advanced equipment  15. The supply systems for sensitive electronic equipment are _______ systems. A. three-wire, three-phase B. four-wire, single-phase C. three-wire, single-phase D. four-wire, three-phase

Q: The width W of the depletion layer for a pn junction can be given by: 2e,(1 W = Np where e, is the e...

A:

Q: Question 20: The fundamental period of the signal r(t) = sin (t +7) + eit/3 is %3D A: 27 B: none of ...

A:

Q: e. noncausal and nonstable The output of a system is given by y(t) = (ax(t)+1)2- a(t)2 -b. For which...

A:

Q: .6. The integral / u(1 +T)u(1+T)dr = 2 (a) 4 (b) zero (d) none of these (e) 2

A:

Q: The circuit of Fig.3.23 consists of identical resistors R R2 =200 2, an ideal diode D and an ideal t...

A: The solution is given below 

Q: V1 520 R2 R3 R4 16 260 I1 R1 R6 Va 40 250 R5

A: We need to find out norton current and thevenin equivalent resistance and thevenin equivalent voltag...

Q: 4. The circuit uses current- (or shunt-) feedback bias. The Si transistor has ICEO = 0, VCEsat =0, a...

A: We need to find out feedback resistance value for given circuit

Q: 8. A function r(t) can be decomposed to an odd and even components as r(t) r.(t) +r.(t). The total e...

A: The solution is given below

Q: Q/ The output signal from an AM modulator is: s(t) - 5cos(1800m t) 20cos (2000m t) 5cos (2200m t(a) ...

A:

Q: 1. The circuit shown in the diagram consists of two resistors connected in parallel to a cell. The v...

A: As per our guidelines we are supposed to answer only first question. Kindly repost the other questio...

Q: 9. An LTI systen has input a[n] = 8[n- 2] which gives the output y[n] = u[n 3]. The impulse response...

A:

Q: ww 2 ΚΩ Vo 15 KO 10 mA Consider the following circuit and find the output voltage D zenon -150 V -30...

A: Brief description : Operational amplifier is active device which have the capability to deliver powe...

Q: Use Load-Line analysis to solve for the diode current and the diode voltage in the following circuit...

A:

Q: 2. The LTI system with h(t) = 8(t – 1) + e*u(-t-- 1) is %3D a. causal and nonstable b causal and sta...

A:

Q: Consider the circuit diagram below. Using mesh analysis, compute the currents (a) IR1, (b) Iz1, and ...

A:

Q: 30 k2 ww 10 kQ 5 kO Consider the following circuit and find the voltage gain.

A: Calculation of voltage gain of the given op-amp circuit. We know, Volatge gain AV=V0VI Input is ap...

Q: For the circuit shown and using the T-equivalent circuit of a linear transformer, the magnitude of l...

A:

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as ...

A: Answer -

Q: A coil in a 60-Hz circuit has a resistance of 100 N and an inductance of 0.45 H. Calculate (a) the c...

A:

Q: 9. Consider the foilowing statements. undefined t= 0 S1: 8(t) = to otherwise S2 : 8(t) = %3D 10 othe...

A: In this question we have to write about delta function.....

Q: Question 19: The signal r(t) = cost +3 cos 2t is A: none of these B: periodic, energy with period 27...

A:

Q: Q3: In the circuit shown below determine Thevenin's equivalent circuit and find the maximum the load...

A: Circuit diagram is given as,  

Q: Calculate the value of RB in ohms. at VCC=17 V, IB=28 uA, and VC=7V and B=77

A: The given circuit diagram is shown below:

Q: 1. Alternating current systems of less than _______ volts are required to be grounded if they're ins...

A: Alternating current systems of less than _______ volts are required to be grounded if they're instal...

Q: H.W: Compute the binary code word values for the amplitudes 0.4 V and 0.78 V, then compute the quant...

A:

Q: Vcc R1 RC Q1 NPN +88 8 R2 RE Volts VC

A:

Q: 40 50 A V OE OC 41.17 09 09 S000- time Fig. 4 6) The waveform of iz can be expressed as: (1) 50cos(1...

A: It is cosine function with delayed 

Q: Calculate the noise voltage at the input of a television RF amplifier, using a device which has a 20...

A:

Q: The EMF induced in the secondary winding of a 50 Hz single-phase transformer having 500 turns on its...

A:

Q: Given a common magnetic core whose length is 100 cm, its cross-sectional area is 25 cm square. The r...

A: The solution is given below

Q: It is required to design a series RLC circuit with BW 20 rad/s and wo 1000 rad/s. If R= 10 n, then t...

A: The solution is given below 

Q: 4) Write a truth table for the function performed by the CMOS transistor. The truth table should hav...

A:

Q: Phase a of a 3-phase system is given by, ean = 155.56cos(377t)V. There is a balance load comprised o...

A: In this question,  Phase a voltage is given. Ean = 155.56 cos(377t) V Balanced Delta load is given Z...

Q: 30 de 60 dB/decade w (in log scale) 10 Consider the following Bode plot of a transfer function and f...

A: Brief description : In the above given question they have mentioned a bode magnitude plot of a open ...

Q: 20. Solve the difference equation yn +÷yn-1 = Un +÷un-1, where un is unit step sequence.

A: In this question,  Difference equation is given.  Solve the given equations.  We know  Z transform o...

Q: V -8.2 1 V V. 1 + 4.2x10°-j0.3455+830 j708.743 -j0.41296

A:

Q: How does the series connection differ from the parallel connection?

A: Differences between the series connection and parallel connection.

Q: Draw the output waveform for the zener limiting circuit. Show your analysis. 2. ANS. Will limit the ...

A:

Q: Determine if the given statement is a proper way to handle electricity or not explain why (or why no...

A: Given ,  Different statements , We have to explain about them.        

Q: The self-inductance of a linear the magnetic circuit is a constant that is: dependent on the winding...

A:

Q: Q6. Determine whether the following Boolean equation is true or false. x'y' + x'z + x'z' = x'z' + y'...

A:

Q: The small-signal parameters of the NMOS transistor shown in the Figure are as below. The transconduc...

A:

Q: 11. Given the function r(t) Sa The second null will occur at t = 3. a. 6T b 47 C., 77T d. Зт e. none...

A:

Q: Obtain the truth table of the following functions, and express each function in minterms and/or maxt...

A:

Q: Calculate the shot noise current in a transistor whose average collector current is 5mA if it is ope...

A:

Q: e. In a non-magnetic medium, E = 50 cos(10°t – 6x ) a, + 40 sin (10°t – 6x)a, V/m. Find the dielectr...

A: e)

Q: The system described by y(t) = e'r(t- to) is %3D (a) nonlinear and time-varying (b) insufficient inf...

A:

Q: Question 6: Given r[n] = u[n] + u[-n – 1] and h[n] = 8[n – 1]. What is r[n] * h[n]? %3D %3D A: 1 B: ...

A:

Q: 20. For a linear time-invariant system if the step response is known, the impulse rsponse can be ob ...

A:

Q: A 100 kVA, 220/440 V, 50 Hz power transformer is tested at 75 Hz to evaluate the core loss, while it...

A: In this question we need to find a most appropriate voltage applied to LV side.

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.