Air enters a circular variable area converging duct at a temperature of 500 K and the static pressure of 130 kPa, and the Mach number of 0.5. Considering study isentropic flow, what will be: i. The pressure, ii. The temperature, and ii. The Mach number at the outlet, if the outlet is reduced by 10% compared to inlet area.

Air enters a circular variable area converging duct at a temperature of 500 K and the static pressure of 130 kPa, and the Mach number of 0.5. Considering study isentropic flow, what will be: i. The pressure, ii. The temperature, and ii. The Mach number at the outlet, if the outlet is reduced by 10% compared to inlet area.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.68P

See similar textbooks

Similar questions

Air Is flowing isentropically through a converging duct wl)lcJ,,is fed from a. large reservoir where )he temperature and pressure are 300 1<" and 400 kPa, respectively. The mass flow rate through the duel Is 4 kg s-'. Determine the Mach number, pressure, temperature and velocity at a point where the cross-sectional area is 0.01 m2
Air at 25 psia, 320°F, and Mach number Ma = 0.7 flows through a duct. Calculate the velocity and the stag nation pressure, temperature, and density of air.
Under low-speed incompressible flow conditions, the pressure coefficientat a given point on an airfoil is −0.54. Calculate Cp at this point when thefreestream Mach number is 0.58, usinga. The Prandtl-Glauert ruleb. The Karman-Tsien rulec. Laitone’s rule
Consider the supersonic flow of air over a two-dimensional wedge with a half angle of 10 degrees at 70 kPa, 260 kelvin, and mach number 2.4 after shock. If the axis of the wedge is tilted 25 degrees beforehand, determine the post-shock Mach number, temperature and pressure on the wedge.
Consider the flow of air through a supersonic nozzle. The reservoir pressure and temperature are 5 atm and 500 K, respectively. If the Mach number at the nozzle exit is 3, calculate the exit pressure, temperature, and density.
Nitrogen enters a duct with varying flow area at 400 K, 100 kPa, and a Mach number of 0.5. Assuming a steady, isentropic flow, determine the temperature, pressure, and Mach number at a location where the flow area has been reduced by 20 percent.
A converging duct is fed with air from a large reservoir where the temperature and pressure are 400 K and 200 kPa, respectively. The Mach number at a point along the duct, where the cross•sectional area is 0.01 m', is 0.7. Determine the temperature, pressure, velocity and density at that point, and also calculate the mass flow rate. Assume lsentropic flow throughout the nozzle.
Air flowing steadily in a nozzle experiences a normal shock at a Mach number of Ma = 2.5. If the pressure and temperature of air are 10.0 psia and 440.5 R, respectively, upstream of the shock, calculate the pressure, temperature, velocity, Mach number, and stagnation pressure downstream of the shock. Compare these results to those for helium undergoing a normal shock under the same conditions.
Consider the isentropic flow through a convergent-divergent nozzle with an exit-to-throat area ratio of 2.5. The reservoir pressure and temperature are 1 atm and 288 K, respectively. Calculate the Mach number, pressure, and temperature at both the throat and the exit for the cases where (a) the flow is supersonic at the exit and (b) the flow is subsonic throughout the entire nozzle except at the throat, where M = 1.
Nitrogen enters a converging–diverging nozzle at 620 kPa and 310 K with a negligible velocity, and it experiences a normal shock at a location where the Mach number is Ma = 3.0. Calculate the pressure, temperature, velocity, Mach number, and stagnation pressure downstream of the shock. Compare these results to those of air undergoing a normal shock at the same conditions.
The low speed minimum pressure coefficient value over an airfoil at is -0.5. Using the PrandtlGlauert rule (analytical method), calculate the critical Mach number at 5 degrees angle of attack. (Be very accurate)
A flow of air with Mach number M1 = 2, pressure p1 = 0.7 atm, and temperature 630 degR is turned away from itself through an angle of 26.38 deg. Determine the Mach number, the staticpressure, the static temperature, and the stagnation pressure after the turn (all pressures in atm).Also determine the Mach angles at the beginning and end of the expansion fan.