AO- Ba CONVERT Lie CHT AN PARALLEL EQU R1=1552 16 m Xc=602 R₂=102 весого то CHT 3XL=3022

Q: An office space measures 50ft x 90ft with 16ft high walls. A 1.25 air changes per hours is desired…

A: length×Width = 50ft x 90ft,Height = 16 ft,Air changes = 1.25,Indoor temperature = 70 °F,Outdoor…

Q: a. Assuming it's an ideal op amp, derive the circuit’s transfer function as a function of frequency,…

A: According to the question, for the circuit given below We need to find, a. Assuming it's an ideal…

Q: 3 mA 10 ΚΩ

A: Circuit diagram is given as,

Q: For the circuit of Figure 2, identify the correct general expression for vo(t) for t≥ 0+. a) vo(t) =…

A:

Q: Consider an LTI system depicted in figure below with the input sequence x[n] = (-0.5)" µ[n]. find…

A:

Q: Obtain the Thevenin's Equivalent Circuit of the given network between the terminals a-b. What may be…

A:

Q: For the network in the figure, find the complex power absorbed by each element. Take Vs = 84-20° V…

A:

Q: The single-line diagram of a three-phase power system is shown in below Figure. Equipment ratings…

A: Given base parameters for zone 1-2 MVAb = 1000 MVA KVb =500 kV  in the zone of line 1-2.   Here, it…

Q: Show with a diagram that FM and PM are equivalent and interchangeable. Briefly explain why the…

A: According to the question we need to show with a diagram that FM and PM are equivalent and…

Q: The neutral base width of a bipolar transistor, biased in the active region, is 0.5 μm. The maximum…

A: The neutral base width of the bipolar transistor is 0.5 μm. Maximum electron concentration is n=1014…

Q: convert Vbc(t) to cosine

A: It is given that: Zload=45∠37° ΩZline=0.01+j3 ΩVbct=295sinωt-105° V

Q: V. R₁-50KQ R:-10KQ The voltage gain of the above amplifier is:

A: Circuit diagram is given as:

Q: For a 10 KVA, 385/110 V, 60 Hz transformer, the components are given as shown below: Rp = 802, Xp =…

A:

Q: 4. Determine Vo using superposition theorem. 322 M + Vo 5A(T 4252 1202 ↑ 10 A

A:

Q: 3. Evaluate the following. Express answers in polar form. a. b. (28 (65°) (45/300)APUA 6+j8 a. 5+j30…

A:

Q: The following problems refer to grounding requirements. 1. What is the minimum size copper grounding…

A: To find the minimum size copper grounding electrode conductor for a service with three sets of…

Q: 5. Convert variables in the coordinate system as follows: (a) Point A (p = 4, = 120°, z= 2) is in…

A:

Q: What is the current thru R7? (Answer in Amps) Answer in Amps 1 3 R1 16 Ohms R8 28 Ohms R2, 1 Ohms ww…

A: In this question we need to find the current through the resistor R7

Q: V = 12.0 V R C эпол A RC circuit, shown in the schematic above, is used to control the operation of…

A: In this question we need to find the value of resistance that the rheostat should be adjusted for…

Q: 1. A linear control system has the following transfer function: R(s) s+1 (a) Determine the transfer…

A: In this question we need to find the following Transfer function of the given system Response of…

Q: 8. For the CE amplifier shown in Figure, re = 3.50. Determine the lower critical frequencies due to…

A: The cutoff frequencies due to the coupling capacitor and bypass capacitor need to be calculated.

Q: Q2: a) If the number of binary bits = 4bits/sample and the sampling rate is 4 sample/sec find: 1)…

A: Given: Number of bits per sample = 4,  Number of samples per second = 4,  To find: a) Signaling…

Q: What are the three basic types of three-phase motors?

A: There are three basic types of three-phase motors, which are categorized based on the way they are…

Q: What type of cable is used with the F connection?

A: The F connector is commonly used in cable television (CATV) and satellite television (SATV) systems.

Q: 21. The below picture shows a complete npn transistor. In creating this transistor, silicon doped…

A:

Q: 4. A pressure transmitter has an input range of 100 kPa to 150 kPa, an output range of 4 to 20 mA…

A: Given data Input pressure range, 100 kPa to 150 kPa Output current range, 4 mA to 20 mA Accuracy is…

Q: For different types of buses/nodes in load flow analysis, explain their definitions and possible…

A: In power system analysis, buses/nodes are used to represent different components of the power…

Q: Q2. Assume the switch has been open for a long time, and that io(t) = 0 A when t 0. 4 V 2 ΚΩ W t =…

A: In this question,  We need to determine the current io  as shown the circuit.  We know Inductor act…

Q: A source voltage is given by the equation e- 277 sin(314t). If this source voltage is connected to a…

A: Voltage equation is given as, e=277sin314t V. Resistance is given as, R=10 Ω.

Q: Consider the signal s(t) shown in figure (1) 1) Determine the impulse response of a filter matched…

A:

Q: How is concept of voltage in electrical circuits is related to the concept of energy

A: relation between voltage and energy in electrical circuits.

Q: If you were asked to design a capacitor in small sizes and where large capacitance was required,what…

A: If you were asked to design a capacitor in small sizes and where large capacitance was required,what…

Q: Draw a radial distribution network feeder (11 kV), with 5 busbars/distribution substations, explain…

A: There are different sub parts for given question. a) To draw radial distribution network feeder 11…

Q: A fuel injector of inductance 6 mH and resistance 2 2 requires a minimum current of 3 A before it…

A: At,t=0,It0=0A, In steady state,  Inductor behaves as a short circuit. Now, the equivalent circuit…

Q: a) The inductor connected to Generator 3 neutral has a reactance of 0.05 per unit using generator 3…

A: Given base parameters for zone 1-2 MVAb = 1000 MVA KVb =500 kV  in the zone of line 1-2.   Here, it…

Q: A 75 km long 60 Hz transmission line is rated at 220 KV and 150 MVA. The line has the following…

A: It is given that: VR=210 kVcosϕ=0.85MVA=150 MVAr=0.09 Ωkmx=0.88 Ωkmy=4.1×10-6 mhokm from the earlier…

Q: A 9KVA, 360V/180V transformer has been tested to determine its equivalent circuit. The open circuit…

A:

Q: 4. Cylindrical volume 0 < p< 5 cm,0 < z< 20 cm, 0 < < 2π It has an electric flux density value D Z…

A:

Q: Express the following expression in polar form 3√2/-45° 7-jl 5/+81.87° 4 - j3 + Not. Solve this…

A:

Q: Problem eight. Given the following characteristic equation. Sketch the root locus. 1+ KS(S+4)…

A: In this question we need to draw a root locus of the given characteristics equation

Q: D4.15 Design the circuit of Fig. E4.15 so that P-3 V when I, 0, and changes by 20 mV per 1 mA of…

A: Given: Vo=3 VIL=0Vochanges by 20mV per 1 mA of Load current.

Q: 1) A 240 V, permanent magnet DC motor has 60 A full load (rated) armature current. Its armature…

A: In this question we need to find the following Rotational loss of motor Full load speed Speed…

Q: V₂ 100 130 10.0 A 92 V VB V₂ 50 10.02 H + 4. 10 S02√ = ?

A:

Q: Question A 440 V, 50 Hz, Y-connected synchronous generator has a direct axis reactance of…

A: A 440 V, 50 Hz, Y-connected synchronous generator- Direct axis reactance=0.12 ohm/phase, Quadrature…

Q: Given a unity feedback system where G(s) = K s" (s + a) find the values of n, K, and a to meet…

A:

Q: Develop a differential equation for vc in the circuit below. Solve it to determine vc(t) for 120.…

A:

Q: Nodal Analysis

A:

Q: Larut . For the type E chopper to be operated in the fourth quadrant only one switch is operated two…

A: In the IVth quadrant, only CH4 is capable of being operated, meaning it can be switched on and off…

Q: R(s) V₁(s) Vo(s) G₁(s) H(s) V₂(3)+ Vy(x) Vy(x) G₂(s) H₂(x) Va(s): Vs(s) (8) A Gy(s) Hy(s) C(s)

A: Given Data: A block diagram representation of the system with, Reference input=Rs Controlled Output…

Q: Use nodal analysis to find VI and V2 in the following circuit. 8 Ω www 3 Α 12 V + ΖΩ www + 1% - Τ 4Ω…

A:

BJT (Bipolar Junction Transistor)

A BJT is a semiconductor device with 3 terminals that consist of a p-n junction diode that can amplify the signal or current. It is a current-controlled device. The three BJT terminals are base, collector, and emitter. The BJT works with the charge carrier, the two type of carriers in the BJT are holes and electrons, the charge carriers flow by the process of recombination. The signal to be amplifier is generally given as the input at the base terminal and an amplified form of it is available at the collector terminal.