An industrial tank is discharging a fluid through a 5-inches nozzle with a velocity of 5 meters per second. At the same time, receiving a fluid at a rate of 265 US Gal per minute. At a certain point, the tank is considered to be quarter full . Find the (a) water level and the (b) mass change in the tank 15 minutes later. Given: tank diameter = 10 ft tank height = 20 ft

An industrial tank is discharging a fluid through a 5-inches nozzle with a velocity of 5 meters per second. At the same time, receiving a fluid at a rate of 265 US Gal per minute. At a certain point, the tank is considered to be quarter full . Find the (a) water level and the (b) mass change in the tank 15 minutes later. Given: tank diameter = 10 ft tank height = 20 ft

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter10: Force And Force-related Variables In Engineering

Section: Chapter Questions

Problem 18P: Using the information given in Table 10.4, determine the ratio of local pressure and density to...

See similar textbooks

Similar questions

Using the information given in Table 10.4, determine the ratio of local pressure and density to sea-level values. Estimate the value of air density at the cruising altitude of most commercial airliners. Altitude (m) sealevel PPsealevel 0 (sea level) 1000 3000 5000 8000 10,000 12,000 14,000 15,000
SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the pressure required to decrease the volume of the oil by 2%?
The diameter of a pipe carrying water changes gradually from 6 inches at a lower point to 18 inches at a higher point by 15 ft. What will be the difference in pressure, in psi, between these points if 6.2 cfs is flowing considering no loss in energy.
. A Pitot tube in the pipe in which air s flowing is connected to a manometer containingwater as shown in the figure. If the difference in water levels in the manometer is 87.5mm,what is the velocity of the flow in the pipe, assuming a tube coefficient, CP = 0.99?
An open cylindrical tank 800mm in diameter and 2000mm high contains water to a depth of 1.6m. It is rotated about its vertical axis at 13 rad/s. How many liters of water are spilled? Use density of water as 1000kg/m3 and specific weight as 9.81kN/m3
Calculate the capillary effect in millimeters in a glass tube of 4mm diameter, when immersed in Water Mercury the temperature of the liquid is 200C in contact with air are 0.073575 N/m and 0.51 N/m respectively. The angle of contact for water is zero and that for mercury is 1300. Take density of water at 200C as equal to 998 kg/m3. Explain the ways of describing the fluid motion
Water flows through a pipe 25 mm in diameter at a velocity of 6 m/s. Determine whether the flow will be laminar or turbulent assuming that the dynamic viscosity of water is taken as1.30 × 10−3 kg/ms and its mass density as 1000 kg/m3. If oil of specific gravity 0.9 and dynamic viscosity 9.6 × 10−2 kg/ms is pumped through the same pipe, what type of flow will occur?