A

Q: 1) For register AH • Set bits b0, b3 • Invert bits b1, b6, b7 • Reset bit b2, don't affect other bit...

A: As per Bartleby guidelines we are allowed to solve only three subparts,please ask the rest again.

Q: lII/ find the limit of the following: 1- limx' cos - 2- lim v+ sin

A:

Q: 2. An alternating current varying sinusoidally with a frequency of 50 Hz has an rms value of40 A. Fi...

A: From the given dataTo find the instantaneous value?To find Time?RMS value of alternating current is ...

Q: Q2/ Prove that P, E - E, = kT In Pi fp

A: The hole concentration in a p type semiconductor is given by :-  NA = NVe-(EF-EV)KTNANV = e-(EF-EV)K...

Q: QI: For the logical cireuit shown below: (A): Draw the flow chart to perform the function (O/P) of t...

A: Given  circuit:

Q: 1. Write a program includes the functions to find the maximum and minimum number of four

A: #include <stdio.h> int main( void ){ int a, b, c, d;    int largest, smallest;     printf( "En...

Q: For the admittance locus diagram shown below: find the value of each element in the ?circuit if w=37...

A: Admittance Locus Diagram:

Q: Practice Problem In the circuit shown, calculate the nodal voltages ,V & V, 2A V V2 ww Va ww 20 2 10...

A: The solution is as follows. The answer given with the question is incorrect.

Q: What will be the voltage drop across a 10 mH inductor when 5sin (20t) A current flows through it?

A: Given: Inductance, L=10 mH Current through inductor, iL=5sin20t A

Q: 10) Two wattmeters connected to measure the input to a balanced three-phase circuit indicate 2500 W ...

A:

Q: Which of the following type of insulation can be installed underground?

A:

Q: 7-6. A three-phase, 60-Hz, four-pole induction motor runs at a no-load speed of 1790 r/min and a ful...

A: The solution is as follows.

Q: 500 internal resistance and full-scale current of 1 ma. Show the way of connection with

A: Since you have asked multiple questions. We will solve the first question for you. If you want any s...

Q: Find the three currents (I1, I2, and I3) through the circuit shown below.  I1 runs through R1 & ...

A: Mesh analysis 

Q: A unity feedback system is characterized by the open-loop transfer function 6.6 (s+1) 1- G(s) s(1+3s...

A: A dynamic system's response to an input expressed as a function of time is known as the time respons...

Q: Q4) A particular control system yielded a steady state error of 0.20 for unit step input. A unit int...

A:

Q: Q3. Perform the following:a. (6767)10 + (3592)10 using BCDb. Discuss floating point numbers by takin...

A: A. 6767 and 3592 using BCD addition: BCD code for 6767 : 0110 0111 0110 0111 BCD code for 3592 ...

Q: For the admittance locus diagram shown below: find the value of each element in the circuit if w=377...

A: Admittance Locus diagram:   

Q: Determine v1, v2, and the power dissipated in all the resistors in the circuit of the below figure. ...

A:

Q: What is the charge of an electron?

A: Electron- It is a subatomic particle. It is denoted by the symbol e-. It was discovered by J.J. Thom...

Q: Answer the following questions related to a series/parallel combinational circuit configured as foll...

A: The solution can be achieved as follows.

Q: When the switch is opened at t=0, obtain the 1K ohm resistor voltage for t > 0 in the circuit shown ...

A:

Q: A 10kn resistor is made of two strips connected in parallel, each one has 40µm thick, and 6mm long, ...

A: The given data's are, Resistor is 10 kΩ, Length of the first strip l1=6 mm, Length of the second st...

Q: After how many time constants, the transient part reaches more than 63 percent ?of its final value

A: The time constant is the multiple of time that is required to reach the response up to the specific ...

Q: Find currents and voltages in the circuit below? 3 42 5 V 82 3 V ww

A: Nodal analysis

Q: The open-loop gain of an amplifier is A 350. and the feedback factor is 8 = 0.7. (a) Determine the c...

A: a)  Af=S0Si     =A1+Aβ     = 3501+350×0.7     =3501+245     =1.4226

Q: Consider the circuit shown in the Figure. The three resistors are identical with R1 = R2 = R3= 200 Ω...

A:

Q: The mathematical relation between impedance and admittance locus are Opposite O Inversely O Mirrored...

A: Relation between the impedance and admittance locus?  Admittance Y= 1/Z Z impedance  

Q: What is value of current (I).

A: Given circuit is -  

Q: Choice the correct answer

A:

Q: When the switch is opened at t=0, obtain the 1K ohm resistor voltage for t> O in the circuit shown i...

A:

Q: A non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos3000t-0.5sin4000t) A is ?applied to the circu...

A:

Q: how many protons have a combined charge of 5.4 pC (picoCoulombs)?

A: Given data: Total charge Q=5.4 pC=5.4×10-12 C

Q: With a neat diagram ,explain about the working of 4 bit R-2R ladder Type DAC.

A: Working of 4-bit R-2R ladder type DAC DAC stands for Digital to analog converter   

Q: When the switch is opened at t=0, obtain the 1K ohm resistor voltage for t > O in the * circuit show...

A: The switch is open at time t= 0 second, then expression of voltage v across 1k ohm resistance.  Capa...

Q: Consider a single tone signal of frequency 3300 Hz. A PCM is generated with a sampling rate of 8000 ...

A:

Q: 6. What are the features of LEDS over conventional bulbs? Name some applications for LEDS.

A: features of LED over conventional bulbs :-  LED consume less power compared to conventional bulb . ...

Q: The memory structure of a control logic controller is fixed and non flexible. True or False?

A:

Q: Answer the following questions related to a series/parallel combinational circuit configured as foll...

A:

Q: Find the frequency of the waveform

A: We will find the frequency of the given waveform as shown below.

Q: In Fleming's Rule out of three fingers, if two fingers leaving the Thumb in Left Hand rule (Motor) a...

A: Flemming's left Rule  This was invented by John Ambrose Fleming. Whenever the current carrying condu...

Q: 1) For register AH • Set bits b0, b3 • Invert bits bl, b6, b7 • Reset bit b2, don't affect other bit...

A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again. The ...

Q: 9. A central station is supplying energy to a community through two substations. Each substation fee...

A:

Q: 1.3 For the Block Diagram below: G Y,(s) Y(s) G2 G3 G4 H(s) a) Find a symbolic expression for the tr...

A:

Q: This question is about electrical power and I want to answer in 20 minutes

A: The solution can be achieved as follows.

Q: What is Coal? Why it is considered as non-renewable energy source?

A: There are two forms of energy namely renewable and non renewable sources of energy. The sources that...

Q: Q5// The power generation equipment of a power station cost Rs 15,75,000 and has a useful life of 25...

A: Sinking fund method is used to determine the depreciation costGiven DataP = 1575000S = 75000Interese...

Q: What are the applications of a bridge rectifier?

A: The solution can be achieved as follows.

Q: Practice Problem In the circuit shown, calculate the nodal voltages V,V, & V, 2A V1 Va V3 ww 10 2 20...

A: so we have to apply nodal analysis to get the voltages.

Q: Find the transfer function T(s) for the circuit shown in figure below. CAL RAI RB1 Vin o Vo CB1 R1 R...

A: