An aluminum cylinder weighing 30 N, 6 cm in diameterand 40 cm long, is falling concentrically through a longvertical sleeve of diameter 6.04 cm. The clearance is fi lledwith SAE 50 oil at 20 ° C. Estimate the terminal (zeroacceleration) fall velocity. Neglect air drag and assume alinear velocity distribution in the oil. Hint: You are givendiameters, not radii.

An aluminum cylinder weighing 30 N, 6 cm in diameterand 40 cm long, is falling concentrically through a longvertical sleeve of diameter 6.04 cm. The clearance is fi lledwith SAE 50 oil at 20 ° C. Estimate the terminal (zeroacceleration) fall velocity. Neglect air drag and assume alinear velocity distribution in the oil. Hint: You are givendiameters, not radii.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.30P: Air at 1000C flows at an inlet velocity of 2 m/s between two parallel flat plates spaced 1 cm apart....

See similar textbooks

Similar questions

Air at 1000C flows at an inlet velocity of 2 m/s between two parallel flat plates spaced 1 cm apart. Estimate the distance from the entrance to the point where the boundary layers meet.
A tractor-trailer truck is coasting freely, with no brakes,down an 8° slope at 1000-m standard altitude. Rollingresistance is 120 N for every m/s of speed. Its frontalarea is 9 m2, and the weight is 65 kN. Estimate the terminalcoasting velocity, in mi/h, for (a) no deflector and(b) a deflector installed.
Consider two pressure taps along the wall of a laminar boundary layer as in Fig. The fluid is air at 25°C, U1 = 13.7 m/s, and the static pressure P1 is 2.96 Pa greater than static pressure P2, as measured by a very sensitive differential pressure transducer. Is outer flow velocity U2 greater than, equal to, or less than outer flow velocity U1? Explain. Estimate U2
Air at 20°C and 1 atm flows at 2 m/s past a sharp flat plate.Assuming that Kármán’s parabolic-profile analysis, , is an accurate, estimate (a) the local velocity u and (b)the local shear stress τ at the position (x, y) = (50 cm, 5 mm).
Air at 20 °C flows at V = 10 m/s over a flat plate of length L= 1.52 m and width W = 2 m.Calculate the boundary layer thickness at the trailing edge of plate and drag force on one sideof plate if:a. Surface of plate is smooth.b. Surface of plate is rough.The air properties at 20 °C are: Density, ? = 1.2 kg/m3and dynamic viscosity, ? = 1.8x 10-5kg/m·s and kinematic viscosity, ν = 1.516×10-5m2/s. kindly give me the solution of this problem with correct and logical reasoning.
Air at 20 °C flows at V = 10 m/s over a flat plate of length L= 1.52 m and width W = 2 m.Calculate the boundary layer thickness at the trailing edge of plate and drag force on one sideof plate if:a. Surface of plate is smooth.b. Surface of plate is rough.The air properties at 20 °C are: Density, ? = 1.2 kg/m3and dynamic viscosity, ? = 1.8x 10-5kg/m·s and kinematic viscosity, ν = 1.516×10-5m2/s. I got the first solution which was wrong kindly solve it correctly
Air at 20 °C flows at V = 10 m/s over a flat plate of length L= 1.52 m and width W = 2 m.Calculate the boundary layer thickness at the trailing edge of plate and drag force on one sideof plate if:a. Surface of plate is smooth.b. Surface of plate is rough.The air properties at 20 °C are: Density, ? = 1.2 kg/m3and dynamic viscosity, ? = 1.8x 10-5kg/m·s and kinematic viscosity, ν = 1.516×10-5m2/s
The main cross-cable between towers of a coastal suspensionbridge is 60 cm in diameter and 90 m long. Estimatethe total drag force on this cable in crosswinds of 50 mi/h.Are these laminar flow conditions?
A Savonius rotor can be approximatedby the two open half-tubes in Fig mounted ona central axis. If the drag of each tube is similar to thatin Table 7.2, derive an approximate formula for therotation rate Ω, as a function of U, D, L, and the fluidproperties (ρ, μ).
Consider a steel sphere (SG = 7.85) of diameter 2 cm,dropped from rest in the water at 208C. Assume a constant dragcoefficient CD = 0.47. Accounting for the sphere’s hydrodynamicmass, estimate (a) its terminal velocity and (b) thetime to reach 99 percent of terminal velocity. Comparethese to the results when hydrodynamic mass is neglected,Vterminal ≈ 1.95 m/s and t99% ≈ 0.605 s, and discuss.
The so-called Rocket Man, Yves Rossy, fl ew across the Alps in2008, wearing a rocket-propelled wing-suit with the followingdata: thrust = 200 lbf, altitude = 8,200 ft, and wingspan = 8 ft(http://en.wikipedia.org/wiki/Yves_Rossy). Further assume awing area of 12 ft2, total weight of 280 lbf, CDq = 0.08 for thewing, and a drag area of 1.7 ft2 for Rocket Man. Estimate themaximum velocity possible for this condition, in mi/h.
Air at 20 °C flows at V = 10 m/s over a flat plate of length L= 1.52 m and width W = 2 m. Calculate the boundary layer thickness at the trailing edge of plate and drag force on one side of plate if: a. Surface of plate is smooth.b. Surface of plate is rough. The air properties at 20 °C are: Density, ? = 1.2 kg/m3 and dynamic viscosity, ? = 1.8 x 10^-5 kg/m·s and kinematic viscosity, ν = 1.516×10^-5 m2/s.