a. 100 cm3 saturated sample of quartz sand is weighed, gravity drained, weighed, oven dried, and weighed again. The saturated, gravity-drained, and oven-dried weights are 130g, 110 g, and 105 g, respectively. Using these data, calculate the following quantities. i. Dry bulk density ii. Porosity iii. Degree of saturation after gravity drainage iv. Specific yield

a. 100 cm3 saturated sample of quartz sand is weighed, gravity drained, weighed, oven dried, and weighed again. The saturated, gravity-drained, and oven-dried weights are 130g, 110 g, and 105 g, respectively. Using these data, calculate the following quantities. i. Dry bulk density ii. Porosity iii. Degree of saturation after gravity drainage iv. Specific yield

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter5: Soil Compaction

Section: Chapter Questions

Problem 5.7P

See similar textbooks

Similar questions

with figures if necessary 1. A wet sand sample has a volume of 4.64 x 10-4 m3 and weighs 8 N. After oven-drying, the weight reduces to 7.5 N. Calculate the water content, void ratio, and degree of saturation. 2. The mass of a wet sample of soil and its container is 0.33 kg. The dry mass of the soil and its container is 0.29 kg. The mass of the container is 0.06 kg and its volume is 0.15 x 10-3 m3. Determine the bulk, dry and saturated unit weights of the soil. Determine the void ratio and degree of saturation. Determine the amount of air void in the soil and the water of water required to saturate 1 m3 of the soil. 3. A sand has a natural water content of 5% and bulk unit weight of 18.0 kN/m3. The void ratios corresponding to the densest and loosest state of this soil are 0.51 and 0.87. Find the relative density and degree of saturation.
1. A sample of saturated clay was placed in a container and weighed. The weight was 6 N. The clay withcontainer was oven dried for 24 hours at 105C and weighed again as 5N. if the weight of the containeris 1 N, and specific gravity of soil solids is 2.70, determine the a) water content b) void ratio c) bulk unitweight d) dry unit weight, e) saturated unit weight f) submerged unit weight. This is the question of Soil Mechanics.
100 cm3 saturated sample of quartz sand is weighed, gravity drained, weighed, oven dried, and weighed again. The saturated, gravity-drained, and oven-dried weights are 130g, 110 g, and 105 g, respectively. Given that the soil sample above has porosity of 35%. i. Determine the void ratio of this soil. ii. If 50% of the void space is filled with water, with the remaining 50% filled with air, determine the volumetric water content, θ. iii. and the degree of saturation, S.
The porosity of a silty sand soil sample is found to be 0.309. Its initial weight is 274.471 grams, and after oven drying for 24 hours, it reduces to 244.321 grams. If the density of the soil solids is 2581 kg/m3, determine the following:Bulk unit weight, Volume of voids, Volume of water to be added/evaporated per cubic meter of soil to attain 50% degree of saturation
1: A sample of soil is obtained from a test pit is one cubic foot ( 1ft³) and weighs 140 lb. The entire sample is dried in an oven and found to weigh 125 lb. Calculate the following: C. Dry Unit Weight (pcf)
1: A sample of soil is obtained from a test pit is one cubic foot ( 1ft³) and weighs 140 lb. The entire sample is dried in an oven and found to weigh 125 lb. Calculate the following: A. water content(%) B. Moist Unit Weight (pcf) C. Dry Unit Weight (pcf)
The saturated clay sample was weighed in a container and the total weight was 7.4 N. 24 hours 105 degreesAfter waiting in the oven, the container was weighed again, this time it was measured as 5.6 N. The weight of the container is given as 0.7 N. Given the specific gravity of 2.66 for the soil, a) water content b) void ratio c) porosity d) density and e)Calculate the unit weight.
01- The weight of a sample of saturated soil before drying is 2.8 lb and after drying is 2.1 lb. If the specific gravity of the soil particles is 2.6, determine: (a) moisture content, (b) void ratio, (c) porosity, (d) bulk density, and (e) dry density.
A sample of saturated clay was placed in a container and weighed. The weight was 6N. The clay in its container was placed in an oven for 24 hours at 105˚C. The weight reduced to a constant value of 5N. The weight of the container is 1N. If Gs = 2.7, determine: a) Water Content b) Void Ratio c) Bulk Unit Weight d) Dry Unit Weight e) Effective Unit Weight
Refer to the soil in Problem 4.5. Using the Casagrande plasticity chart, graphically estimate the shrinkage limit of the soil as shown in Figure 4.22. 4.5 The following data were obtained by conducting liquid limit and plastic limit tests on a soil collected from the site. Liquid limit tests: Plastic limit test: PL = 19.3% a. Draw the flow curve and determine the liquid limit. b. Using the Casagrande plasticity chart (Figure 4.21), determine the soil type.
An oven dry sand mass with a dry unit weight of 105pcf and Gs of 2.70 is placed outdoors in a container. Overnight, it rains. As it rains, the total volume of the soil specimen within the container remains the same, yet the S increases to 55% by the time the rain is over for the night. a. Determine the new total unit weight of the soil after the rain in units of pcf. Express your answer in four significant figures. Show full phase diagram.