An ideal op-amp circuit is shown above, with dc supply Vcc = -Vcc = 12V. Assume that v1 = 2V, v2 = 2V, R1 = 3Ω, R2 = 3Ω.  Please determine Rf (in ohm's) so that the output voltage vo = -10 volts.

Q: Figure 1Ω ww 350 Ω 40 www v < 1 of 1 Part A Use the node-voltage method to find how much power the…

A:

Q: Explain the prime mover in diesel plant and it's energy conversion

A: Given: Explain the prime mover in diesel plant and it's energy conversion.

Q: Implement the circuit (draw the schematic) using the different implementation methods for the 4…

A: The truth table is given as Here , we need to design ⇒b2 by using 16×1 MUX.⇒b1 by using 8×1 MUX.⇒b0…

Q: Question 2 Open-circuit and short-circuit tests on a 40-KVA, 2400/240-V, 50 Hz transformer gave the…

A:

Q: Compute the reactance of the following a. 5 µF capacitor at 50 Hz b. 5 µF capacitor at 100 rad/sec 5…

A:

Q: 2. Use current division rule to solve for i₁. 4A 个 100.52 m ≥30.52 50.12

A: In this question We need to determine the current i1 in the circuit.  We are solving this problem…

Q: Consider the following circuit. When oscillation is stable, the internal drain-source resistance of…

A:

Q: When making a flowchart what does this symbol stand for? Select one: a. Decision b. None of the…

A:

Q: 1. Calculate the theoretical output DC voltage of the half-wave rectifier circuit and compare it…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: In a 2-pole, 208 V (L-L, rms), 60-Hz motor, Rs = 0.5 Ω, Rr = 0 45 Ω, Xℓs = 0.6 Ω, and Xℓr = 0 83 Ω.…

A: Given data The parameters of three-phase induction motor is given in the problem; P=2 VLine=208V…

Q: A light assembly shop, 15 m long, 9 m wide, and 3 m up to trusses is to be illuminated to a level of…

A: Given a light assembly shop, length= 15 m &amp; width=9 m Utilization factor(UF)=0.9 Maintenance…

Q: Thevenin equivalent circuit. 1. Find VTH 2. Find RTH using the short circuit current. b. 89 1 4A 3i,…

A:

Q: consider a transmission line with zl=3.346+j77.299 ohm assume that sb=100mva and vb=735kv find the…

A: In this question we need to find the per unit impedance convert the impedance using a new base of…

Q: Find the current through the diode in mA.

A:

Q: Please help me solve the activity below. Please provide a CLEAR and READABLE solution. Thanks in…

A: We have calculated the t.f as follow

Q: 11 The intrinsic impedance of a medium is given by impedance in free space is: Hint: -8.854x10 and…

A: Given: μ0=4π×107H/m ∈0=8.854×10-12 η=μ∈Ω

Q: Find the SSE for a unit step and unit ramp functions of the following

A: Given: A control system,  To find: Steady state error for unit step and unit ramp functions.

Q: (a) Give the vector in cartesian coordinates that extends from P(p = 4, p = 10°, z = 1) to Q(p=7,0 =…

A:

Q: The critical frequency at a particular time is 12.5 MHz. What is the optimum working frequency for a…

A:

Q: Problem 1: Write the node voltage equations to solve for v1, v2, and v3. Your equations should only…

A:

Q: Consider the two systems S₁(z[n]) = z[-n¹01] and S₂(x[n]) = cos(zn-3²]) el/zin) 0 T S₁ S₂ I[n] #0…

A: Given: S1xn=x-n101 S2xn=cosxn-32e1xnxn≠00xn=0

Q: 2- Assuming that addition/subtraction cost 40ns and shift 3ns, compute the cost of the…

A: Given: Assuming that addition/subtraction costs 40ns and shift 3ns, compute the cost of the…

Q: 2 ohm ww ohm 3 ohm ? Calculate the total current in the circuit www 4 ohm www 5 ohm ww 120 V 20 AO…

A: In this question we need to choose a correct option

Q: For the circuit shown the value of 13 would For the circuit shown the value of 13 would be: 12 A R1…

A:

Q: Draw the diagram and truth table of the following gates using diodes a) 3 input AND gate b) 2 input…

A:

Q: "In a biased positive parallel limiter with an input of 10Vp-p and a +2V DC battery, the…

A: To determine the highest/positive peak amplitude of the output waveform in a biased positive…

Q: 3. Convert this decimal code to binary then to hex and then to ASCII 68 117 110 110 32 105 115 32 70…

A: Convert each decimal number to binary manually: 68 = 01000100 117 = 01110101 110 = 01101110 110 =…

Q: 9) 150 V a) V-21.5V b) V-75V Ⓒ%-58.88V d) V-73.21V e) None of the above 40 w a) 1-9.28A b) 1-12.74A…

A:

Q: A capacitor of 8µF takes a current of 1A when the alternating voltage applied across it is 230V.…

A:

Q: A uniform surface charge density of 20 nC/m² is present on the spherical surface r=0.6 cm in free…

A:

Q: The critical frequency at a particular time is 12.5 MHz. What is the optimum working frequency for a…

A: Given: Critical frequency, fc=12.5 MHz Angle of incidence,i=650   We need to find the optimum…

Q: + 12V t=0 1000002 зн бл 32

A:

Q: Find the output y(n) given the difference equation and input signal. Difference equation: y(n) =…

A: Given: Difference equation,  y[n]=2x[n]+3x[n-1]-x[n-2]+y[n-1], Input signal,  x[n]=[1, 2, 4, -1, 5,…

Q: 58 (t) dt

A: Given data, Function is given as, ∫-∞-3δtdt=

Q: In IoT systems, actuators are responsible for transforming electrical impulses into a tangible…

A: Yes, that's correct! Actuators are an essential component of IoT (Internet of Things) systems, and…

Q: find transfer function Passive filter row Low Pass filter Highpass filter Band pass filter @ Band…

A: Filter Circuit: To eliminate the unwanted signals from the input signal, we use filter circuits.…

Q: Problem 1 0²4 Oz² Prove that = Yetjkz is a phasor solution of the wave equation +k²=0 by direct…

A:

Q: J U Calculate the absolute value of the voltage U and it's angle in the AC circuit shown above. Give…

A: Since you uploaded multiple question as per guidelines we solve the 1st question for solution of…

Q: find transfer function Passive filter Low Pass filter Highfass filter d volus Band pass filter Band…

A: Need to find transfer function Passive filter a. Low Pass filter b.Highpass filter c. Band pass…

Q: A 15 kW,230 V, short-shunt generator was run light as a motor to determine rotational losses at…

A:

Q: Which of the following is NOT a characteristic of a digital signal? a. Continuous b. Discrete c.…

A: The characteristics of a digital signal are:  1) Quantised in amplitude 2) Discrete in time  3)…

Q: What are the conditions for oscillation?

A: oscillation refers to the oscillations of electrical quantities such as voltage, current, or charge.…

Q: Isn't part c here missing the 50 ohm resistor?

A: No, The solution provided is correct

Q: a certain battery with potential difference of 2 volts can deliver 10 joules of energy, determine…

A: Given: battery with a potential difference = 2 volts Energy = 10 joules  Need to calculate the…

Q: 13. A temperature control system has a set point of 20°C and the measured value is 18°C. What is (a)…

A: Since you have asked multiple questions, we will provide the solution only to the first mentioned…

Q: 4.27 Design an op-amp circuit that performs an averaging operation of five inputs v₁ to v5.

A: The required circuit can be designed with the help of summing amplifier and the averaging function…

Q: Problem 3. Give an example of the product of two numbers (in 2's complements) to show that an…

A: Multiply -6 and -5 in 4-bit 2's complement notation. The binary representation of -6 in 4-bit 2's…

Q: 3. (. ) Using source transformation, replace the circuit below with a practical current source at…

A:

Q: A 400V, 3 –phase, 4 wire, star –connected system supplies three resistive loads of 18kW, 21kW and…

A:

Q: Please solve 1. For the timer circuit above, the period of the square output wave measured at pin…

A: In the given circuit IEEE 555 timer is configured to work in astable mode. VCC = 10 v R1=18×103 ohms…

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.