An 8-pole, 3-phase, 50 Hz induction motor is operating at a speed of 720 rpm. The frequency of the rotor current of the motor in Hz is __

Q: A 40 kW induction motor, with a lagging power factor of 0.76, is supplied by a 120 V rms 60 Hz sinu...

A: The solution is given below

Q: R1 For the circuit shown in figure beside, select the values of R1, R2 & R3 so that: y1=0.5v, y12=-0...

A:

Q: Q3: Calculate thevalueof the currentshown in the below figure? 6mA w? 2mA 2A 3mA 7A 6A 1mA OA

A:

Q: 3. y" – 2y' + 5y = 0 initial conditions: y(0) = -1 and y'(0) = 7 %3D %3D

A:

Q: A single phase 9.6 kVA, 500 V / 1.5 kV transformer has an impedance of 1.302 Ω with respect to  prim...

A: GivenKVA of the transformer =9.6 KVA=0.0096 MVAPrimary side voltage=500 v=0.5 Kvsecondary side volta...

Q: importance of the electrical and robotic components of the robotic circuit?

A: After the evolution of compact electrical components and Processing languages, self-driven robots pl...

Q: A. A. B. module OR (ar buy} In this question, the user of the OR logic gate and the gate table itsel...

A: Brief description : Logic gates are used to implement any digital circuits. The basic logic gates ar...

Q: True/False A Latch is a back to back set of two Flops with inverted clock inputs to them. This logi...

A:

Q: The position of a particle moving along the x-axis is given by (X(t)=3t+2t^3 ). Find the acceleratio...

A: Given,The position of a particle moving along x-axis is,X(t) = 3t+2t3 Here, we have to determine the...

Q: Consider an FM signal s(t)=10 cos(2n 10 t+8 sin 4n 10 t).Determine a. modulation index b. frequency ...

A:

Q: al 10 D.

A:

Q: calculate the magnitude of the Thevenin equivalent impedance. Assume that the j3 ohm inductor is the...

A:

Q: (22)Use nodul analysıs to fin the power in (552) resis tor. [ 149.05 W) 15 i 252 Yu.52 125V- 8.2 55S...

A: The circuit are given as 

Q: For the system shown take the output to be the displacement x1. Find the response of the system to a...

A:

Q: Design and write a truth table using the Karnoff map What is the name of the resulting circle?

A:

Q: #1) Compute Vo: 2mA Vo 4k2 14MA

A:

Q: An ac voltage of peak value 20v is connected in series with a silicon diode and load resistance of 5...

A: Diode- Diode is a device which is used as switch which allows the flow of current in one direction. ...

Q: 34. In the circuit of Fig. 10.53, which is shown in the phasor (frequency) domain, I10 is determined...

A:

Q: C

A: The solution is given below

Q: 3) Electronic component pinout dimensions, are taken from Actuator options dimensions PCB layout dim...

A: It is asked to choose the correct option for taking electronic component pinout dimensions.

Q: A Fabry-Perot filter is used to select 100 channels spaced apart by 0.2nm. What should be the cavity...

A: Fabry-Perot optical filter-The Fabry-Perot optical filter consists of two flat mirrors that reflect ...

Q: In the circuit shown in figure (3) V1 =12V ,find Vs : 4 kn 2 kn V1 1 kn Vs 6 k! 4 kf2 3 kn ww

A: This question belongs to circuit theory . It is based on the concept of current division , voltage d...

Q: D3.4. Find the total electric flux leaving the spherical surface r = 2.5 m given the charge configur...

A: Here,We have to find the total electric flux leaving the spherical surface in different charge confi...

Q: The electric field lines point radially outward a negative point charge. OTrue OFalse

A: The question is about electric field lines point radially outward for the negative point charge is i...

Q: A short shunt compound generator has an armature,shunt field and series field resistances of 0.02 oh...

A:

Q: Determine the closed-loop voltage gain of the circuit shown in the figure assuming an ideal op amp

A: For ideal opamp voltage at inverting terminal is same as voltage at non inverting terminal.  For ide...

Q: Series Diode Configuration 4. Ge Si 4. Vo and Ip +12 Vo- Love Ip 5.6KQ

A:

Q: 4. Compute the power dissipated by a. A 5-ohm resistor with 5-A current b. A 12-V battery with 12-A ...

A: The solution is given below 

Q: A germanium diode draws 32 mA with the forward bias 0.27 V. If T=300 K, calculate the reverse .satur...

A:

Q: Q3: Calculate the value of the eye aid in Figure T? V-5V V=V V=6V V=8V

A:

Q: c) Define RMS value and average value. Find the form factor and crest factor of the following wave s...

A:

Q: Q2 Figure Q2 shows a simple logic circuit. Be Figure Q2 Compute the simplified Boolean expression fo...

A: Given,  

Q: Question 2 Consider the closed-loop system shown in in Fig. 2. G:(3) U(s) Process G(5) 15 3+ 5s + 11...

A: Given, Closed loop system:  

Q: In a 4-bit arithmetic circuit if the given input numbers A & B are 1011 and 1001 respectively. Then ...

A: Given Inputs A=1011    B=1001     Control inputs are 011 and 110

Q: An alternating current of frequency 50Hz has a maximum value of 200 2A Reckoning the time from the ...

A: Given, An alternating current  Frequency, f=50 Hz Maximum current, Im=200 A  

Q: Consider an FM signal s(t)=10 cos(2n 10 t+8 sin 4n 10° t).Determine a. modulation index b. frequency...

A: Given data, A FM signal st=10 cos2π·106t+8sin4π·103t

Q: Find the the Gradient of (f(Zy-3)) * O zj+yk

A:

Q: 4. Construct a complex circuit that will produce a total resistance of 9540.54 500 V battery, resist...

A:

Q: 10.4: For the circuit shown: 1. Find the Z-Parameters? 2. Find the Y-Parameters? 52 ww 2012 202 502 ...

A:

Q: F2(ABC) = (AÅB)C + (A’+B’)’ 1. Convert the expression into Standard Sum of product (SSOP) form using...

A: Brief description : SOP : Sum of product terms. POS : Product of sum terms. SOP : Minterms. POS : Ma...

Q: What are the drawbacks of using OOPS?What are the drawbacks of using OOPS?

A: OOPs -  The term OOP stands for object-oriented programming. it is a language of programming that en...

Q: A controller is to be designed for the plant for a transportation delay of 0.05 s. Explain briefly w...

A: Transportation delay in a control system is the time difference between the Applied input to the sys...

Q: 8- If we were to build a truth table for a 16-input AND gate, how many different combinations of inp...

A: 8. If we were to build a truth table for a 16-input AND gate , how many different combinations of in...

Q: Three point charges are located as shown in the figure 9-5 x 10-12 IC) and di 6 lem] -4 x 10-12 IC] ...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: ) The following figure shows a transistor-level (CMOS) circuit for some logic gate. Sketch the logi...

A: The transistor-level (CMOS) circuit is shown below,

Q: The reactance of a generator is given as 0.25 per-unit based on the generator’s of 18 kV, 500 MVA.  ...

A:

Q: An ac voltage of peak value 20v is connected in series with a silicon diode and load resistance of 5...

A:

Q: 1. What is the phase sequence of a balanced three phase circuit for which Van = 160Z – 90 V? Find Vm...

A:

Q: explain why a voltage divider used as a bias on a dual-clipper circuit does not give a 'clipped' out...

A:

Q: An object is launched at a velocity of 20 m/s in a direction making an angle of 25° upward with the ...

A:

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.