AC Circuits Find the capacitive reactance of a capacitor of 10µF when it is connected to a circuit having frequency of 50 Hz and 20 kHz

Q: 1. Signed 2's Compliment numbers Convert the following signed 2's compliment values to the decimal…

A: We need to find out decimal equivalent , for given binary number .

Q: 24V (41) Io find Io. 1012 452 Mw 122 ++1: 2422 16V

A: Here we need to find the current I0 in the circuit using superposition theorem.

Q: I A diode is doped with NA= 1018/cm³ on the p-type side and ND = 10¹8/cm³ on the n-type side. (a)…

A:

Q: Calculate the branch currents and the total equivalent current of the complete circuit in Figure Q3.…

A:

Q: Give corect answer please Given that a feedback network is shunt-series, and the output load is…

A: Given, The value output load is RL=10 KΩ The transfer gain of the system is, β=10 The value of…

Q: H KK M

A:

Q: A bathroom exhaust fan is not designed to operate at the voltage of standard household wiring (Vrms…

A: Given that, Normal household supply= 120V (rms) Primary turn (N1 )=100 Secondary turn (N2 )=20 R=8Ω…

Q: 9. Use mesh analysis to obtain is, iz, and is. 10 V 4Ω 12V Ε 6Ω lig 292

A: We need to find out the current for given circuit by using of mesh analysis .

Q: An open loop control system results in -2t a response of € (sin5t+cos5t) for a unit impulse input.…

A: It is given that: xt=e-2tsin5t+cos5t

Q: help please. be sure write this a clear. solve this one don't copy from another work

A:

Q: 2. Given Is = 0.1sin(10t) Amps and Vs = 6cos(10t) Volts in the circuit below, find the Norton…

A:

Q: Please check the right statement(s) 1) The unit of J is A/m² 11) The unit of H is A/m² III) The unit…

A: We need to determine the units of current density (J), magnetic field intensity (H), Electric flux…

Q: In a no load test, an induction motor took 15A and 500watts with a line voltage of 150V.If stator…

A: SOLUTION  GIVEN  Io = 15A W =500W VL = 150V => Vph = VL/√3 = 150/√3…

Q: 1. What type of transistor is BC548? How do you identify its type based on the circuit's diagram?

A: Because the BC548 is an NPN transistor, the collector and emitter are open (reverse-biased) while…

Q: For a certain source-free parallel RLC circuit, R = 1 ks, C = 3 µF, and Lis such that the circuit…

A:

Q: Find the Thevenin equivalent circuit to the LHS of AB of the DC network in Figure Q2. From the…

A:

Q: figure 1. Radio waves from a nearby radio station are the external AC source As- sume Vac(t) = Vo…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Evaluate the following: (a) 5 sin (5t -9°) at t = 0, 0.01, and 0.1 s; (b) 4 cos 2t and 4 sin (2t…

A: It is given that: a) 5sin5t-9° at t=0,0.01, and 0.1s,b) 4cos2t and 4sin(2t+90°) at t=0,1,and 1.5s,c)…

Q: What type of MOSFET is IRF640?

A: We need to tell about the type of given MOSFET.

Q: 3. Find the Req given that all resistors are 6 ohms. Req ww www www

A: We need to find out the equivalent resistance for given circuit , we will find out equivalent…

Q: R(T) = 1 To = 5 0.2 -1 dt = 0.2 √ {2+5 cos [10xt+tan~¹ (4/3)]} {2+5 cos [10z (t + 7) + tan`¹ (4/3)]}…

A:

Q: A FLOO DUGAT EMITTING 60° TO A POINT ON THE IN LUX IS. 25,000 CANDELAS IN THE CENTER OF ITS BEAM…

A:

Q: For the capacitor-input filter, calculate the capacitance C   6 μF   8 μF   10 μF   12 μF

A: The ripple is the unwanted AC quantity present in the DC output and it can be removed with the…

Q: A coil has a time constant of 1 second and an inductance of 8 H. If the coil is connected to a 100 V…

A: In this question,  We need to determine the rate of rise of current at the instant of switching.…

Q: 1. Consider an ideal low-pass filter with frequency response -66 2. |w| w. The input to this filter…

A: We need to find out output for given input signal and given system .

Q: Calculate Thevenin voltage "Q 20 V R, 1.5 kΩ R₂ 4.7 ΚΩ R$ 3.3 kQB RLOAD

A: here we have to find the thevenin voltage and thevenin resistance .

Q: A silicon transistor is biased with base resistor method. If ß=100, VBE =0.7 V, zero signal…

A: Given- Current gain, β=100. Base emitter voltage, VBE=0.7 V. Collector current, IC=1 mA. VCC=6 V.…

Q: V1 100V R1 1000 C1 0.001FF

A:

Q: destion 3 Three equal capacitors are connected in parallel across 20-volt dc source. What is the…

A:

Q: In the circuit above, use R₁ = 99, R₂ = 29, Io = 3A, and k = 1/12 V/A. a. Find the value of V.…

A: The required parameters can be calculated by using the nodal voltage and ohms law.

Q: 24V Io find Io. 1012 452 Mw 122 ++. 242 HON

A:

Q: Problem- A single phase induction motor draws 12 MW power at 0.6 lagging power factor. A capacitor…

A: Given, The induction motor draws power, P=12 MW The operating power factor without the capacitor,…

Q: EX:7) Draw the X-diagram for the given system with mark all reactance in per-unit values. Chose the…

A:

Q: Determine the angle by which v₁ leads i₁ if v₁ = 10 cos (10t – 45°) and i₁ is equal to (a) 5 cos…

A:

Q: A uniform line charge with pi = 5 µC/m lies along the x axis. Using Gauss' Law find the electric…

A: We need to find out electric flux for given charge distribution .

Q: 1. For the bridge network shown in Figure shown, find the current in the 5ohm resistor, and its…

A: We need to find out the current through given resistor by using of thevenin equivalent circuit , for…

Q: Solve for the node voltages shown in the figure below. The component values are R₁ = 12 N, R₂ = 16…

A: The given circuit is shown below, R1=12 ΩR2=16 ΩR3=12 ΩR4=7 ΩR5=7 Ω

Q: What is the purpose of the amplitude limiter to FM Demodulation

A: In this question We need to define the purpose of the amplitude limiter to FM Demodulation.

Q: The switch in the circuit has been closed for a long time. It is opened at t = 0. At t = 0+, the…

A: Given circuit- To find- The current through the 1 μF capacitor at t=0+.

Q: Consider the vector field G = yx ax + 2.5x ay – 2y2 az and the point Q(6, 5, -2). Find: (a) G at Q;…

A: Given: G=xyax+2.5xay+-2y2az and Q6,5,-2.

Q: 10 mV + 20 mV + 50 mV +) 100 mV + 25 ΚΩ m 20 ΚΩ 10 ΚΩ 50 ΚΩ Μ Μ 50 ΚΩ + Vo 10

A:

Q: X1 X2 X3 X3 d dt _d³x₁ d³x₁ d², = + Option 1 = x1 dt3 dt² dt 3 -[ + d² x₁ dt² + d dt d² dt² d dt dx2…

A:

Q: Op Amps Handout #2 1.a. Design an inverting amplifier to provide a gain of 25 using practical…

A: 1. Solution:

Q: A 240-volt battery has an internal resistance of 1.2 ohms is connected through a line with…

A: It is given that: V=240 voltRint=1.2 ΩRLine=8.8 Ω

Q: 1. Consider the two circuits below being driven by an AC source Vac. What is the impedance between…

A:

Q: 2 A generation station of 1 MW supplied أعلى قيمة هي رادم فيها واط ۱۰۰۰۰۰ dregion as follow: from…

A:

Q: 19A (↑) 385 Theverin's theorem (open) RTA VTH T.E-C I - (I-X+) RTH 16n га Norton's Theorem (shorted)…

A: We need to find out the current by using of thevenin equivalent circuit and norton equivalent…

Q: Consider the signal x[n] shown in the figure x[n] ILII ILI 3. vialexin il y[n] 1.0 The signal y[n]…

A:

Q: Discuss differences, advantages, and disadvantages of the connections + switch power supply 2 light…

A: Given: variety connections of bulbs. To explain: Differences, advantages and disadvantages of…

Q: IV. Compare the Fourier transform table specifically this part 1 e-ªu(t), a>0 jw + a 1 te-ªtu(t),…

A: We need to find out the Fourier transform for given signal .

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.