liquid C,H,...

A: Vapor pressure of liquid ethanol is,PV=100 mm Hg=(100×0.00131579) atm=0.131579 atm at temperature, T...

Q: A stream of 7,000 kmol/h of water and 3,000 parts per million (ppm) by weight of ammonia at 350 K an...

A: We know that Ammonia tends to highly soluble in water. If we show temperature effect than its solubi...

Q: Consider the decomposition of calcium carbonate: AH° - 177.8 kJ/mol CACO3(s) = CaO(s) + CO28) AS" = ...

A:  Decomposition reaction of Calcium Carbonate: ∆H=177.8kJ/mol=177800J/mol ∆S=160.5J/K.mol To Calculat...

Q: Butane (C4H10) is fed to a furnace and combusted with excess air. The stack gas leaving the furnace ...

A: