An aqueous solution contains 0.239 M ascorbic acid (H2C6H606) and 0.103 M nitric acid. Calculate the ascorbate (C6H6O62-) ion concentration in this solution. [CGH606] = mol/L. %3D

Q: When Ca(OH)2 is dissolved in water, it is known that the enthalpy of solution (AHsoln) is -16.2 kJ/m...

A: Given data: Enthalpy of solution = -16.2 kJ/mol Mass of calcium hydroxide = 54 g Volume of water = 5...

Q: The density of a mahogany wood is said to be 497 - 849 kg/m3, compute the values to g/mL and g/cm3. ...

A: Density is the ratio of mass and volume. Mass can be expressed in grams or kilograms. Volume can be ...

Q: Please answer fast max in 30 minutes thank u II. One mole of ideal goose at initial conditions of 3...

A: Calculate the volume from the ideal equation for different pressure and temperature given. In the fi...

Q: a Prove that Laplace (sin at ) s2+ a2

A:

Q: For flow of gases through pipes, such flows are considered plug flows. In other words, the velocity ...

A: Given Volumetric flow rate at inlet Q1= 0.5266m3/s Mach number at inlet = 0.5 c=340m/s Volumetric f...

Q: There is 1.36 kg of gas, for which R = 377 J/kg-K and k = 1.25, that undergoes a nonflow constant vo...

A:

Q: A steam power plant operates on a thermodynamic cycle in which water circulates through a boiler, tu...

A:

Q: 15. It states that the total entropy change associated with any process must be positive, with a lim...

A:

Q: Q5. 1. Metal A melts at 1280°C, Metal B melts at 450°C. Thermal arrest data is obtained from cooling...

A: Given: Thermal arrest data for the alloy AB % A 1st Arrest Point 1st Arrest Point 0 450 0 ...

Q: A Na2CO3 solution is made up by dissolving 32.5 g of Na2CO3ˑ10H2O in H2O and adding H2O until the to...

A: The molar mass of Na2CO3.10H2O is Msalt = 286 g/mol, The molar mass of Na2CO3 is Msalt = 106 g/mol T...

Q: It is concerned with the rational design and/or analysis of performance of chemical reactors. (A) Qu...

A: 7. (D)Chemical reaction engineering is concerned with the rational design or analysis of performance...

Q: Example: Calculate the MEABP of the petroleum fraction of petroleum cut has the following ASTM D86 D...

A:

Q: Q3- Write a matlab code to create a matrix A(5,5), then: Change the first row elements with the seco...

A: MATLAB-Code: A = rand( 5,5); % The Above Statement will create a random matrix A with 5 rows and 5 C...

Q: Q2/ aqueous solution has 35% NaCl and 65% water by mass entered to crystallizer were 5 kg/hr of wate...

A:

Q: A rotary drier burns a fuel with dry air at 40oF and 30.1 in Hg. The oil contains only carbon and hy...

A: Given, The temperature of dry air, T = 40 °F = 277.594 K The pressure, P = 30.1 in Hg ×3.38639 kPa1 ...

Q: Q/ Flew between hwo reserveis. Water at 10C flow from a large reserveir to a all one thưongh a 5-em-...

A:

Q: Water at 20°C flows with a velocity of 10m/s over a flat plate which is maintained at 80°C. Find the...

A: Water flow over a flat plate Water Tw=20℃ Flat plate T∞=80℃ L=1.5m μ=4.5×10-4 Pa-s k= 0.65 W/m-K Ve...

Q: A refrigerator operates on a reversed Carnot cycle whose coefficient of performance is 5.0. The evap...

A:

Q: One hundred tons per hour of a feed containing 20 wt% Na2CO3 and the balance insoluble solids is to ...

A: Given, The flow rate of the feed is F = 100 tons/hr The weight% of Na2CO3 is 20% The weight% of inso...

Q: The change in entropy for the system is 800 k 600k 1200 kJ 800 kJ НЕ →1200 kJ 600 kJ 200 kJ 400 k 30...

A: Solution :     Given that The heat Q1=1200 kJ and Q2=800 kJ  enter the heat engine from reservoirs a...

Q: A drug having a molar mass of 160 is being produced in a reactor.  The aqueous effluent (exit stream...

A: Basis: 100 kg solution of reactor effluent stream First, calculating the density of the drug solutio...

Q: 6.4. (a) Find the transfer functions H/Q and Hy/Q for the three-tank system shown in Fig. P6-4 where...

A:

Q: Explain the selection of engineering materials for applications depend on which properties. Why the ...

A: 1.Selection of Engineering materials depends on the following parameters: Mechanical loads Wear Ele...

Q: QI The operating conditions were 25 "C, 1 atm for the diffusing of Oxygen through a non- diffusing w...

A:

Q: In a solution, a relative volatility (alpha sub a-b) greater than 1.0 means that pure component a bo...

A: Relative volatility defines ease of separation. Relative volatility is basically More volatile compo...

Q: The chemical reaction A → C + D is known to be second order with respect to the concentration of rea...

A: This problem is based on Chemical reaction Engineering. Data given : Reaction : A ---> C + D Over...

Q: Calculate the pH of the solution that results when 20.0 mL of 0.1590 M benzoic acid (Ka(C6H;COOH) = ...

A: given: volume of benzoic acid=20 ml concentration of benzoic acid=0.1590M concentration of water=mol...

Q: Exercise Problems (UNIT 1): 1. An open tank (Patm = 14.7 psi) contains 10 feet of water covered with...

A:

Q: 700 grams of a certain substance with a specific heat capacity of 16 J/g-K was heated and cooled in ...

A: Given mass of substance= 700 grams specific heat capacity=16 J/g-K a 10 step process of heating /coo...

Q: Batch reactor conversion Problem description: Consider the batch reactor shown in the attached figu...

A:

Q: Any device that performs signal conversion is Modulator explain?

A: Modulation is a phenomena in which a signal is sent through a bandpass range of frequencies. It is p...

Q: Q.)In the synthesis of ammonia stoichiometric amounts of N2 and H2 are sent to reactor where the fol...

A:

Q: Q3) A: Give the crystal structure for the following metals. Fe , Ni , Pb , Cr , Al , Ag , Zn , Mo , ...

A:

Q: (A column having trays above the packing) A mixture containing 10% of the solute A is to be scrubbed...

A: Given: Consider the absorption as below:

Q: Q1 Gas (A) is diffusing through a non-diffusing water (B) in a wetted wall column. It was recorded t...

A: Wetted wall columns have applications in the absorption process. The mass transfer coefficient is an...

Q: Calculate the gas viscosity at 1 atm and 94F. Given the following composition of the gas Fill in the...

A: Given Gas composition are given in table Component Mole fraction ,yi Molecular weight Mi0....

Q: A venture-meter is shown in Figure (1) carries water, find the flow rate if there are no losses duri...

A: To measure the flow at a converging or diverging section of the pipe, we can use a venturi meter. Th...

Q: (d) Provide the mechanism of phase-transfer catalysis taking suitable example. Why is phase transfer...

A: Phase transfer catalysis It is the process of carrying a  nucleophile from the aqueous phase to the ...

Q: Consider the system is shown in the figure below, Find the closed loop transfer function by Mason's ...

A:

Q: A fuel containing 75% ethane and 25% propane is burned with dry air. All the H subscript 2 burns to ...

A: Given Fuel=75% ethane+ 25% propane Products-H2,H2O,CO2 and CO CO2/CO=10/1 Excess air=15% Find a. M...

Q: 2)A steam power plant operates according to the simple ideal Rankine cycle. The pressure limits of t...

A: Given P1=P4=10kPa P2=P3=9MPa Mass flow rate of steam,m=60kg/s Quality of steam at turbine outlet do...

Q: D: Define and draw the Unit Cell and give an example.

A: A unit cell is the smallest element of a crystal lattice that indicates the three-d sample of the wh...

Q: Consider that an iron is forgotten to be open throughout two days while its surface temperature is a...

A: As given heat transfer is taking from iron to air ,it is a convection mode of heat transfer. followi...

Q: An LPG is composed of 60% by mole butane and 40% by mole propane. A common household LPG tank has a ...

A: Given, The LPG is composed of 60% butane and 40% propane. The pressure of the tank, P = 1.7 MPa The ...

Q: A thermometer having a time constant of (10 mh) is initially at (250°C), it is suddenly placed in a ...

A:

Q: The liquid phase reaction ammonia-formaldehyde reacts as the reactant in an isothermal, constant vol...

A: Given data: Initial concentration of NH3= 4.06 M Initial concentrations of H2CO = 6.32 M Rate of rea...

Q: Waste gas containing ammonia and sulfur dioxide is treated by water absorption in a single-stage tre...

A: Here water is used to remove unwanted gas in the waste gas. The unwanted gases are ammonia in Sulphu...

Q: Given the following reactions: P.(s) + 50,(9) – P,O10(s) 2H2 (9) + Oz(g) –→ 2H;O(g) 6H;O(g) + P,O10(...

A: Given reactions with free energy of reactions are- P4(s) + 5O2 (g)→P4O10 (s)                  ∆G⁰= -...

Q: A water storage tank assumes supply of water into a factory. Water is supplied to the tank through a...

A: The conversion factor between kW and hp is as follows: 1 hp = 0.7457 kW3.25 hp required = 2.4235 kW ...

Q: 9.

A: The compound shown in the image belongs to heterocycles. In simple words, heterocycles mean a ring c...