An Alternator has an effective line voltages of 1 20 V, has an impedances of 5 / 45 in Wye connection. Determine the a) line current, line voltages b)the apparent power of the connected load. What is the capacity of synchronous generator if the connected load is 85%.

Q: For the following circuit, draw the output signal. D A- B- Y A B

A:

Q: Calculate the current I for the network given below Si -10 V KK Ge 1.2 ka ... 3.3 K2 Ge Si 1.2 k2 Va...

A: We need to find out the current for given circuit

Q: What is the color code for a 8KQ, tolerance t 10% resistor? Find the nominal value of the resistance...

A:

Q: Predict how the operation of this clipper circuit will be affected as a result of the following faul...

A:

Q: Consider two toroids of square cross section of air core,

A:

Q: find all current flowing through each resistors

A:

Q: 1. Using vector diagram show and briefly explain the effect of supply voltage changes on a synchrono...

A: The armature current Ia in a dc. motor is calculated by multiplying the difference between V and Eb ...

Q: using the conventional current flow, where is the direction of the current during the positive cycle...

A: The solution is given below 

Q: 3. A fine-grain aluminum wire (grain size is 0.2um) is thermocompressively bonded to aluminum thin f...

A: Electromigration- The term electromigration is define as the movement of atoms with in the material ...

Q: 3 Design a scaler using operational amplifier. Where Vo= 1/2V1+2V2 (Cr)-

A:

Q: What Transistor AC Equivalent model is the most preferred for analysis, based on our text references...

A: AC equivalent model A theoretical circuit that contains all the external characteristics of a given ...

Q: Q3. E/The only parameter that affects the conduction in semiconductors is temperature True False Con...

A:

Q: 3- Draw the Experimental setup of the short – circuit Test.

A: The  short circuit test meant for the LV side ( Low voltage side).  The experimental set up can be a...

Q: How much energy is imparted to an electron as it flows through a 25 V battery from the positive to t...

A: This question belongs to basic electrical.  It is based on the concept of energy produced by the ele...

Q: What do you mean by mesh analysis

A: Mesh: A loop which does not contain any inner loop is known as mesh.It is applicable only for planar...

Q: 4.11.1 In the circuit shown in the image below, if vs = 41 V, is = 8.5 A, and Ro Q, according to the...

A:

Q: Fill in the blanks: Ge Si 1.2 kQ -10 V 3.3 ka What is the status of Si Diode? ON or OFF mA,

A:

Q: Question1 A) Give the expressions of M1, M2, M3 1 12 13 M1 M3 М2 M1= M2= M3= B) Give the logical com...

A:

Q: Given: 1V VTH Rps,on C = 50pF = 0.4 = 100.2 1kN, At t = 0, Vc1 = 1V, V; = u(t) Solve for V.(t) 1. C1

A:

Q: 4Ω 1Ω a 32 V (+ 12 Ω 2 A RL Copyright O McGraw-Hill Education. +1)

A:

Q: For the circuit shown, a) If ve = 1 kV and i, = 5 mA, find the value of R and the power absorbed by ...

A: The required values can be calculated by using the ohm's law in the circuit.

Q: For the circuits given below find the voltage of drain , source and gate ( Vo ,Vs,VG) of each circui...

A: (a) The figure (a) is shown below: It can be observed from the above circuit diagram that:  Vdd=15 ...

Q: 4. Determine the output voltage (Vo) and diode current (Ip) for the circuit shown below 2 ka Si +10 ...

A:

Q: 5. The following figure shows the eight-bit Adder-Subtractor. Your inputs for this combinational cir...

A:

Q: 1. Using nodal voltage method, determine the magnitude and direction of the current / in the network...

A: Given circuit- Before applying node voltage method to the above circuit, First applying source tran...

Q: For the following circuit, draw the output signal. A- B. Y A B

A:

Q: Quèstion 11 The current gain(a) is greater than the current gain(B). O True False

A:

Q: D/ The junction is in thermal equilibrium when the answer

A:

Q: く+ Using KCL and KVL, calculate the voltages V and V, for the netw shown below. All the resistors ar...

A:

Q: . Sketch the waveform of vo. Indicate the maximum and minimum values. R vo 10 Vpk E 4 V

A:

Q: What are the problems in an ordinary op-amp integrator?

A:

Q: 6. A short 3-phase, 34-kV power transmission line delivers a load of 10-MW at a power factor of 0.9 ...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: For the following circuit, draw the output signal. D- A- B- Y. B.

A:

Q: • Determine I, V,, V,„ and V, for the series circuit + V - R1 E1 = 10 VoMw 4.7 k2 Si R2 2.2 k2 V, E2...

A: The circuit diagram is shown below, Where,R1=4.7kΩR2=2.2kΩ  

Q: I. Solve for all current and the voltage values across each component. 20n 402 240V, Is MF 5oHz SomH...

A:

Q: Why do we need to analyze the BJT to see its AC Response?  What controls the amplification of the B...

A: BJT: It is a Bipolar Junction transistor or switch and it is a three-terminal device example emitter...

Q: (a) At what reverse-bias voltage does the reverse-bias current in a silicon pn junction diode reach ...

A: It is given that: ID=0.9Is  

Q: Subject: Circuits II If the secondary of the transformer is step down, the primary will have

A:

Q: 3Ω 3Ω Ο σ 15 V 4Α 6Ω

A:

Q: 6.a. Which of the following can you accurately measure using an OSA? A. Signal power in a channel on...

A: 6.a.  An optical spectrum analyzer(OSA) is an instrument that is used for the measurement of the sig...

Q: Using Y-∆ or ∆-Y transformation, determine the equivalent resistance and total current

A: In this question, Determine the equivalent resistance and total current using Y-∆ or ∆-Y transformat...

Q: 7. Find the Thévenin equivalent circuit for the network external to the resistor R in each of the ne...

A: In this question,  We need to Calculate the Thevenin theorem across the resistance R.  Here two circ...

Q: 2. Find the total current of the charge graph below q (C) A 10 1 2 4 t(s)

A: Given

Q: Calculate the resistance of a metal conductor 20 m length of a wire having a uniform cross-sectional...

A:

Q: (I) Circle the correct answer (8) 1. Sun light is converted to electricity in silicon when a photon ...

A: "Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Problem 37 - Find the total inductance for the network shown below. 3.3 mH 2.4 mH L4=5.6 mH L3=3 mH ...

A: In this question, we will find equivalent inductance for given circuit....

Q: مختبر الكهربات R, IR R A 1KO 1.5KN R2 R. R2 2.2K 3V 4V D

A:

Q: Given three impedances Z1= 10+j0, Z2= 3+j4 and Z3= 8-j6. Impedance Z2 and Z3 are connected in parall...

A:

Q: Q1/ Assume that the Fermi energy level is 0.25 eV above the valence band energy. Let T = 300K. Deter...

A:

Q: For the circuit below, find the curent I.

A: The given circuit diagram is shown below:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.