A. Discuss the importance of power electronics interfaces in microgrid installations B. With the aid of diagram describe DC microgrid C. With the aid of diagram describe AC microgrid

Q: For the circuit shown below, solve for Z₁ that draws the maximum average power and what is that…

A:

Q: TUTORIAL 2: Unbalanced A-connected load A balanced abc-sequence source Vab= 10020° V. Is connected…

A: Given: A balanced abc-sequence source Vab= 100∠0° V is connected to a delta-connected unbalanced…

Q: What is the total current (in sine wave equation form) if i1 = 9 sinθ and i2 = 12 cosθ

A:

Q: Find the equivalent winding resistance, reactance and impedance

A:

Q: 04/ For the network in Fig.4 1. Write the equations necessary to solve for the branch currents. 2.…

A: Mesh analysis is the method to finding a current in a circuit. This method used in network theory.…

Q: Choose the correct answer.

A: given a 1.5 hp motor has input current of 10A at a voltage of 120 V. Here we have to find the…

Q: (A) Evaluate the Transfer Function (T.F), using block diagram reduction method.

A: The required transfer function can be obtained by considering the parallel and series connected…

Q: An AM transmitter radiates 9 kW of power when the carrier is unmodulated an (10.125 kW when the…

A: We need to find out the modulation index and total power transmitted

Q: A copper coil, when connected to a 30-volt supply, initially takes a current of 3 A and has a mean…

A: In this question we need to find a temperature coefficient of resistance at 0oC. Let resistance at…

Q: Find i for t> 0 if i(0) = 2A and v(0) = 6V. 5Ω 1000 mH 26 cos 3t V =/F +1 + >.

A: The given circuit diagram is shown below: It is given that: i0=2 Av0=6 V

Q: 1.Three number of single phase ideal transformers, each of rating. 10kVA, 200V / 100V,50Hz is…

A: Line and phase voltage in delta connected system remain same  Line voltage is 1.732 times more than…

Q: Find VTH, ZTH, and IN for the circuit shown below for R = 2 ohms. 3 Ω j4 Ω 10/40° V 6 Ω 1) 2/20° A…

A: For the above given question by calculating open circuit voltage across the given terminal we need…

Q: A single phase transformer on open circuit condition gave the following test results: Applied…

A: From the question, it is given that  Applied voltage Frequency Power drawn 192 V 40 Hz…

Q: O Final Task #2 63 61 ба AGG + 64 65

A: Block diagram reduction:

Q: 1? *13. Using superpositio, find the current through each resistor for the networks of Fig. 8.105.…

A:

Q: 03. A) Design a multi range d.c. mille ammeter using a basic movement with an internal resistance Rm…

A: muilty range ammeter design by connecting shunt across the ameter of low value its shunt value is…

Q: b) Find the bandwidth of a signal that can be decomposed into four sine waves with frequencies at 0…

A: For the above given signals we need to calculate its bandwidth by plotting frequency spectrum. By…

Q: Calculate the value of C for the circuit to be in resonance. C 702 3 cos 21 V (+ 3Ω Ո 3H

A: In parallel circuits find the admittance of the network  The imaginary part of the admittance should…

Q: Multiple Choice Questions (MCQ): (15 M 1. For a horn antenna, in which flaring is done only in one…

A: Given  Few multiple choice questions based on antenna theory. Please find the below attachment for…

Q: Use superposition to find the phasor current, I, for the circuit below.

A: It is given that using the superposition theorem current I need to find out:

Q: An automobile battery supplies a current of 10A to the starter. It has a resistance of 1.25 Q. What…

A: Given: For an automobile battery I=10 AR=1.25 Ω

Q: 8- Inter pole winding is connected in a) series with armature c)parallel with armature 9- What are…

A: Given about interpole winding and rotating parts of a dc machine.

Q: 41. What is the potential difference from point b to point d in the circuit shown? Which is at high…

A: We need to find out the potential difference between given point

Q: What is the impedance of purely inductive circuit at a frequency value approaching to zero?

A:

Q: = 9.83 Example 8.11(b). A 4-pole lap-connected armature of a d.c. shunt generator is required to…

A:

Q: What distance should a 2N load placed from the pivot so that the see saw won't move? 0.3 m ? m 3N O…

A: We need to find out distance for 2N force .

Q: 10.23. Draw the block diagrams of both the direct forms I and II simulation diagrams for the systems…

A:

Q: Solve for RC. 12 V Select one or more: a. 500 ohms Ob. 1050 ohms c. none d 2200 ohms 2 mA Re 07.6V…

A: Given circuit:

Q: A SUBSTATION RATED 1250 KVA IS OPERATING AT FULL LOAD AT 0.8 PF LAGGING AND TO CARRY AN ADDITIONAL…

A: The substation is an electrical substation is a subsidiary station of energy technology,…

Q: Study the following circuit carefully. 6V o 20.3k Ovo What does the circuit do? Explain how the…

A: Given a circuit with a transistor and a buzzor connected to it. A variable resistor of 20.3k ohm is…

Q: The Excess -3 code of 6 is O a. 0110 Ob. 0111 C. None of the above Od. 1001

A: We need to find out excess 3 code of given digit

Q: 8- If field resistance of a d.c. shunt generator is increased beyond its critical value, the…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: QI what are the ideal characteristics of op-AMP. for the op-AMP circuit shown prove that the voltage…

A: Given  We need to list out ideal opamp characteristics. And for the given opamp circuit we need to…

Q: An AM signal is represented by x(t) = (20+4sin500t) cos(2?X105t) V. Solve the modulation index.

A: For the given amplitude modulated signal we need to calculate the value of modulation index.…

Q: Example 6 The EMF and current waves of a circuit having resistance only are e=170sin2 / 60t and…

A: We are authorized to answer only three subparts at a time since you have not mentioned which part…

Q: The displacement of an object is measured using a linear potentiometer with resistance Rp = 1.8 k as…

A: The given circuit is shown below. Given information about The circuit is, Rp=1.8 kΩ. L=250 mm.…

Q: ANSWER IT. ABC D

A: Given a logic circuit and we need to implement it with the nand gates.

Q: O Final Task #2 63 61 ба 466 + 64 65

A:

Q: Example 05:- For the filter circuit shown, sketch the frequency response and determine the cutoff…

A:

Q: 0. Modern transistors have now reached the limits in small sizes. We can now fit a maximum of about…

A: As per Bartleby policy we can answer only three questions at a time. I am answering first three for…

Q: Q2: Given the following system: Y(n) = y(n-1) - Y(n-2) + X(n) G 1) Determine the response of the…

A:

Q: In a half wave rectifier, If the output frequency is 2kHz then the input frequency is? Group of…

A: We have, For half-wave rectification,the output frequency equals the input frequency. For full-wave…

Q: What is the expression of the complex power of the reliant current source? 103 16.52 2014 2020°V 6Vx…

A:

Q: Q6) Find the skin depth & and propagation constant at a frequrnvy of 2MHz in copper where o =…

A: 6) To find the skin depth and propagation constant  Given , frequency = 2 MHz in copper

Q: You are working on a single-stage amplifier that has a 200-kHz bandwidth and a voltage gain of 87 at…

A: Amplifier is a device it is used to amplify the amplitude of input current and voltage. The example…

Q: An inductor having a resistance of 25 ohms and a Qo of 10 at a fr=10kHz is fed from 100/0° supply.…

A: In this question we will find series capacitance required for resonance , q factor , inductance of…

Q: 1. A type of electrical signal that has two states? 2. Write True or False about the following…

A: SCADA is  the software for controlling the industrial process. SCADA software is the central control…

Q: Find v, for the circuit below. 5 0 10 sin (5000) 30°) V + 40 μF 80 2 sin (8000 + 10°) A

A: In this question,  We need to determine the voltage v as shown the circuit using the super position…

Q: An automobile battery supplies a current of 10A to the starter. It has a resistance of 1.25 Q. What…

A: Answer: 12.5V Explanation   a. It is not a valid option. The value of current should be 100A to…

Q: Question4: A) Determine the z-transform for ( 1. x(n) = 6(0.6)" cos (0.2лn)u(n) 2. x(n) = 4e-3n…

A:

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.