Answered: An element in an electric heating unit…

An element in an electric heating unit is applied to a 232v power supply. The current flow through the element is 19 amperes. What is the resistance of the elements?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 14RQ

See similar textbooks

Related questions

Q: Solve for the value of the voltage on 220 ohms resistor. D1 2200 02 10V

Q: Find the power supplied by battery B1.

A: The current through Battery B1 is calculated by using the mesh analysis and if the current through…

Q: A business uses two 3 kW fires for an average of 20 hours each per week, and six 150W lights for 30…

A: It is given that Power P1 = 3 kW Time T1= 20 hours Power P2 = 150 kW Time T2= 30 hours Cost of…

Q: Question 3: At $0.08 per kilowatt-hour, it costs $1.20 to run a heater for 50 hours from a 20-V…

A: First we need to find the power to calculate the current.

Q: An electric motor operating at 100 V d.c. draws current of 10 A. The resistance of the winding of…

A: Given, An electric motor operating at voltage, V = 100 V Current drawn, I = 10 A Efficiency, η=25 %

Q: What is the average power transferred to resistor R2?

Q: A 1.9 kW electric heater is operating with 235 V and it is running for 2 hours. Calculate the…

Q: 01:- electrical heater (500w) (250V) calculate the current will draw by the heater and its…

Q: Find power in KW taken by DC motor driving a pump to raise 1400 litre of water per minute to height…

A: Referring to the given points:

Q: find the power absorbed by the 3 ohm and 5 ohms

Q: Pl:- A – what is the cost of using 200W oil-burner motor running b00 min a week for 7 months at g ¢…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again. The…

Q: no. 000 AWG wire is 100 meters long. For no. 000 wire, it has a wire resistance of 0.0618 ohms per…

A: In this question , we will find power loss in given AWG wire resistance length and current flowing…

Q: A 60 ohms bulb is connected to a 220V source for 1 hours. How much energy is taken from the source?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Assuming a rate of 3 cents per kwh,how much will I pay for the loss with 7657.8881 watts due to the…

A: The solution is given below

Q: If the voltage drop across a 560ohm resistor measures 15 V, what is the power absorbed by the…

Q: The voltage drop across a resistor of 150 ohm is 10 volts. The wattage of the resistor must be 1 W.…

Q: The voltage supplied to a water heater was reduces to 75%.The power consumed by the heater will be…

Q: 1 (t) 3202 vos 50 cos (40ot - 98) Volts 31.25 Ho0mH HF

A: Given Vg =50cos400t-90° VR1 =320 ΏR2 =80 ΏC =31.25 μF L =400 mHω =400 rad/S

Q: What should be the current passing through the 120-ohm resistor? (in milliamperes, rounded-off in…

A: If R1 and R2 and R3 are connected in parallel than equivalent resistance be Req than…

Q: Calculate the total electrical energy consumed for a load usage of 5 lamps (24 watts each) for 8 hrs…

A: Total lamps=5 power of each lamp=24 watt light on for 8 hrs per day

Q: An electric heater is used for 2hrs daily. The monthly bill of the electricity is 10$. The rate of…

A: The monthly electricity bill evaluated as:

Q: 6. A thermal station has an efficiency of 15% and 1-0 kg of coal burnt for every kWh generated.…

Q: motor with an efficiency of 87% is required to deliver 3kW of power for an hour. The electrical…

Q: What voltage drop will be there across a 1 kW electric heater whose resistance when hot is 40 2? 150…

A: Given a electric heater having, Power rating, P = 1 kW Resistance, R = 40 Ω

Q: Kirchhoffs's Law, calculate the voltage across 2 ohms resistor.

Q: 1. A current of 3A flows for 60 seconds through a lamp. How much charge has moved? 2. If 28000 C of…

Q: if a dc generator delivers 180w to a load, what is the minimum hp needed to drive the…

A: if a if a dc generator delivers 180w to a load, what is the minimum hp needed to drive the…

Q: A 50-ohm load dissipates 200W of power.How much is the voltage and current across the load?

A: Given Data: Power P = 200W Resistance = 50 ohm

Q: Q1) Compute the total power supplied to the following circuit by the battery. 2 A 1A V, Volt

Q: 10. Determine power absorbed by each element in the following circuit. T=6 Amp 17 Amp + 12 Volt 8…

Q: How much power in kW can a machine do with 600 kWh of work in 12 hours?

A: kWh is the units of Energy Energy is the product of power and time. Power expressed in kW and time…

Q: An electric cooker operates at 12A of current when connected to a 240 V supply for 1 hour a day. The…

A: Given An electric cooker operates at 12A of current when connected to a 240 V supply for 1 hour a…

Q: If 420 J of energy are absorbed by a resistor in 19 min, what is the power to the resistor?

A: Power absorbed by the resistor = Energy absorbed in JTime in seconds. 1 min = 60 sec Given , Energy…

Q: What is the current flowing on the 9-ohm resistor if the source voltage is placed at 20 volts? Note:…

A: In this question we will find current flowing in 9 ohm resistor....

Q: 3. A fluorescent lamp unit connected to a 110 v AC line takes 1.2 A and requires 110 w power. What…

A: The solution is given below

Q: refrigerator is operating at 8A of current when connected to a 220 V supply for 2 hour a day. The…

A: Given, Current,I =8A, Voltage, V=220V Time, t=2Hr per day 1 Unit price = 25ba For 30 days, time is…

Q: The expected value of the voltage across a resistor is 80 V, and the measured value is 79 V. What is…

A: Given: Expected value or True value of voltage, VT=80 V Measured value of voltage, Vm=79 V

Q: An electric heater with a resistance of 40 ohms and a current of 5 amperes. What is the voltage? O…

Q: ten electric heaters, each taking 200 watts were used to dry out on site on electric machine which…

A: Given that Power rating of each heater is 200 w Time of usage t= 60hrs V= 240 v Cost C =…

Q: How much energy will be consumed of a 500 W Water Heater runs for 20 hours continuously? If the…

Q: a 12 volts battery has a 50 ampere-hour capacity. The internal resistance is 0.1 ohm. A 15-ohm load…

Q: An electric heater consumes 1.8MJ when connected to a 250 V supply for 30 minutes. Find the power…

A: Energy= Power *time. 1 w-s=1 Joule. Power rating= Voltage*current .

Q: Determine the voltage value in volts on voltage across the resistance of 2 ohms. 1Ω 12Ω 12 Ω 6A Μ 2Ω…

A: In this question we need to find a voltage across 2 ohm resistor.

Q: If an electric heater requires 23 A at 110 V,determinea. The power it dissipates as heat or other…

A: a. To determine the power dissipated by the heater: Power absorbed by the heater can be expressed…

Q: The billing from an electric utility indicates a present reading of 31,450 kWH and a previous…

A: Energymeter is used to measure the energy consumed by the electrical utility. Since it counts the…

Q: A load of 10ohms was connected to a 12V battery. The current drawn was 1.18amperes. What is the…

A: Assume internal resistance of battery 'r' And apply KVL

Q: An appliance draws 1A of current when plugged to a 220V outlet. It was further measured that the…

A: In this question we will find power factor of circuit..

Q: A power station burn 0.5 kg of fuel per kwh. Assume the fuel has an calorific value of 7500…

A: A power station burn 0.5Kg of fuel per Kwh.Assume the fuel has an calorific value of 7500…

Q: A water heater draws 12 Amperes at 240 Volts current supply with a heat resistance of 20 Ohms.…

A: The power consumed by heater (P) is given by: Where, The voltage across heater is “V”, The current…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

An element in an electric heating unit is applied to a 232v power supply. The current flow through the element is 19 amperes. What is the resistance of the elements?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Introduction.

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the calculated load for an electric range rated at 16 kW? (Table 220.55) Show calculations.
A 50-ohm load dissipates 200W of power.How much is the voltage and current across the load?
Calculate the power supplied by the source and the average power absorbed by 2-ohm resistor.
According to the following specifications, a single solar 295-watt solar panel has maximum power operation voltage at 24 volts. What is the maximum number of solar panels that can be used in a single string? a. 35 solar panels. b. 30 solar panels. c. 25 solar panels. d. 40 solar panels. e. 20 solar panels.
The internal energy of water in a container is increased by 330 kJ by means of a device placed in the container. Since the voltage applied to the heater is 110 volts and the total operating time of the heater is 5 minutes, what is the current flowing through the heater in amperes?
A 12 V source is connected across a 10 resistor.(a) How much energy is used in two minutes?(b) If the resistor is disconnected after one minute, is the power during the firstminute greater than, less than, or equal to the power during a two-minute interval?
34 - When an electric motor is running at full speed, the voltage between the ends of the motor is 10 V and the current in the circuit is 2 A. When the movement of the motor is blocked, the voltage is 2 V and the current is 0.5 A. What is the efficiency of the engine? A) 100 B) 20 C) 80 D) 60 E) 40
The values of the circuit elements are given below.What is the average power transferred to resistor R2?R1=200 ohmsC=9 micro FL=0.2HR2=2500 ohms
ten electric heaters, each taking 200 watts were used to dry out on site on electric machine which had been exposed to a water spray. They were used for 60 hours on a 240 V supply at a cost of 5 pesos/kW. Calculate the values of the following quantities involved: a) Current b) Power in kW c) energy in kW d) Cost of energy
Find power in KW taken by DC motor driving a pump to raise 1400 litre of water per minute to height of 30m. The the motor efficiency is 90% and pump efficiency is 75%.
Find the power dissipated by the 45-ohm resistor
Given:Vb = 100 voltsR = 10000 ohmsC = 200 μFAssuming that after a long period of time, the switch is flipped from position "A" to position "B" at t=0. Calculate the voltage across the resistor after 3 TC.