a. b. C. d. 7jw eX() 3 e7jw et X (74) 3 7jw 3X() -X(w) e p7jw 3

Q: SW DETERMINE (a) fosc (6) B (c) Av (d) Rf THE FOLLOWING let C = C₁ = C₂ R = R₁ = R₁₂ = R3 C3 = 2 C

A: According to the question, for the given RC phase shift oscillator as shown below We need to…

Q: Solve the Discrete-Time Fourier transform solution just enlun the nenhlem.) b) x[n]-un-11

A: x(n)=(0.5)n u[n-1]

Q: Find the voltage drop Vr(t) across the resistor when w=we. Suppose that UR (t) = AR cos(wt + o),…

A: For the given band reject filter circuit the value of the voltage at various values of the angular…

Q: I did not understand the answer not accurate please solve it again

A: “Since you have posted a question with multiple sub parts,we will provide the solution only to the…

Q: (c) Sketch a buffer circuit using an op-amp and explain its purpose/operation. (d) Using inverting…

A:

Q: onvert the following signals from the domain shown on the left to that shown on the right. Show all…

A:

Q: The cost of a single phase overhead transmission line is Rs (25000 a + 1500) per km where 'a' is the…

A: We have an 3-phase overhead line which has, Cost of transmission line = 25000 a + 2500 Rs/km a =…

Q: A three-phase, 60-Hz induction motor runs at 890 r/min at no load and at 840 r/min at full load.…

A:

Q: For R1=5000 2, R2=8000, R3-9000, R4-8000 , C1=0.008 F, C2=0.002 F & I1=0.002 A in the shown circuit,…

A:

Q: Problem 4.4: A 200-hp, three-phase, 60-Hz, six-pole, 1150-rpm, 0.90-pf induction motor operates with…

A: It is given that: Actual speed =11502=575 rpm Rated speed =1150 rpm cos θ =0.9 VLL line =480 V

Q: An electric plant that produces 11 x 10⁹ kWh/year has an annual investment expenditure of $44.5 x…

A: An electric plant that produces 11 x 109 kWh/year has an annual investment expenditure of $44.5 x…

Q: Given the matrices: a. Represent the system by signal flow graph and indicate the variables in it.…

A: In this question we need to draw a SFG and block diagram of the given state space Matrix

Q: Which of the followings is the current on the resistor R₂ as a function of time 1₂(t) after the…

A:

Q: 4- Let Q1 = 8 μC be located at P₁ (2, 5, 8) while Q2 = -5 μC is at P2(6, 15, 8). Let € = 0. a) Find…

A: Given data Q1=8 μC, P12, 5, 8 Q2=-5 μC, P26, 15, 8 To Find out We have to determine the force on Q2…

Q: 3.) A 400/100V transformer has an effective primary resistance of 0.3Ω and a secondary resistance of…

A: In this question we need to find the primary current at maximum efficiency.

Q: Which of the followings is the current on the resistor R₂ as a function of time 1₂(t) after the…

A: The current through the resistor R2 needs to be calculated in terms of current I2(t).

Q: Q3) The Voltage-divider bias circuit shown below is to be designed operate Efficiently stabilized.…

A: For the given voltage divider bias circuit the value of the bias resistor needs to be calculated.…

Q: V DC separately excited motor has ure resistance 2 ohms and voltage constant V /rad/s. The field…

A: Given data Supply voltage, V=100 V Armature resistance, ra=2 Ω Voltage constant, Kb=0.6 Torque…

Q: We have a 3Phase, 4poles, 60 Hz induction machine. In this machine R = Rp. If we ignore the losses…

A: Given data 3 Phase, 4 Poles, 60 Hz Rs=Rr' Slip, S=0.1 To find out We have to determine the…

Q: 1. Given the measurement value of VD in Figure 1, determine: 14 V a. lp b. VDS C. VGS d. VGG 1 ΜΩ…

A: Given Data: A  JFET circuit having Drain Resistance RD=1.6 kΩ Drain Input voltage VDD=14 V Drain…

Q: Explain if the each of the circuits/functions below are low pass, high pass, band pass, notch (band…

A:

Q: 2-(XXXXX) (YY) (YY)

A:

Q: 8- Find E at the origin if the following charge distributions are present in free space: point…

A:

Q: The impulse response of a system is h(t) tu(t). For an input u(t-1), the output is = A B с D t² 2…

A: We need to find out output for given input and impulse response .

Q: A ten-turn solenoid has a ferromagnetic core with a relative permeability of 10,000. The length of…

A: Given Data: No. of turns, N =10 Relative permeability of the core, μr=10000 Length of the solenoid,…

Q: Two parallel wires conduct the same amount of current and in the same direction. The wires are L…

A: According to question We need to calculate magnetic field at point P which is the middle point of…

Q: Find the Thevenin equivalent circuit with respect to the terminals a,b of the circuit shown in…

A: In the given circuit, we need the find thevenin's voltage and thevenin's equivalent impedance.

Q: Assume that the input voltage Vin varies in a sinusoidal fashion as a function of time. In other…

A: Need to identify the correct input and output waveform for the given circuit. Based on the working…

Q: V DC separately excited motor has ure resistance 2 ohms and voltage constant V /rad/s. The field…

A: V = 100 V Ra = 2 ohm Kb= 0.6 V/rad/s T= 20 Nm Kt = 50 Nm/s

Q: LOGIC EXPRESSION ( NEED NEAT EXPLANATION HANDWRITTEN SOLUTION PLEASE OTHERWISE DOWNVOTE)

A: Given: A logic circuit diagram,  To find: Boolean function F in terms of Minterms.    Note: We will…

Q: cuicuit designed in winknown subuenit, va resistance R = 2.8K2 and two identical silicon BTTS T₁ and…

A:

Q: 4) A binary On-Off ASK communication system is using the below s1(t) and s2(t) signals to transmit…

A:

Q: 8. Answer the following questions about this circuit. C-0.039µF, Vin-IV, R-3.9 k2 R www 39 ΚΩ Q039…

A: Given Data: An RC circuit with, Input voltage Vin=1 V Output voltage =Vout To Find: Phase shift…

Q: The circuit shown is supplied from a 240 V, 3-phase, a-b-c system. Answer a Your Answer: b Answer C…

A:

Q: Q2/ Design an FIR Linear Phase. For Band-Stop Filter having the ideal -Yesponse Hol (W) = O…

A: Given: Frequency response of linear phase FIR band stop digital filter,…

Q: 1. Solve for Ix in the circuit using superposition. 10 Ω Ix Μ 30 V 10 Ω 5Ω Μ 592 |- 12 Α

A:

Q: Knowing that the voice signal has no noticeable spectral content from -300 Hz to approximately 300…

A: Given data Cutoff frequency = 3 db Max Frequency = 300 Hz Min Frequency = -300 Hz Voice Signal = 1.5…

Q: 4.17 Using the ideal op-amp assumptions, determine 1, 12, and I in Fig. P4.17. 1 mA www R₁ Figure…

A: An ideal op-amp is a linear, high-gain amplifier with infinite input impedance, zero output…

Q: Q1/ What is bit is the output voltage for digital-to-analog Convertor Consider Rf = 1k (1101) 5V-…

A:

Q: Q4) A total of 40 MHz of bandwidth is allocated to a particular FDD cellular telephone system that…

A: Given data Bandwidth, B1=40 MHz FDD cellular telephone system bandwidth, B2=111.111 kHz Erlangs of…

Q: a) What is the largest voltage that you can apply to a 1kΩ resistor that can dissipate up to 0.25 W?…

A: In part a, we need to find the maximum voltage that can be applied across a resistor for the given…

Q: A capacitor of 2 mF has a voltage of 525cos(201). The energy stored in it at t = 850 ms is: O a.…

A: Capacitance C=2 mF. Voltage V=525cos20t V. Time t=850 ms =0.850 sec.

Q: Consider two discrete-time LTI systems with impulse responses hi[n] h₂[n] = = (n + 4)u[n+3]u[-n − 1]…

A:

Q: The transfer function of a system is The corner frequencies will be 10(1+0.2s) (1+0.5s)

A: Transfer function of a system:G(s)=10(1+0.2s)(1+0.5s)

Q: №g + SIO 5 Va - Then calc. power, P=VI

A: Here we have to find the voltage Vg and power P.

Q: Question # 2: One circuit of a single-phase transmission line is composed of three solid 0.5 cm…

A: The arrangement of conductors can be redrawn as, Inductance | phase | m L=2×10-7 lnDmDs H/m So, the…

Q: Q3. This question is on op-amps. (a) Comment on the differences between the values in the two…

A: The gain of the ideal operational amplifier and the input resistance for the practical operational…

Q: given points A(8,-5, 4) and B(-2, 3, 2), find: a) the distance from A to B. |BA| = |(-10, 8, -2)] =…

A: Note: As per Bartleby guidelines we are supposed to provide solution of one question and first 3…

Q: Obtain the Thevenin impedance for the circuit shown at terminals a-b.

A: For the given circuit the total impedance of the circuit at the open terminal need to be calculated.

Q: #Z) FIND Vc in the network VA/2 LV (I +VA -2K_2 V.

A: We need to find out the output voltage for given circuit.

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.