Air flows steadily through an adiabatic turbine, entering at 1MPa, 500 oC and 120 m/s and leaving at 150 kPa, 150 o C and 250 m/s. The inlet area of the turbine is 80 cm2 Calculate, a) mass flowrate of the air b) the power output of the turbine.

Q: Sulfur dioxide (A) diffuses through a stagnant layer of air (B) of 2 cm thickness at 45oC and 1.2 ba...

A: As per Bartleby guidelines, we are supposed to answer only the first 3 sub- parts. Kindly repost oth...

Q: Example 1; Find the scalar product of the two vectors A.B in Fig. 6. The magnitudes of the vectors a...

A:

Q: Q5: What weight of pyrite ore (impure FeS,) must be taken for analysis so that the BaSO, precipitate...

A: It is a chemical analysis technique in which the substance sought is transformed into another substa...

Q: Q1: Mass flow through a sonic nozzle is a function of gas pressure and temperature (Pressure P, Temp...

A:

Q: Equipment necessary to manufacture adjustable ball-lock pins for pulling two components together had...

A:

Q: Estimate the filtration flow (cm³/sec) of pure water across a membrane with a total surface area of ...

A: Given data: Surface area=900cm2 Viscosity of water=1cP Opening=0.55μm Porosity of membrane=20% Membr...

Q: A system consists of a turbine and heat exchanger are connected in series. The working fluid is ente...

A: The turbine is the device in which fluid expands. A heat exchanger is a device in which energy is tr...

Q: Glass is substance. O Amorphous O crystalline O conductive All O O

A: Solids are categorized based on the arrangement of atoms, the ability to transfer light from one sid...

Q: Two bulbs are connected by a straight tube, 0.001 m in diameter and 0.15 m in length. Initially the ...

A: Given: Diameter of Tube = 0.001 m, Length of Tube = .15 m, T = 25 0C, P = 1 atm After diffusion star...

Q: For the experimental data of a cooling tower shown in the table below: Air flow (1/sec) 30.57 Water ...

A: It is required to calculate the cooling tower efficiency, the total heat transferred from water duri...

Q: In a steady flow apparatus, a fluid enters with a specific volume of 0.40 m3/kg, a pressure of 550 k...

A: V1=0.40m3/kgP1=550kPav1=20m/sz1=40mV2=0.82m3/kgP2=100kPav2=280m/sW=140kJ/kgQ=-12kJ/kgTo find:∆U

Q: Calculate AH for the following reaction NO+O----NO2 using the following equation 1- 203 --------302 ...

A: Given reactions, Reaction 1: 2O3 → 3O2                        ∆H = -430 kJ                  Reaction...

Q: Liquid mixture of A and B is to be have the concentration of B reduced by 26 times in co_current uni...

A: Given: Initial concentration of B = C, Final Concentration of B = C/26 Feed of A to solvent flow rat...

Q: p = 70.5 exp(8.27 × 10-7P) where p is density (lb/ft³) and P is pressure (lb,/in.2). (a) What are th...

A:

Q: Q: The working fluid, in a steady flow process flows at a rate of 220 kg/min. the fluid rejects 100 ...

A: Given data: Fluid flowrate=220kg/min Heat reject is 100kJ/s   Inlet outlet Velocity (m/s) 320 1...

Q: Q2/ Consider steady one-dimensional heat conduction in a large plane wall of thickness L and constan...

A: Given: Boundary conditions-kdT0dx=q0    at x=0 & -kdTLdx=hTL-T∞ at x=LIt is required to obtain e...

Q: The process shown in below they think too much alcohol is lost in the bottoms (waste). Calculate the...

A: Given that, Feed F = 1000 kg Mass fraction of alcohol in feed xEtOHF = 0.1 Mass fraction of water in...

Q: A cloud of coal particles is traveling through a system. The cloud diameter estimated to be 0.027 m ...

A: Given data: The diameter of cloud = 0.027 m Drag coefficient for total cloud = 0.44 Density of cloud...

Q: Air is used to heat a room. The flow rate of the entering air to the heating unit is(2.50 m3 /s) at ...

A: Heat lost by a system will be equal to the heat gained by surroundings. This says that the heat or t...

Q: A liquefied mixture of n-butane, n-pentane, and n-hexane has the following composi- tion in percent:...

A: To find: a. weight fraction. b. mole fraction. c. mole percent of each component. d. average molecul...

Q: The following parameters apply to enzymes entrapped in a porous matrix.  VM = 8 mg/L-min;  KM = 150 ...

A:

Q: Given that a 50.0-kg test run of gas averages 10.0% H2, 40.0% CH,, 30.0% CO, and 20.0% CO2, what is ...

A: Given: 50 kg of sample containing mixture of gases. Composition (Mole fraction) and Molecular weight...

Q: A metal container has a volume of 188 m³. It is filled with nitrogen at 29°C and atmospheric pressur...

A: From ideal gas law, we have the relationship between the temperature, pressure, volume and the numbe...

Q: P Flag question A heat engine transforms a. heat into work b. work into electricity c. light into el...

A: If we talk with respect to thermodynamics and engineering , we can define  heat engine as a system t...

Q: Q.2/A/ The electric heater consumes 1.5 MJ when connected to a supply of 225 V for 25 minutes. Find ...

A:

Q: Example (H.W): Ammonia is to be removed from a 10 percent ammonia-air mixture by countercurrent scru...

A: The equilibrium data is, Y* = 0.8X mole% of ammonia in gas is 10%   Mole fraction of ammonia in init...

Q: A 2-kW resistance heater wire with thermal conductivity of k = 20 W/m C, a diameter of D = 5 mm, and...

A: Given that, Heat generated Q = 2 kW = 2000 W Thermal conductivity K = 20 Wm.Co Diameter D = 5 mm = 5...

Q: Calculate the pressure exerted by 1.0 mol C2H6 at 1000 K in 100 cm3 using (a) the ideal gas equation...

A: The ideal gas law is given as the product of pressure and volume which is equal to the product of th...

Q: Consider a composite plane wall as shown: k = 20 W/mk A, = 1 m?, L = 1m %3D %3D T, = 0°c T; = 100°C ...

A: The rate of heat transfer through the wall is to be calculated.

Q: Calculate Z for ammonia at 320 K and 15 bar by (c) The second virial coefficient equation (d) The So...

A: Given that, Temperature T = 320 K Pressure P = 15 bar It is required to calculate the Z for ammonia ...

Q: 3) A rigid tank (stationary) contains a hot fluid that is cooled while being stirred by a paddle whe...

A:

Q: Not sure

A: Given: Hydrazine = 750g Hydrogen peroxide = 125g The molecular weight of H2O2 = 34 The molecular wei...

Q: If a process designed by a chemical engineer shows severe damage to the environment. As a chemical e...

A: As an chemical engineer with professional ethics and conduct one should always look after environmen...

Q: 4.4. How much heat is required when 10,000 kg of CaCO, is heated at atmospheric pres- sure from 50°C...

A: Given: Mass of CaCO3 (m)= 10000 kg Initial temperature (T1) = 50 °C Final temperature after heating ...

Q: (B) The pressure of gas being pulled though a line by a vacuum pump is measured with an open end mer...

A: The open-end mercury manometer is a U-shaped device made of glass with a small diameter and filled w...

Q: Double effect evaporator is used for concentrating a certain caustic soda solution 10000kg/hr from 9...

A: Evaporators are used to extract the pure form of solids from the slurries where the moisture or the ...

Q: Ql: Mass flow through a sonic nozzle is a function of gas pressure and temperature (Pressure = P, Te...

A:

Q: Example (H.VW): Ammonia is to be removed from a 10 percent ammonia-air mixture by countercurrent scr...

A:   Given ,   Equilibrium data ,Y*=0·8X Mole percent of ammonia in gas is 10% Mole fraction of ammonia...

Q: :A mixture Containing (wt7) 457 B and the balanced Tis Fed to a distillation Column. The over head (...

A: Given that, The weight fraction of B in the feed xB,F = 0.45 The weight fraction of T in the feed xT...

Q: How do you calculate (a-vO2) using Fick equation? Using the right units of measurements? Peak strok...

A: The process to calculate the vO2 with the help of the Fick equation is to be determined along with v...

Q: Ql: What is the kinetic energy of a vehicle with a mass of 2300 kg moving at the rate of 10.0 ft/sec...

A:

Q: Consider the phase diagram for water in pressure-volume coordinates and answer the following: A) Sat...

A: (A) Given, At, T1 = 170 °C Saturation pressure of water, P1 = 7.9 bar    At pressure P2 = 10 bar Sat...

Q: ) What is the mass of 5.13 moles of Na2Cr207?

A: Since you have posted multiple independent questions in the same request, we will solve the first qu...

Q: A water solution containing 10 wt.% acetic acid is added to a water solution containing 30 wt.% acet...

A:

Q: Q: Amate nia is diffusing through a stagmnt gas mixture Consisling of one-third nitrogen and two thi...

A: Given that, Total pressure Pt = 206.8 kNm2 = 206.8 kPa Temperature T = 54oC = 327 K Thickness of the...

Q: The original cost of a property is $ 35000. Its salvage value is to be $3500 at the end service life...

A: Given: Original cost of a property Vo = $35000 Salvage value Vs = $3500 life of property n = 8 years...

Q: Estimate the fugacity of isobutylene as a gas: a) At 280 degrees Celcius and 20 bar(use 2nd virial c...

A:

Q: Q2 - Calculate average permeability from the following core analysis data Depth, ft k, md 4000–4002 ...

A: Given data: Depth, ft k, md 4000-4002 50 4002-4005 20 4005-4006 70 4006-4008 100 4008-4...

Q: How many total atoms are there in 34.2 g of CH3CO2H?

A:

Q: Calculate n (kg totalis), mco (kg CO/S). and y (kg CO/kg total) in terms of m 50 kg H,O/s mackg dry ...

A: Flow rates in terms of m.dg is asked.