An RLC series circuit has R = 2 ohms, L= 20 mH, and a variable capacitance C as shown below. The voltage source supplying the circuit has an output voltage of 120 Vrms at a frequency of 400 Hz. The capacitance is varied till the capacitor voltage magnitude equals the inductor voltage magnitude. Under this condition, the value of the capacitance C is.micro 四*Farad C L=20 mH I R=2 0 Vo V, 120 20 V, 420

An RLC series circuit has R = 2 ohms, L= 20 mH, and a variable capacitance C as shown below. The voltage source supplying the circuit has an output voltage of 120 Vrms at a frequency of 400 Hz. The capacitance is varied till the capacitor voltage magnitude equals the inductor voltage magnitude. Under this condition, the value of the capacitance C is.micro 四*Farad C L=20 mH I R=2 0 Vo V, 120 20 V, 420

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A resistance R, capacitance C, and inductance L are connected in series to a voltage source with amplitude V and variable angular frequency v. If w = w0 , the resonance angular frequency, find (a) the maximum current in the resistor; (b) the maximum voltage across the capacitor; (c) the maximum voltage across the inductor; (d) the maximum energy stored in the capacitor; (e) the maximum energy stored in the inductor. Give your answers in terms of R, C, L, and V.
A LC circuit in a radio tuned to 1080 kHz has an inductor with an inductance value of 60 μH and a resistance of 0.25 Ω. a. what is the capacitance of the LC circuit? b. sketch the impedance phasor diagram for the radio. Be sure to label important features of the diagram.
An RLC circuit connected in series has a resistance of 5 ohms, an inductance of0.05 henry, a capacitor of 4 x 10-4farad, and an applied alternating emf of200cos100t volts. Find an expression for the current flowing through this circuit ifthe initial current and initial charge of the capacitor are both zero.
A series RLC circuit has an inductor that has a value 500 mH, the capacitor 25 µF, and the resistor has a value of 400 Ω. They are connected to an ac power supply functioning at frequency 60 Hz. The peak current is 450 mA a) Find Vmax b) Find the angle by which the current leads, or lags, the voltage. Using your result is it leading or lagging? c) How much power is the circuit dissipating on average?
A 200 Ω resistor, 0.900 H inductor, and 6.00 µF capacitor are connected in series across a voltage source that has voltage amplitude 30.0 V and an angular frequency of 250 rad/s. (a) What are v, vR, vL, and vC at t = 20.0 ms? Compare vR + vL + vC to v at this instant. (b) What are VR, VL, and VC? Compare V to VR + VL + VC. Explain why these two quantities are not equal.
Given a series RC circuit that has a resistance of 12MΩ and a capacitance of 47µF, and attached to a 24VDC source, what will the voltage drop across the capacitor be when 5 time constants have passed by? _______
For the circuit shown below: A. Draw a phasor diagram(use graph paper / engineering paper) to determine RL, XL and XC. B. What is the quality, QL, of the inductor? C. Write an expression for C in terms of XC and source frequency in Hertz, f. Please try in typing format please ASAP
A parallel RLC circuit containing a resistance of 1kΩ, an inductance of 142mH and a capacitor of 160uF are connected in series across a 240Vrms, 60Hz supply a. Calculate the impedance of the parallel RLC circuit (Z), and the current drawn from the supply (Is)
Consider the RLC circuit above. Assume vs=0 V before t = 0, and then vs=2 V when t > 0. L = 100 mH, C = 6.8 nF. Assume R = 1 kΩ, find the final (steady-state) current through the inductance and voltage across the capacitance, respectively.
I'm working on a circuit design problem where I need to find the values for an RLC circuit that, when placed in parallel with a 100 Ohm resistor, results in an admittance of 28.627 /_ -31.900 mS at 100 Hz. I've successfully calculated the resistance (R = 33 Ohm) and inductance (L = 55 mH), which are correct, but am having trouble with the capacitance C. My attempts to calculate C using the capacitive reactance Xc consistently lead me to 0.02 mF, which isn't accepted as correct. The impedance I've calculated for the RLC network is Z_RLC = 33 + j34.9 Ohm. Could you help me verify the Xc calculation and find the correct value for C in mF? Thank you!
An RLC circuit consists of a 150-Ω resistor, a 21.0-μF capacitor, and a 460-mH inductor connected in series with a 120-V, 60.0-Hz power supply. (a) What is the phase angle between the current and the applied voltage? (b) Which reaches its maximum earlier, the current or the voltage?
A 20µF capacitor has a sinusoidal voltage across it given by?(?) = 5 sin(500? + 45°) V.(a) Find the phasor representation of the voltage in polar (magnitude and phase) form.(b) Find the phasor representation of the voltage in Cartesian (real and imaginary part) form.(c) Find the phasor representation of the current through the capacitor. (d) If this same voltage appeared across the terminals of a 100mH inductor, what would be thephasor representation of the inductor current?