Answered: Analyze the quality of water and design…

Engineering

Civil Engineering

Analyze the quality of water and design the treatment units required to meet BIS guidelines.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter8: Seepage

Section: Chapter Questions

Problem 8.6P

See similar textbooks

Related questions

Q: b) Define the constituents of wastewater and its relation to the contaminants, impurities and…

A: Solutions: The used water ejected out from industrial, commercial, and domestic facilities is known…

Q: Discuss the relationship between removal efficiency and the cost of water treatment for the four…

A: As the removal efficiency increases in the water, the cost of water treatment also increases because…

Q: OD, COD, and ultimate BOD of a wastewater containing

Q: Explore the extent to which wastewater is being used informally in households and industries.

A: Wastewater is converted into drinking water. Sewage, leftover food, lubricants, detergents, and…

Q: Disinfection, sedimentation, flocculation, coagulation, and filtration are processes for a surface…

A: Coagulation is defined as a water treatment process in which chemicals which are known as coagulants…

Q: 26. An Extended Aeration treatment plant consists of an aeration compartment with a volume of 1320…

A: Calculate the F/M ratio and the volumetric loading.?

Q: (a) Discuss in details and with suitable examples about the sources of the wastewater that need to…

A: As per our guidelines we are supposed to answer only one question. Please repost other questions as…

Q: •Given the following information for wastewater plant, the plant is an activated sludge system with…

A: Answer Flow rate Q = 60000 m3/d Volume of Aeration tank = 7500 m3 Efficiency of aeration tank = 85%…

Q: (b) Fat, oil and grease from restaurants have been identified as a significant blockage in the…

Q: A two-pond system shown in the attached picture is fed by a stream with a flow rate of 1.0 million…

A: Determine the initial concentration of pollutant;

Q: The average design flow at a wastewater treatment plant facility is 1.5 m3/s. The bar rack is…

A: Design Flow = 1.5 m3/s Clear spacing between bars of bar rack = 2.5 cm

Q: BOD and COD are wastewater quality parameters listed in the regulation for sewage discharge…

A: THE ABOVE QUESTION IS RELATED TO THE ENVIRONMENTAL ENGINEERING. IN THE QUESTION BOD& COD…

Q: Develop actions that can be taken to improve water quality or prevent its deterioration in the…

A: Their are several ways through which water quality parameter can be affected in distribution . The…

Q: A thorough description of the different AOP techniques available for wastewater treatment, including…

Q: A 8.5 ml of sample of wastewater is diluted to 300 ml with distilled water in standard biochemical…

Q: Distinguish the different role of primary and secondary treatment of wastewater.

A: The treatment of wastewater is an important process that is required to be performed before the…

Q: At the point of mixing of a river and a wastewater point discharge, DO is 5.5 mg/L and DOs is 10.1…

A: It is required to find critical deficit of DO and minimum DO. Critical time of DO deficit and…

Q: Problem: 1. Design a facultative pond to treat (10650)gpm of sewage having (10650/20)mg/L of BOD.…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Distinguish the domestic and industrial wastewater

A: Domestic waste water: Domestic waste water is that which is discharged from residential or…

Q: Design a two-compartments septic tank to serve a household of twelve persons having the water…

A: It is required to determine the detention time of sedimentation tank. th=1.5-0.3logp×q Here p is the…

Q: Briefly stated, what is the principal purpose (i.e., treatment objective) of the following steps…

A: Preliminary treatment • It involves removal of inorganic particles such as glass pieces, sand…

Q: Sketch with labels the flow of treatment processes for surface water from the intake to the…

Q: Draw a flow diagram depicting the relationship/s between the various components of suspended and…

A: here we need to classify total dissolve solids and total suspended solids. volatile solids: The…

Q: A city with an expected increase in its future population is to provide a complete water treatment…

A: The water treatment plant for surface water source are a rapid mix, flocculation, sedimentation,…

Q: Determine the diameter of a trickling filter for a wastewater flowing at the rate of (13500/100)…

A: Wastewater flowing at the rate of (Q = 13500/100) gallons per minute. Concentration for the…

Q: A wastewater treatment plant treats a wastewater at a flowrate of 10 million liters per day. The…

Q: A wastewater sample of 100 ml was filtered through the filter paper and the filtered water was…

A: Suspended Solids=Weight of residueVolumeWeight of residue=7.76-0.1=7.66gmsSuspended…

Q: Problem: 1. Design a facultative pond to treat (13500)gpm of sewage having (13500/20)mg/L of BOD.…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: sewage treatment plant contains fourteen standard rate tricking filters with diameter 37.8m ilters,…

Q: What is the difference between DO and BOD? Clearly explain why these 2 parameters are used in water…

A: Dissolved Oxygen (DO): It is the amount of oxygen which is dissolved in water. The solubility of…

Q: It was decided to design wastewater collection system for the same area in Figure 1. If you know…

A: The expression for number of people is given as Number of people=Number of villa× Number of person…

Q: A wastewater treatment plant (WWTP) discharges its effluent in a river. The regulatory agency wishes…

A: DO after mixing can be calculated as DOmix=DOeffluent × Qeffluent + DOriver × QriverQeffluent +…

Q: identify drinking water standards, Overview of typical processes used for contaminant removal,…

A: The quality characteristics defined for drinkable water are referred to as drinking water quality…

Q: A wastewater treatment plant treats a wastewater at a flowrate of 10 million liters per day. The…

Q: Two communities, A and B, are found on two opposite sides of flowing river with a 9.10 m3 /s rate of…

A: BOD: BOD means biochemical oxygen demand. It is defined as the amount of dissolved oxygen that is…

Q: List down in correct chronological order the necessary water treatment plan processes. Define the…

A: STEPS ARE (1) Collection (2) Screening and Straining (3) Chemical Addition (4) Coagulation and…

Q: b.) Estimate the peak runoff flow rate observed in the combined sewer system in cfs generated only…

A: If we draw a line parallel to x-axis from the peak of the graph, the the line will intersect the…

Q: A wastewater treatment lagoon is being designed to accommodate an input flow of 0.1m^3/s containing…

A: Given data: The input flowrate is 0.1 m3/s. The concentration of input effluent is 25.0 mg/L. The…

Q: B- State and briefly explain the factors that influence the characteristics of the wastewater.

A: The characteristics of wastewater is classified into 3 categories: 1. Physical 2. Chemical 3.…

Q: Design a water treatment plant for a town with a 2020 population of 25000 persons, average…

Q: Please calculate the ThOD, COD, and ultimate BOD

Q: What is the purpose of secondary wastewater treatment? a. To reduce toxic chemicals and heavy…

A: Purpose of secondry waste water treatment.

Q: If a manufacturing facility generates raw wastewater that is predominantly composed of dissolved and…

Q: It is desired to design an activated sludge process to treat 20,000 m3/d of settled wastewater with…

A: Solution-

Q: A water source has a flow of 10 MGD, alkalinity of 275 mg/L in CaCO3, and a pH of 8.85. What will…

Q: A livestock and crop farmer uses some acidic wastewater to irrigate his soil before growing crops as…

A: Irrigation Farming: Irrigation farming is the practice of growing agricultural crops with the help…

Q: The average domestic wastewater flow is 108 gallon per capita per day (gpcpd), containing TSS…

A: Given-The average domestic wastewater flow= 108 gallon per capita per day.Tss concentration in waste…

Concept explainers

Total Energy Consumption

The term energy consumption signifies the consumption of electricity. Energy consumption as electricity is a primary demand for households, factories, industries, complexes, and commercial places. According to a report, the total U.S. energy consumption for 2018 was 101 BTU (British Thermal Units). It accounted for 17% of the total energy consumption of the world. The total energy demand for the U.S. as oil equivalent was estimated to be about 6804 kg of oil equivalent.

Question

Analyze the quality of water and design the treatment units required to meet BIS guidelines.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The infiltration capacity of a catchment is represented by Horton’s equation as f= 0.5+ 1.2e^-0.5t where f is in cm/hr and t is in hours. Assuming the infiltration to take place at capacity rates in a storm of 4 hours duration, estimate the average rate of infiltration for the duration of the storm.
Choose the typical range of values for the storage coefficient of confined aquifers a) 1-100 b) 0.1-0.3 c) 10 ^ - 12 - 10 ^ - 8 d) 10 ^ - 6 - 10 ^ - 3
Problem 5: Design a aerated grit chamber for a wastewater treatment plant where the incoming average flow rate is 0.8m3/s. Assume • a peak factor of 2.5. • Detention time = 225 sec • Width to Depth ratio = 1.5:1 • Width = 3 m • Aeration requirement is 0.3 m3/min/m • Sludge generation 40L/103 m3
What is the ultimate BOD 24 km downstream from the outfall? > Answer: 3.89 g/m3 What is the DO deficit 24 km downstream of the effluent discharge? > Answer: 3.192 g/m3 Question: At the location 15 km downstream of the effluent discharge, how much oxygen would have to be added to have the do at 7 mg/l?
A wastewater treatment plant will receive a flow of 30,000 m3/day. The plant has a 3.6 m deep circular primary clarifier with a surface overflow rate of 60.0 m3/m2-day.a. Calculate the surface area (m2), diameter (m), volume (m3), and hydraulic retention time of the primary clarifier.b. How long will it take a 1.0 mm particle with a density of 1500 kg/m3to settle in the primary clarifier? show all work
The infiltration capacity in a basin is represented by Horton’s equation as fp = 4.0 + e-3.5t Where fp is in cm/h and t is in hours. Assuming the infiltration to take place at capacity rate in a storm of 120 minutes duration, estimate the total depth of infiltration during the storm.
b. Determine the spacing of pipe drain from following data. Annual rainfall = 1000mm Drainage coefficient = 1% to be drained in 24 hrs Depth of impervious layer from land surface = 10m Depth of highest position of water table below the land surface = 1.5m Depth of drain below land surface = 2.0m Permeability of soil = 10-4 m/s
Oil (SG = 0.89), with a kinematic viscosity of 0.007 ft2/s, flows in a 3-in.-diameter pipe at 0.049 ft3/s. Determine the head loss per unit length of this flow.
Explanation of a method for improving reservoir permeability
A catchment has a size of 100 km2 . In its original condition, the average annual total runoff from the catchment is 1.0m3/s . The average annual rainfall is 800 mm/a . In an average year, 50% of the rainfall infiltrates and only 10% of the rainfall reaches the groundwater . Capillary rise is negligble. a . How much is the evapotranspiration in an average year(neglect the effect of storage)? b . How much water seeps out from the groundwater to the surface water in an average year if you assume that over a year there is no change in storage in the groundwater? c .How much water in mm/s,is used by the vegetation(evaporation from bare soil can be neglected)?
Draw DO Sag curves (2) for high BOD and low BOD effluent input for the same river and under same conditions. Also list 4 parameters that influence Oxygen sag curve. What is the best way to make sure that there is adequate DO in a river where treated wastewater is released.
What measures should be considered if the water abstraction in the aquifer exceeds the permanent discharge? Kindly not provide the Plagiarized answer