A well of 0.4 m diameter fully penetrates a 25-m-thick confined aquifer of coefficient of permeability of 12 m/day. The well is located in the center of a circular island of radius 1km. The water level at the boundary of the island is 80 m. At what rate should the well be pumped so that the water level in the well remains 60 m above the bottom?

A well of 0.4 m diameter fully penetrates a 25-m-thick confined aquifer of coefficient of permeability of 12 m/day. The well is located in the center of a circular island of radius 1km. The water level at the boundary of the island is 80 m. At what rate should the well be pumped so that the water level in the well remains 60 m above the bottom?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 300-mm diameter test well penetrates 27m below the static water table. Water is pumped at the rate of 69 liters per second for 24 hours. The water levels at two observation wells 35m and 95 m from the well were lowered by 1.10m and 0.50m, respectively. Which of the following most nearly gives the transmissivity of the aquifer?
A 45-cm well penetrates an unconfined aquifer of saturated thickness 30 m completely. Under a steady pumping rate for a long time the drawdowns at two observation wells 15 and 30 m from the well are 5.0 and 4.2 m respectively. If the permeability of the aquifer is 20 m/day, determine the discharge and the drawdown at the pumping well. Ans. 2556 lpm; 10.54 m
A confined aquifer has a thickness of 85 ft. An 86-in diameter well drilled to the bottom of the aquifer, as shown in fig 3-10, if the hydraulic conductivity of the aquifer is 10 ft / day, and if water is originally 170 ft deep in the well, calculate approximately the maximum rate of flow that can be pumped from the well without dewatering any part of the aquifer. Assume 1000 ft reasonable value for the radius of influence. What will be the average velocity ( Darcy velocity ) of flow in the aquifer at a distance 20 ft from the center of the well?
An unconfined aquifer is known to be 32 m thick below the water table. A constant discharge of 2 cubic meters per minute is pumped out of the aquifer through a tube well till the water level in the tube well becomes steady. Two observation wells at distances of 15 m and 70 m from the tube well show falls of 3 m and 0.7 m respectively from their static water levels. Find the permeability of the aquifer (mm/s).
A confined aquifer has thickness of 33km and 7km wide. Two observation wells are located 1.2km apart in the direction flow. The head in well one is 97.5m and well two is 89m. i) What is the total daily flow through the aquifer? (Hydraulic conductivity of the aquifer is 1.2m/day) ii) What is the elevation of the potentiometric surface at a point located 0.3 from well one and 0.9 from well two?
An unconfined aquifer is known to be 32 m thick below the water table. A constant discharge of 2 cubic metres per minute is pumped out of the aquifer through a tubewell till the water level in the tubewell becomes steady. Two observation wells at distances of 15 m and 70 m from the tubewell show falls of 3 m and 0.7 m respectively from their static water levels. Find the permeability in mm/s of the aquifer. a.3.28 x 10^-1 b.4.68 x 10^-1 c.2.58 x 10^-1 d.1.18 x 10^-1
In fig 3-5, the aquifer thickness is 10 ft, the hydraulic conductivity of the aquifer is 0.06 m/day, and the river water surface is 7m above the bottom of the aquifer. If it is necessary to maintain a water level in the trench not more than 10 m deep, at what rate must water be pumped out of a 100 m long trench? The distance between the edge of the trench and the river is 300 m. Assume all water comes from the river.
A fully penetrating well with diameter of 0.25 m is bored into an unconfined aquifer with hydraulic conductivity of 22 m/d and porosity of 0.3. The water table is initially at a height of 55 m above the bottom of the aquifer. After continuous pumping, a steady state drawdown of 12 m is reached. (a) If the pumping rate has no effect on the water table at a distance of 1.2 km from the pumping well, determine the pumping rate. Determine the drawdown in an observation well 600 m away from the pumping well. Determine the travel time from the observation well to the pumping well.
Consider a confined aquifer with a thickness of 12 m and hydraulic conductivity of 20 m/day. This aquifer is fully penetrated by a pumping well having a radius of 0.4 m and is operating at a discharge of 550 m3/day. Calculate the drawdown under steady-state condition in the pumping well and at a point located 41 m away from the well. Assume the radius of influence of the pumping is 310 m.
At a well the ground elevation is 1510.0 (m asl), the depth to the water is 5.0 (m) and the lithology is 0-10 m sand; 10-12 m grey clay. What is the hydraulic head in m asl and the hydraulic gradient?
b) A 30-cm well fully penetrates an unconfined aquifer of saturated depth 25 m. When a discharge of 2100 lpm was being pumped for a long time, observation wells at radial distances of 30 m and 90 m indicated drawdown of 5 and 4 m respectively. Estimate the coefficient of permeability and transmissibility of the aquifer. What is the drawdown at the pumping well?
A 1-m diameter well penetrates vertically through a confined aquifer 30m thick. When the well is pumped at 113 m^3/hr, the drawdown in a well 15m away is 1.8m, in another well 50m away, it is 0.50m. What is the approximate drawdown in the pumped well?