A wedge splits a sheet of 20°C water, as shown in the figure. Both wedge and sheet are very long into the paper. The thickness (D) of the sheet is 3.5 cm. If the force required to hold the wedge stationary is F=124 N per meter of depth into the paper, what is the angle 8 of the wedge? 6 m/s D 6 m/s F 6 m/s

A wedge splits a sheet of 20°C water, as shown in the figure. Both wedge and sheet are very long into the paper. The thickness (D) of the sheet is 3.5 cm. If the force required to hold the wedge stationary is F=124 N per meter of depth into the paper, what is the angle 8 of the wedge? 6 m/s D 6 m/s F 6 m/s

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter10: Force And Force-related Variables In Engineering

Section: Chapter Questions

Problem 28P

See similar textbooks

Similar questions

The block shown in Figure M01 is acted upon by its weight W = 400 lb, a horizontal force F = 600 lb and the force P exerted by the inclined plane. The resultant R of these forces is parallel to the incline. Determine P and R. Does the block move up or down the incline?
A horizontal force P acts on the top of the 30 N block having a width of 25 cm and a height of 50 cm. If the coefficient of friction between the block and the plane is 0.33. a. What is the value of P for motion to impend? b. Is the motion will impend due to overturning?
The cylinder in the figure below, having a mass of 100 kg is to besupported by the cord that wraps over the pipe. Determine the largest vertical force F that can be applied to the cord without moving the cylinder. The cord passes two times over the pipe (take β = 540° and μS = 0.3).
After the block in figure 5 has moved 6 m from rest, the constant force P is removed. Find the velocity of the block when it returns to it's original position. The coefficient of kinetic friction is 0.30.
A 500 N block is resting on an inclined plane and is subjected to a constant force of 600N acting parallel to the inclined plane. After the block has moved 3 m from rest along the inclined plane the force 600N is removed. The inclined plane has a slope of three vertical to four horizontal. Coefficient of friction is 0.20 a. Which is the following gives the distance that the black will move further along the inclined plane until it will stop? b. Which of the following gives the velocity of the block when this for 600 Newton was removed? c. Which of the following gives the velocity of the block when it returns to its initial position?
The helicopter flying in Figure 4 with a constant velocity of 180 km/h and is directly above point A when a loose part begins to fall. The part lands 6.5 seconds later at point B on an inclined surface. 16. The vertical motion component of the falling part is A. uniform motion B. non-uniformly accelerated C. uniformly accelerated D. stationary
A horizontal force P acts on the top of the 30N block having a width of 25 cm and a height of 50 cm. If the coefficient of friction between the block and the plane is 0.33. What is the value of P for motion to impend?
A ball of mass 5kg and a block of 12 kg are attached by a light weight cord that passes over a frictionless pulley of negligible mass as shown in the figure. The block lies on a frictionless incline of angle 30 degrees. Find the magnitude of the acceleration of the two objects and the tension in the cord. Take g = 9.81 m/s^2.
A tennis player strikes the tennis ball with her racket while the ball is still rising. The ball speed before impact with the racket is v1 = 15 m/s and after impact its speed is v2 = 20 m/s, with directions as shown in the figure. If the 60-g ball is in contact with the racket for 0.047 s, determine the magnitude of the average force R exerted by the racket on the ball. Find the angle β made by R with the horizontal. Comment on the treatment of the ball weight during impact.
A rock is thrown under a bridge at an initial speed of 10 m s − 1 and an angle of 36.9 degrees from the vertical, as shown. At the same time, a boat is passing under the bridge traveling 6 m s − 1 in the direction shown. See the note on the formula sheet about the values of trigonometric functions for this angle. a) Find the vertical and horizontal components of the initial speed of the rock seen by a person on the bridge. Clearly indicate your choice of axes in your drawing. b) Find the vertical and horizontal components of the initial speed of the rock seen by the person in the boat. Clearly indicate your choice of axes in your drawing. c) Draw a clear vector diagram showing how to relate the speed with which the rock appears to be moving when viewed from the bridge, the speed with which the rock appears to be moving as seen by the person on the boat and the speed of the boat with respect to the bridge.
A 4-ft-diameter log (sg. = 0.82) divides two shallow water as shown in the figure. Compute the vertical reaction at point C, if the log is 12 ft long. CHOICES A.) 658.68 B.) 568.88 C.) 856.86 D.) 865.65
A tank in figure C is accelerated to the right and the width of the tank is 1 m. Determine the acceleration needed to cause the free surface to touch point A. What is the pressure at point B? Determine the equivalent hydrostatic force acting on the wall of the tank at the side of point B.