A. Name the following refrigerants: 1. Dichlorotetrafluoromethane (CCIF;CCIF:) 2. Octafluoropropane (CF:CF:CFs) 3. Trifluoromethane (CHF;) 4. Trichlorofluoromethane (CCI,F) 5. Pentafluoroethane (CHF;CF)

A. Name the following refrigerants: 1. Dichlorotetrafluoromethane (CCIF;CCIF:) 2. Octafluoropropane (CF:CF:CFs) 3. Trifluoromethane (CHF;) 4. Trichlorofluoromethane (CCI,F) 5. Pentafluoroethane (CHF;CF)

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter9: Refrigerant And Oil Chemistry And Management-recovery, Recycling,

Section: Chapter Questions

Problem 17RQ: What is the name of the conference that was held in Canada in 1987 to attempt to solve the problem...

See similar textbooks

Related questions

Q: Give your opinion on whether the following statement is correct or incorrect, and give an explanatio...

Q: For the lightweight truss which is loaded as shown 10 kN 5 kN 6 m -6 m 4 m D E -6 m 3m 3 m Determine...

A: By observing the figure , it is given that no.of members = 7

Q: A В L

A: given; AB=Lweight density=qlets take reaction force at A=RA

Q: Question J. fv x(t) オ Derive the equation of motion- ewe

A: For solution refer below images.

Q: Determine the mass of air at a pressure of 215kPa and a temperature of 31°C in a 132-gallon containe...

A: Given: P = 215 kPa T = 31°C V = 132-gallons

Q: The particle P starts from rest at point A at time t = 0 and changes its speed thereafter at a const...

Q: 1. Determine the tension forces developed in the wires CA AND CB required for equilibrium of the 10-...

Q: Given the bended rod as shown below. Determine the following: a.) The x-component of Reaction A. b.)...

A: GIVEN DATA- A LOADED BAR GIVEN WE HAVE TO FIND REACTION FORCES

Q: Please draw shear force diagram v(X) and bending moment diagram m(X)

Q: A two stage cascade refrigeration system uses R-11 as the working substance. The evaporator is at -3...

A: Given dataTwo stage cascade refrigeration system with R-11 as working substanceEvaporator Temperatur...

Q: A cannonball is launched vertically upwards at 50 m/s then it returns to the ground after some time ...

A: Given: u = 50 m/s a =9.81 m/s2

Q: Q12. As shown in the image below, ball A and ball B are approaching each other, and they have a mass...

Q: bulk modulus of elasticity of oil ?

A: Given: Oil in hydraulic cylinder is compressed from an volume: V1=2 m3 V2=1.94 m3Pressure in oil ...

Q: Determine the constant speed of the passengers on the amusement-park ride if it is observed that the...

Q: Figure (1) shows a linkage that operates rock crushing mechanism. a= 9.32 in, b= 12.27 in, c= 3.0 in...

A: Below is the kinematic diagram for the rock crusherThere are 6 links which are numbered on that kine...

Q: PROBLEM 3: Determine the tension in each of the three ropes supporting the crate. 2 ft 4 ft 4 ft B y...

Q: , a reasonable pressure drop between the evaporator and absorber is 1.5 psi Consider a large NH3/H2O...

A: Special: A maintenance refrigeration structure (ARS) is a choice to the customary mechanical tension...

Q: Problem 3.22 Steel tube with the cross section shown carries a 50 kip – in. torque. Determine (a) th...

Q: One kg of water of 0°C is brought into contact with a heat reservoir at 95° C. When the water has re...

A: We have, Mass of water, m=1 kg, T1=0oC=273 K Temperature of heat reservoir, T2=95oC=368 K

Q: 2 m -1m 2 m This is not your onwproperty so do itn any www 1.5 m KAC 1.5 s In the assembly shown, sa...

A: At the point when a mass is hung upward from a spring, the spring extends. The power on the mass bec...

Q: QUESTION 2 Calculate the length of the resistor of a circular wire used in a heater element connecte...

A: GivenV=240VQ=8Jt=0.25d=0.00016in1in=25.4mmρ=2.825×10-6Ωcm=2.825×10-5Ωmmnowd=0.00016×25.4=4.064×10-3m...

Q: force developed on the plate?

A: Given: Velocity,v=41 m/sflat plate moving away from it at ,u=31 m/scross-sectional area of jet,A=0.0...

Q: A cantilevered bar in the figure is acted up on by a system of forces Fx =75 lb, Fy 200 lb, and Fz =...

A: according to the given details

Q: A man exerts a force Fon the handle of the stationary wheelbarrow at A. The weight of the wheelbarro...

Q: an engine burns a liter of fuel each 12 minytes, the fuel has specific gravity os 0.8 and heating va...

Q: A beam segment subjected to internal bending moments at sections A and B is shown along with a sketc...

Q: Q8:- A Hook's joint is used to connect two shafts whose axes are inclined at 20°. The driving shaft ...

A: Answer: (a) The extreme angular velocities of the driven shaft: ◆ Maximum velocity = 66.86426 rad/se...

Q: 1. A cylinder of Radius 30 cm is rolling along the surface with constant speed of 60 cm/sec a. What ...

A: Answer: (a) The rotational speed of the cylinder about its axis is 2 rad/sec. (b) The magnitude of t...

Q: PROBLEM 1: Determine the mass of the heaviest uniform bar that can be supported in the position show...

Q: The crane BC shown below lifts a load of W. Neglecting the weight of the crane. Determine the follo...

Q: For the gear train shown, the diameters of the three solid shafts are: dAB = 20 mm, dco = 25 mm, dgf...

Q: 5) If water with a mass of 348 g with an initial temperature of 42° will be frozen in the refrigerat...

Q: Question 31 of 46 Determine the magnitude Pof the vertical force required to lift the wheelbarrow fr...

Q: at 35°C and 0.1 MPa in air-standard Otto cycles with a compression ratio of 7. The cycle reaches a m...

A: v1v2=r=7T3=Tmax=1100°C=1373kT1=35°C=308KP1=0.1Mpa=100 kpa

Q: A motor is attached to a pulley of radius 10 cm and mass 1 kg. A belt passes through the pulley that...

A: It is asked to find the energy consumption of motor and motor torque

Q: A horizontal flow field has the following velocity components: u = (y? - x²) m/s v3 (2xy) m/s a) The...

Q: 2) Reqd: Determine e of A relative to D G = 12 x 10° psi MN Ib t U-41 0001 1000 lb ft 900 lb ft er 2...

Q: A Pelton wheel turbine is to operate under a head of 25 m at 200 r.p.m. If the discharge is 9 m /s a...

A: Given Data: H=25 m, N=200 rpm, Q=9 m3/s, η=90 %=0.9

Q: One kg of water of 0°C is brought into contact with a heat reservoir at 95° C. When the water has re...

A: Given Data m=1 kg To=0°C TH=95°C

Q: Find the maximum compression of the spring.

A: Find the maximum compression of the spring.

Q: A particle travels along the parabolic path y = bx² . If its component of velocity along the y axis ...

Q: you are given the mass, damping, and spring constants of an undriven spring-mass system my'' + μy + ...

A: Given data, Equation of spring mass system is my"+μy'+ky=0

Q: Determine the constant speed of the passengers on the amusement-park ride if it is observed that the...

Q: a. Where will the ball be 1.2 seconds after it is kicked? b. What will be the greatest height reache...

A: Given- Initial velocity- 35m/s Angle- 25deg

Q: The beam in the figure below is made from three boards nailed together as shown, If the internal sec...

Q: 150 lb/ft A B 6 ft – -8 ft

Q: A horizontal flow field has the following velocity components: u = (y2 – x2) m/s = (2xy) m/s a) The ...

A: Velocity equations: u= (y2 - x2) m/s v= (2xy) m/s Pressure at point A (3m, 2m), P1= 600 kPa Pressure...

Q: A gage pressure of 52.3 kPa is read on a gage. Find the absolute pressure if the elevation is: (a) A...

A: Given:Gage pressure, Pg=52.3 kPa

Q: a gas occupies 1.5 m3 at 102 kPa, what pressure is require to reduce the volume of the gas by 2.5% u...

Q: 3. The specific gravity of a certain alcohol is 0.8. Calculate its specific weight and mass density ...

Question

100%

Please answer it Asap and completely for an upvote. Thank you.

A. Name the following refrigerants:
1. Dichlorotetrafluoromethane (CCIF;CCIF:)
2. Octafluoropropane (CF:CF:CFs)
3. Trifluoromethane (CHF;)
4. Trichlorofluoromethane (CCIF)
5. Pentafluoroethane (CHF,CF,)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What causes fractionation in certain refrigerant blends?
Are federal excise taxes on reclaimed refrigerants the same as those for new refrigerants?
Define a near-azeotropic refrigerant blend, and give two examples.
What is the main difference between a zeotropic and an azeotropic refrigerant blend?
Why is information regarding the specific volume of gases important to the designer of air-conditioning, heating, and refrigeration equipment?
Excluding lines, which of the following components are required to make simple hydrolic system?  A) Reservoir, pump, filter & regulator. B) Reservoir, ACOV, pressure relief valve & actuator. C) Reservoir, pump, selector valve & actuator.
What causes the sublimation of ice in a freeze dryer system?
Carbon dioxide (R-744) is unlikely to be used as a refrigerant because of its _______. A) high GWP B) high flammability C) high working pressure D) difficulty to manufacture
ANSWER THERMOFLUIDS QUESTIONS
What refrigerant blend can be used in retrofit applications as a long-term replacement for R-22 in residential and light-commercial air-conditioning applications?
What is the name of the conference that was held in Canada in 1987 to attempt to solve the problem of refrigerants released into the atmosphere?
When condenser tubes become fouled, they may be cleaned by A. using a steel brush. B. using a brass brush. C. using a chisel and hammer. D. running a mixture of sand and water through them.