If the capacitor in the figure shorts to ground, the voltage at the cathode of the PUT will+18 V470ACOK 10220Select the correct response:not changebecomes zeroincreasedecrease

On seeing the circuit of the PUT the cathode is connected to the capacitor on shorting the capacitor…

Answered: apacito ngure shorts to ground, the…

apacito ngure shorts to ground, the voltage at the cathode of the PUT +18 V 470 ll AO OK 10LD 22.4 Select the correct response not change becomes zero increase decrease

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Related questions

Q: A load consumes 50kW and 20 KVAR. What is the power factor at the load terminals?

Q: concepts of a 3 phase synchronous moto

A: The motor is a device used for the conversion of electrical energy to mechanical output, there are a…

Q: 1. Give the transfer function of the following diagram, both in impedance and RC form: R e, CT 2

Q: Determine the inductor current i(t) shown in the circuit below. t= 0 4Ω. i(t) 16 2 20 V 0.4 H v(1)…

Q: Perform these operations using 8-bit signed two's complements arithmetic: i. 27 - 12 92 - 66 ii.…

A: 2.the operation using 8-bit signed two's complement arithmetic: Given, I. 92-66 ii. 27-12 III.…

Q: (c) Using voltage division find the ratio | Vout/ Vin| shown in figure 7. Assume that the input…

A: In this question, We need to determine the ratio of voltage Vo/Vi?

Q: Why did the synchronous motor stop as soon as we set the speed of the prime mover to 2500 rpm then…

A: As we know that in synchronous motor we have to give suppy from stator to produce three phase…

Q: #1) FIND the valve of the load Rin the network that will achieve maximum power trauster and…

Q: shunt motor takes 40 ampsat full-load when connected to a 115-volt line. At no load, the motor…

Q: 15. A circuit has a power factor of 0.85 lagging. Th apparent power is 67VA. Find the real power in…

A: Given, Power factor, pf = 0.85 Apparent power, S = 67 VA

Q: Discuss two advantages and disadvantages of a coubly-fed induction generato DFIG) over a squirrel…

A: Types of generator used in Wind power plant Doubly fed induction generator ( seperete excitation is…

Q: the 100P gain

A: Open Loop System-A system having a input in the system which does not depends on the system output.…

Q: V.(s) Determine the transfer function VO of the circuit as illustrated below. C2 ing R vo(t) v,(t)…

A: The solution is given below

Q: Ouestion 2 5Ω 2F 3F 10 Figure 2.1 Consider the system shown in figure 2.1 (a) (b) (c) (d) (e) Obtain…

Q: A, power by S1stor R 1S R 4 A 6 V 7 W 6 W None of the choices 24 W 18 W а. d. b. е. с.

A: We need to find out the power consumption by given resistance

Q: Q3/ A: For the power system shown, calculate fault current and when a 3-phase fault occurs at point…

A: In this question we need to find a fault current when 3 phase fault occurs at point F shown in…

Q: On no-load, the motor takes 4 A at 96 V and at 0.25 lagging power factor. The no-load friction and…

Q: What is the expectation of X where X is a single roll of a fair 6-sided dice (S {1,2, 3, 4, 5, 6})?…

Q: 23. A balanced three-phase wye system has a phase voltage of 277V and a line current of 26A. Which…

Q: 12. Two capacitors 15uF and 30uF are connected in parallel, what is the total amount of capacitance?…

Q: Design a MOD-10 Counter using a MOD-16 Counter.

Q: Determine the inductor current i(t) shown in the circuit below. t = 0 16Ω 4Ω. ilt) 16 2 20 V 0.4 H…

A: Current: It is the time rate of the change of the charges. The direction of the current is opposite…

Q: C= ax + 2ay - 3az and D= 4ax + 5ay-6az

Q: 50 + 20 /-30)

A: We need to find out polar form

Q: Determine the value of re. O 20 V 2.2 k2 390) k2 B = 140 %3D 1.2 k2 O 7 ohms O 10.12 ohms O 5.34…

Q: find the sinusoid represented by the polar.

A: In this question, We need to find the sinusoid represented by the polar

Q: Determine the average power absorbed by R1. (answer: 8W) 为H 4H ree reeer R2 4A O RI 98 car 4t V

A: In this question, We need to determine the power in the resistance R1 We know power in resistance…

Q: Briefly discuss the changes in the power factor of a three-phase squirrel cage rotor induction motor…

Q: Two long straight current-carrying wires are lined up parallel to one another at a distance d.…

A: In case of multiple different questions we are allowed to answer only first question. Please repost…

Q: (c) What does it mean for a system to be BIBO stable? Which region(s) of the z- plane correspond to…

A: BIBO STABLE: A system is said to be BIBO stable, for a given bounded input(finite amplitude signal)…

Q: Cite the similarities of common-emitter, common-base and common-collector configurations

A: The circuit of common-emitter is given as- The circuit of common-base is given as- The circuit of…

Q: NOTE: Average of periodic signal f (x) of period T is given by: t0+T 1 f(x)(ave) = 7 f(x) dx T to D1…

A: The solution is given below

Q: + 30 V Rc Rt るRE8.2Ke Find zi and zo and Av and Vo

Q: A. Find H in rectangular components at P(3, 4, 2) if there is a current filament on the z axis…

A: The Rectangular components of a vector are described by the vectors in horizontal and vertical…

Q: A coil of wire having a value of (5 + j8) ohms is connected in series with a capaci- tive reactance…

Q: Calculate for Voltage across each Resistors VAB, VBG, VCB, VCG, VCD, VED, VFE, VFG (consider the…

A: given here a circuit and asked to find the voltages across each resistor.

Q: Design a system with two generators (at 11 kV) and three loads, two transformers and four…

A: system design requirements loads =3 transformers =2 transmission line = 4 generators =2 at 11 kV…

Q: 11. Overcharging of a battery can cause. A. Bucking of a lead plates B. Loss of battery electrolyte…

A: Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: A UJT employed for the triggering of an SCR, stand-off ratio = 0.61 and DC source voltage and VBB is…

Q: An op-amp circuit has a desired closed-loop voltage gain of 10. If the input resistor to the…

Q: Calculate the closed-loop voltage gain, ACL, of an inverting op-amp circuit having an input…

Q: In infinite line, the uniform line charge density is 10 uC/m.what is the electric field for line if…

Q: +20 V 2 kn 82 ΜΩ Vo Ipss=12 mA Vp=-3 V ra= 100 ka 11 MQ Rs Cs 610 2

A: We need to find out output voltage for given circuit

Q: The system poles are 1+2j; 1-2j. Therefore, they are located in O a. Real Axis O b. Right half side…

A: Answer: Right half side of s-Plane Explanation: a. It is not a valid option because the given…

Q: How does each switch's Bridge ID come to be?

A: Switch's Bridge ID : Switch bridge ID is also known as uniques bridge identifier the main purpose…

Q: MI Ma 2. G(s) = X, cs) Fes) (tng)

A: Write the force balance equation on each mass Force due to spring = KX Convert into s domain…

Q: QI A 380 V, 50 Hz, 3-phase, star-connected induction motor has the following equivalent circuit…

Q: 1. Determine the inductor current i(t) shown in the circuit below. t = 0 4Ω ilt) 16Ω 20 V 0.4 H v(1)…

Q: 5. Find the Thevenin's Equivalent Circuit 20 10 Q 2i,

Q: (a) A linear, time-invariant discrete system is causal if its unit-sample response, h[n], is zero…

A: Casual system : Casual systems are those kind of systems which output depends on past output and…

Question

If the capacitor in the figure shorts to ground, the voltage at the cathode of the PUT will
+18 V
470
AC
OK 10
220
Select the correct response:
not change
becomes zero
increase
decrease

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Assume that the voltage drop across the resistor, ER, is 78 V; the voltage drop across the capacitor, EC, is 104 V; and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. Find the missing values. ET ER78V EC104V IT IR IC Z20 R XC VA P VARSC PF C
Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the inductor, EL, is 104 V, and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. ETITZ20VAPFER78VIRRPEL104VILXLVARsLL
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
(a) If the capacitor is initially uncharged with C = 8.50 µF and = 1230 V, find the value of R (in ohms) required to charge the capacitor to a voltage of 785 V in 1.40 s. (b) If the capacitor is then discharged across the patient's torso with Rtorso = 1240 Ω, calculate the voltage (in V) across the capacitor after 4.50 ms.
Q1 (True/False): A) The current through the capacitor is inversely proportional to the derivative of the voltage across it: Is it true or false? B) In a typical electronic circuit the capacitor blocks DC and couplest he AC to the next stage of the circuit: Is it true or false? C) The more the value of the stray capacitance , the better it is: Is it true or false?
A series circuit has a capacitor of 1.5625x10^(-8)F a resistor of 2x10^4 ohms, and an inductor of 1H. If the initial charge on the capacitor is zero,. if a 12-volt battery is connected to the circuit and the circuit is closed at t=0, determine the charge on the capacitor at any time t
A series L–R–C circuit has a supply input of 5 volts. Given that inductance, L = 5 mH, resistance, R = 75ohm and capacitance, C = 0.2µF, determine (c) the frequency at which the p.d. across the capacitance is a maximum and (d) the value of the maximum voltage across the capacitor. answer: c) 4741 hz, d)10.85volts