An RLC circuit has a resistance of (2.66x10^2) S2, an inductance of (1.93x10^1) mH, and a capacitance of (3.2x10^1) nF. At time t = 0 the charge on the capacitor is (1.800x10^1) µC and there is no current flowing. What is the energy stored in the capacitor after two complete cycles? Express your result in nJ with two significant figures. Note: Your answer is assumed to be reduced to the highest power possible. Your Answer:

An RLC circuit has a resistance of (2.66x10^2) S2, an inductance of (1.93x10^1) mH, and a capacitance of (3.2x10^1) nF. At time t = 0 the charge on the capacitor is (1.800x10^1) µC and there is no current flowing. What is the energy stored in the capacitor after two complete cycles? Express your result in nJ with two significant figures. Note: Your answer is assumed to be reduced to the highest power possible. Your Answer:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The resistance, inductance, and capacitance in a parallel RLC circuit in (Figure 1) are 0.4 kΩ, 5 H, and 5 μF, respectively.Calculate the minimum root of the characteristic equation that describes the voltage response of the circuitCalculate the maximum root of the characteristic equation that describes the voltage response of the circuit.
A 10μ F capacitor is connected in series with a 0.7 MΩresistor across a 200 V d.c. supply. If the p.d. across the capacitor continued increasing at the initial rate, it would be represented by OA, the tangent drawn to the initial part of the curve. If T is the time constant in seconds, namely the time required for the p.d. across C to increase from zero to its ﬁnal value if it continued increasing at its initial rate. This result is really obvious from the fact that at the instant of switching on there is no charge on C and therefore no p.d. across it. Consequently the whole of the applied voltage must momentarily be absorbed by R. (a) Find the time constant and the initial charging current. (b) Calculate the time taken for the p.d. across the capacitor to grow to 150 V.…
A series circuit has a capacitor of 1.5625x10^(-8)F a resistor of 2x10^4 ohms, and an inductor of 1H. If the initial charge on the capacitor is zero,. if a 12-volt battery is connected to the circuit and the circuit is closed at t=0, determine the charge on the capacitor at any time t
An RC circuit has an emf of 5 V, a resistance of 10 ohms, a capacitance of 10 – 2 F, and initially a charge of 5 C on the capacitor. Find an expression for the charge on the capacitor at any time t. Ans.: q = (1/20)[ 1 + 99e – 10t] coulombs
Suppose the input to the circuit is a damped ramp of the form Kte−100t V. Find the largest value of K such that the inductor current does not exceed the 40 mA current rating
All capacitors were initially discharged.at t = 0, S1 is placed at position 1 and S2 is closed.At t = 15 ms, S1 is placed at position 2 and S2 is kept closed. At t = 25 ms, S1 is kept at position 2 and S2 is opened.after 25 ms, the voltage vT will Question options: increase until it reaches the battery voltage at steady state exponentially decay to zero stay constant be a sine wave
The initial voltage across the capacitor at t = 0 in the circuit shown is 2V. Voltage Vs is applied at t = 0; that is, Vs = 10 u(t) V. Find voltage v(t), t >= 0, across the capacitor.
Can somebody explain why the inductors are open circuit and the capacitor is short circuited. Given that: The presence of a voltage source indicates an infinite size, which may be stated in the circuit as Vs(t)= δ(t).
A capacitor in an RC circuit was allowed to discharge through a resistor. How long will it take to reduce the charge in capacitor to 50% of its original value? Express your answer in terms of time constant.
An RL circuit has an emf given (in volts) by 4 cos t, a resistance of 100 ohms, an inductance of 4 henries, and no initial current. Find the time when the current is 2 A for the first time.
In a source free RL circuit containing an inductor initially charged to a current lo, how many time constants are considered practically sufficient for this inductor to be completely discharge!
* If the current through a 5 mH inductor is increasing at 3 A/s, what is the voltage across the inductor? * The current in an 8 µH inductor is given by i(t) = 3t + 2 A. What is the value of the inductors voltage at t = 2 s.