A. State two methods that can be used to access the Internet:1-2-B. Name the acronym for the following:1- OSI:2- WAN:3- IP:C. State the data unit for each layer for the TCP/IP model:1- Application layer:2- Transport layer:3. Network layer:4- Data link layer:5- Physical layer:

As per guidelines, we can solve only one question at a time. Hence resubmit the question for further…

Answered: A. State two methods that ca 1- 2- B.…

Engineering

Computer Science

A. State two methods that ca 1- 2- B. Name the acronym for the 1- OS: 2- WAN: 3- IP:

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: Fill in the blank. Refers to the below figure, if PC1 want to send packet to PC2. Write the best…

Q: How many possible ports are allowed in TCP? a. 8 b. 16 c. 65,536 d.…

A: TCP (Transmission Control Protocol) is a network communication protocol that is used to create a…

Q: If a subscriber needs to connect 255 computers, then class ______ IP addressing is the best option…

A: Ip. Addressing is a technique used to connect hosts in network. There are 5 class category i.e class…

Q: Do we need both DNS addressing schemes? Why are there two?

A: DNS: DNS stands for Domain Name System. This is the system that provides the ability to the users…

Q: Is it feasible for a single Media Access Control (MAC) address to be used by more than one network…

A: Media access control: Is it possible for two different network interfaces to have the same MAC…

Q: For IP network to be transmitted over Ethernet , they have to be?

A: The IP address must be converted into an address that is appropriate for the physical network over…

Q: 3. How many bytes are in Ethernet address?

A: A node is a point representing a variable or signal. A branch is directed line segment joining two…

Q: comparison or distinction between IoS and OSI There's also the question of TCP vs. IP to consider.

A: Introduction: The following is the difference between ISO and OSI: The International Organization…

Q: four sentences, describe Pure Aloha in Multiple Access Pro

A: Pure Aloha in Multiple Access Protocols

Q: 802.11 MAC protocol is based on CSMA/CD. O True O False

A: CSMA/CD (Carrier Sense Multiple Access/Collision Detection) is a media access control strategy that…

Q: How many useful addresses does a Class C network have? Group of answer options 254 256 255 253

A: "Class C" IPv4 addresses are used for small-sized networks.First three octets of a "Class C" network…

Q: Write the advantages of optical fibre over twisted and coaxial cables.write about various classes of…

A: The fiber-optic cable provides an attractive alternative for the wire transmission lines namely…

Q: 4- What is the organization responsible for standardization of UTP cats.

A: Unshielded Twisted Pair (UTP) cable it is most certainly by far the most popular cable around the…

Q: o and wait protocol x 103 bps, round trig the packet size i

Q: Computer Science INFO SEC QUESTION: How can I scan all the services running on a machine connected…

A: answer is

Q: Subnet 192.168.0.0/20 to meet the following network requirements: VLAN1 needs 200 hosts VLAN2 needs…

A: 192.168.0.0/20 11000000 10101000 00000000 00000000 /20 means number of network bits is 20. Therefor…

Q: (i) What is the purpose of Address Resolution Protocol (ARP)? (ii) What are the type of addresses in…

A: Purpose of the Address Resolution Protocol?What do the Address Resolution Protocol and the Reverse…

Q: 16.a. How far can workstations be separated in an FDDI network? A. 100 km B. 50 km C. 15 km D. 2 km…

A: 16 .a) FDDI supports a variety of fiber optic cable types, including the 62.5/125 micron…

Q: What are some of the features of 802.11ac and 802.11n?

A: Features of both 802.11ac and 802.11n

Q: 168. A modem is connected in between a telephone line and a a. network b. computer c. serial port d.…

A: A modem, is an equipment gadget that changes over information from an advanced organization,…

Q: Assume a computer has two network interface cards, NIC1, a Wifi USB, and NIC2, an on-board Ethernet.…

A: The network interface card (NIC) enables computers to interact across a computer network via wired…

Q: Why does the company want to connect the PCs of its employees to a network? List the various network…

A: Topology refers to the network's structure and how all of the components are linked to one another.…

Q: Assume a computer contains two network interface cards, NIC1 and NIC2. NIC1 is a Wifi USB card, and…

A: INtro The network interface card (NIC) enables computers to interact across a computer network via…

Q: What sets circuit-switched networks different from their counterparts, known as packet-switched…

A: Please check the step 2 for solution.

Q: QUESTION 4 The Ethernet protocol is classified as which category? O none of these O a turn-taking…

A: 4.The ethernet protocol is classified as which category

Q: Q3/ Answer either A or B A) state the differences between the following: - 1- Connection-oriented…

A: Difference between Connection-oriented and Connection-less Services: S.NO Connection-oriented…

Q: e the four abstractions layers of TCP/ I

A: the four abstraction layers of tcp /ip : link layerThe link layer is the networking scope of the…

Q: Abbreviation of UTP in networking is_____________.

A: UTP abbreviation in networking.

Q: resses; III - It can use both optical fiber and twisted pair as a physical medium; IV - This is a…

A: Analyze the characteristics and identify the communication protocol: I - It can be used both for…

Q: Why does the company want to link the PCs of its employees to a network? List the many computer…

A: Introduction: Topology refers to the network's structure and how all of the components are linked to…

Q: a. Explain the controlled access protocol in detail. b. Describe in detail about channelization.…

A: Controlled Access Protocol:- In controlled access, both departments check each other's information…

Q: A.5. Match the following to one or more layers of the OSI model: a. Providing host-to-host…

A: MATCH THE LAYERS. a. Providing host-to-host addressing. - Application Layer & Transport Layer.…

Q: The bus, ring and star topologies are mostly used in the LAN explain?

A: Given that, The bus, ring and star topologies are mostly used in the "LAN".

Q: 265. How many communication channels are needed for serial transmission? a. 1 channel b. n channels…

A: 1 communication channel is needed for serial transmission.

Q: Describe the technologies that were employed to create a WAN.

A: Introduction: WANs used to be based on circuit-switched telephone lines and modems, but today there…

Q: 1.Switched Ethernet networks primarily use _____. a. broadcasting b.…

A: The Switched Ethernet network , the switch is connected to the all station in LAN. When the port of…

Q: Do research on the following protocols: Can Bus protocol SPI I2C USB and draw the transmission…

Q: b) Explain, with the aid of a diagram, how a switch builds a MAC Address Table. d) Describe two…

A: 1. How switch builds a MAC address table 2. Two types of frame forwarding methods used by layer 2…

Q: ESTION 7 How many signal levels are needed to achieve a theoretical data rate of 32Mbps if the…

A: Nyquist formula: The Nyquist formula describes the link between data transmission rate, bandwidth,…

Q: (c)Discuss the following as they relate to IP networks . (i)Network Address Translation (ii)Datagram…

A: Given: (c)Discuss the following as they relate to IP networks .(i)Network Address…

Q: How many bits are there in the Ethernet address?

A: b. 48 bits yes, there are 48 bits in the Ethernet address.

Q: Write the procedures of active and passive scanning in IEEE 802.11

A: According to the Bartelby Guidelines we are allowed to answer one question at a time. So kindly…

Q: an IP-based storage networking technology developed by the IEEE. Its mechanisms enable the…

A: Lets see the solution.

Q: Is the EZ serial switch, like a router, equipped with a user configurable interface?

A: Intro EX Switches are a kind of switch. Cloud-ready and high-performance access and…

Concept explainers

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.

Question

A. State two methods that can be used to access the Internet:
1-
2-
B. Name the acronym for the following:
1- OSI:
2- WAN:
3- IP:
C. State the data unit for each layer for the TCP/IP model:
1- Application layer:
2- Transport layer:
3. Network layer:
4- Data link layer:
5- Physical layer:

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

3.4a) Choose one network architecture (e.g., client-server, peer-to-peer) and explain its characteristics, advantages, and disadvantages. b) Define the OSI (Open Systems Interconnection) model and describe its seven layers. c) Compare and contrast the OSI model with the TCP/IP model. Highlight their similarities and differences.
a) Why are standards important for protocols? b) Dial-up modems, HFC, DSL and FTTH are all used for residential access. For each of these access technologies, provide a range of transmission rates and comment on whether the transmission rate is shared or dedicated.
8. List and discuss the advantages of IP over 10-Gbps Ethernet compared to IP over ATM.
(b) The Open Systems Interconnection (OSI) Protocol Model describes seven protocol layers: Application, Presentation, Session, Transport, Network, Data Link, and Physical. Describe briefly what are the responsibilities of the Network layer. Give an example of Network layer protocol and explain its main characteristics. (c) Suppose that web server A sends a hypertext document to a web browser in machine B. Describe briefly what happens at each protocol layer. What does encapsulation mean in the context of network protocols? (d) Two well-known protocols at the Transport layer are the Transmission Control Protocol (TCP), and the User Datagram Protocol (UDP). Explain their key features and differences.
a)How OSI layers play their role in the communication between two computers. Discuss. Correctly identify the layers for the items mentioned below. Switch, Router, Hub, TCP, Browser, IP Address, Frame, UTP cable?
1, Build a peer-to-peer network using a private IP address and its procedure 2. Identify common issues in building peer-to-peer networks.
I What exactly is meant by the term "Network Address Translation"? (NAT).ii) If the network layer is necessary, why is it necessary?i ii) Identify four advantages of IPv6 over IPv4.
need proper explaination of All part please length explaination of all parts ' networking q1 (a) Why Frame Relay was originally designed for use across Integrated Services Digital Network (ISDN) interfaces? (b) A connectionless protocol, such as Ethernet, defines the route of a packet through source and destination addresses. However, a connection-oriented protocol, such as ATM, defines the route of a cell through virtual connection identifiers (VPIs and VCIs). Could you explain this statement? (c) Transferring files from one system to another seems simple and straightforward, some problems must be dealt with first. For example, two systems may use different file name conventions. Two systems may have different ways to represent text and data. Two systems may have different directory structures. How to solve these issues in case of transferring of files from one system to another.
1. State at least three reasons why messages are broken into packets fortransmission through a network.2. Discuss the trade-offs between circuit switching, packet switching, and virtual circuit switching.3. Draw a six-node full mesh network. How many connections did your drawing require? How many connections would a fifty-node full mesh network require?
Let's imagine your youngster accesses the internet using the school's wireless Network and puts in www.google.com (Or any other website you can think of). List the various routing protocols in the precise sequence that they should be used to avoid any misunderstanding.
(a)What is difference between physical and logical topology?(b)Compare UTP and STP cable.
Discuss the role of network protocols, such as TCP/IP and UDP, in device communication over a network. How do they ensure reliable data transmission?