An inductor coil with an inductance of 0.5 H and negligible resistance is connected across the terminals of a 230 V, 60 Hz supply. Determine the current in amperes taken by the inductor coil. What power in watts is taken by this inductor coil if the current lags the

Q: A single-phase transformer, with primary turns of 500, is delivering full-load of 80 kW at a lagging…

A: As per our guidelines when student asks multiple subpart questions , we have to answer only first…

Q: An aircraft has a wing span of 56 m. It is flying horizontally at a speed of 810 km/hr and the…

A: We have an aircraft with, Wing span (l) = 56 m earth magnetic field (B) = 4 * 10-4 Wb/m2 Speed (N) =…

Q: B. Find, graphically, y(t) = f(t) * h(t) where h(t) = 8(t)- 8(t-1) and f(t) is the signal shown J…

A:

Q: Question 17 The BCD equivalent of decimal 109 is 0001 0000 1001BCD 0001 0000 1101BCD 1110 1110…

A: Given: The decimal number is 10910.

Q: Two inductors of 5 H and 4 H have a mutual inductance of 2.5 H between them. The coupling…

A:

Q: The open loop DC gain of a unity negative feedback system with closed-loop transfer s+4 function is…

A:

Q: An information signal of 3cos(2m10¹t) is given to 3 bit PCM system. Sampling rate is twice of the…

A: Given data: Message signal expression, 3cos(2πm104t) number of encoder bits used per sample, n = 3…

Q: 4 Find the F.T. of the following Signals using differentiation prop. Ans FCW) - 2A (cosaw - Cosbu -…

A: We have to calculate fourier transform of following signal using differentiation property : we…

Q: Problem 10 The core of the magnetic circuit of Fig. (a) is made of steel whose B-H characteristic is…

A:

Q: 10. A 47 resistor and a capacitor with a capacitive reactance of 120 are in series across an ac…

A: SOLUTION GIVEN-->           LET                   RESISTOR = R ohm…

Q: Determine the product of (1 + i) and (1-3i) (A) 4-2i B) 2-2i C) 2-4i (D) 2+4i

A: Given: To determine the product of 1+i and 1-3i.

Q: d. Calculate the rise time (T.). e) Based on the value of damping ratio (C) the system is a)…

A: For the given question I have to solve part 'd' and 'e' : Transfer function of the control system…

Q: A shunt generator has a full load current of 196 amp. at 220 V. The stray losses are 720 watts and…

A:

Q: Discussion of power quality aspects that need to be considered before installing the power factor…

A: power factor correction aims to improve power factor and therefore power quality. It reduces the…

Q: Implement the Boolean function F (x, y, z)=Σ(0, 1, 3, 5, 6, 7) with NAND gates, and draw the logic…

A: it is given that: F (x, y, z)=Σ(0, 1, 3, 5, 6, 7)

Q: Find E* (s) for each of the following functions. Express E*(s) in closed form. ε-47's (a) e(t) = at…

A:

Q: 72. In 132 kV system, the phase to ground capacitance is 0.01 µF and inductance is 6H. The voltage…

A:

Q: What Is setup time?

A: Setup: Particularly UPR and forceful body carriage. b: characteristics, make-up. The preparation…

Q: 2.a. Find the total resistance between 'a' and 'b' for the circuit given below. 20 Ω www 162 a Rab…

A: Given:

Q: Sampling at time t = 0, 4, 2x4, 3x4 using ZOH. What's the output at 2.5 seconds? The signal is t^2…

A: Given:  Signal f(t)=t^2 The signal is to be sampled using ZOH method at time instants t=0,4,8,12 We…

Q: 16V (+) 4Ω 8Η 31 ἰχ The circuit above is in DC steady state. What is the value of it in amps? ΖΩ

A: Given data, Circuit diagram is given as,

Q: In a current divider, resistors are connected Select one: O a. In a star configuration O b. In…

A: Current division rule is applied when all the resistance are connected on parallel and voltage…

Q: Q3:-Using superposition, determine the current through the (6 ) resistor for network of Fig.2.…

A: It is given that:

Q: hybrid parameter his (a) (c) O + V₁ ww R₁ (aR3 + R₂) R₂ + R₂ (1-α) R₂ R₂ + R3 ww network as shown.…

A:

Q: For the waveform shown below, find Vrms v(1) 2 6 8 2.

A: Considering the waveform. Time period (T) = 4 vt=t             0≤t≤2-1         2≤t≤4

Q: Consider the following section of a multiloop circuit, with current directions as indicated: zero…

A: Given, The circuit is,

Q: 1A ww 3Ω 8F: + - The circuit above is in DC steady state. What is the value of vein volts? VC 5Ω ww

A: Given data, Circuit diagram is given as,

Q: Low power factor has some adverse impact on both the transmission line and on the consumer…

A: “Low power factor has some adverse impact on both the transmission line and on the consumer…

Q: VT VR3 = R3 R₁ + R₂ + R3 st -VT VRI R₁ VR2 R₂ W-W VR3 R3

A: Given circuit: To prove: Voltage across resistor R3 is VR3=R3R1+R2+R3VT.

Q: A 500 kVA, 6.6 kV star connected alternator has a synchronous reactance of 1.0 2 per phase and…

A:

Q: The following data were obtained on a 20 kVA, 50 Hz, 2000/200 V Transformer: SCT: 60 V, 10 A, 300 W.…

A: Given  20kVA, 50Hz, 2000/200 V transformer SCT details: 60V, 10A, 300W Series reactance referred to…

Q: What substance acts as the moderator in a pressurized water generator?

A: Pressurized Water Generator:- The water in the core is heated by nuclear fission and then pumped…

Q: Bandwidth is the:  A) a measure of the width of a range of frequencies B) the rate of data transfer…

A: In filter circuit   it allows only certain range of frequency . The range of frequency is called…

Q: element is connected across an AC signal. CH1 and CH2 measures the

A:

Q: 4. The circuit shown in Fig. 2.9-4 is known to contain only resistors and independent sources. (i)…

A:

Q: What are the advantages of using a PLC-based system over a relay-based system? O There are no real…

A:

Q: (2) Convert the following voltage sources, which are shown in the following circuits, into…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: What kind of cable uses BNC connectors?

A: A cable is a bundle of wires, which is used to deliver electricity or carry the flow of electrons.…

Q: 3. Find Vx if the power supplied by the 5A current source is 50W.

A: It is given that: P5A=50 W

Q: Find the inverse transforms 100 F₁(0) = jo 100 F₂(0) = F3(0) = 500 (jo+100) (jo+500) 500 jo…

A:

Q: Two signals mi(t) and m₂(t) both band limited to 5 KHz are to be transmitted simultaneously over a…

A: Given: A modulation circuit diagram with two different signals m1 and m2 and two different carriers.…

Q: 5- Sampling theory 6- Nyquist rate 7- PAM 4-Pulse Code Modulation

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Sol Axit A y(t) = x(t)h(t). = x(t) @ [s(t) = S(t+1)] - = X(t) Sit) - X(t) @ S(t+1) = X(t) = x (t+1)…

A: Given: Solution of a question. To do: We have to just explain last step.

Q: The SCR of Fig. 20.25 has gate trigger voltage V₁ = 0.7V, gate trigger current = 7 mA and holding…

A: We have an SCR circuit as shown in figure, with, gate trigger Voltage VT = 0.7 V Gate trigger…

Q: 2. The short-circuit secondary current in a transformer is 2 A. What is the primary current if the…

A: Given, A transformer has, Short circuit secondary current I2=2 A. Transformer turns ratio a=25.

Q: 16V +1 www 4Ω 8H ₁₁ The circuit above is in DC steady state. What is the value of it in amps? www…

A:

Q: The strain gauge with a resistance of 250 ohm undergoes a change of 0.15 ohm. During a test the…

A: Given a strain gauge with, Resistance, R=250 Ω. Change in resistance, ∆R=0.15 Ω. Strain,…

Q: A 50 MVA, 11 kV three-phase alternator was subjected to different types of faults. The fault…

A: We have been given an 3-phase 50 MVA alternator which was subjected to different types of fault.…

Q: What is the voltage drop across the 2Ω resistor? 10 Ω 122 V Select one: a. Ο • b. 12 c. 18 d. 22 e.…

A: Given, The circuit is,

Q: Calculate the values of i2, 13, V2, V3,Vc and v₁ in the network shown in Fig. at the following times…

A: We have been given an network as shown in figure, We need to determine the value of, i2 , i3 , V2 ,…