Answered: A)Perform the N=5 point circular…

A)Perform the N=5 point circular convolution of x and h using DFT. B)Perform the N=5 point circular convolution of x and h in time-domain.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Related questions

Q: 5. Use the concept of node voltage analysis to find io in the circuit shown: 16V +1 8Ω ww 5Ω 8 Ω Μ…

A: Given circuit:

Q: Two charges are placed as shown in Fig. 17–49 with q1 = 1.2 µC and q2 = -3.3 µC. Find the potential…

A: Given: Two charge, q1=1.2μCq2=-3.3μC

Q: Obtain the simplified output boolean expression A- B-

A: Given logic circuit,

Q: Find the E. T. of the following periodic signal -2 2

A: Given: Required: Fourier transform of the above given periodic sawtooth wave.

Q: If this machine were running as a generator, what would be the total induced emf developed by the…

A: Given: Armature resistance=0.050Ω, Terminal voltage=120 V, Armature current=20 A

Q: Find the F. T. of the following Signals using differentiation pro ĴA

Q: 1.3. Consider the system shown below. M(f) (the Fourier transform of m(t)) is also shown. M (f) y(t)…

Q: The current rating of an over current relay is 5 A. The relay has a plug setting of 150 % and time…

Q: Which of the following is an accurate statement for series tuned circuit?

Q: Consider the system shown below. M(f) (the Fourier transform of m(t)) is also shown. M (f) y(t) -20…

Q: Determine the primary constants, R, L, G, and C for a distortion-less line working at 300MHz. Given…

A: Given,Frequency, f=300 MHzCharacteristic impedance, Zo=75 ΩAttenuation constant, α=0.12 Np/mWave…

Q: 5Ω 107 0.1V, 5Ω + 10ΩΣ V

Q: Explain the concept of spread spectrum modulation.

A: We need to explain the concept of sprede spectrum modulation.

Q: please answer asap A 40Kw motor with a heating time constant of 120 minutes has a final…

Q: 37 The voltage gain of an amplifier without feedback is 3000. Calculate the voltage gain of the…

A: Given, Voltage gain of an amplifier without feedback or open loop gain, AOL=3000 A negative voltage…

Q: Now, d2 x (+) dt 2 50, d2x14) dt 2 d2x(1) dt 2 -2 is +2 J2x(+) ct 2 = ~15 (t + 2) + 25 (1-0) + 1 5…

A: Given here some calculation and asked to explain it. we know that if fourier transform of xt is…

Q: The output signal from a frequency inverter will appear on a scope screen as a: A. pure sine wave…

A: Introduction - Frequency inverter - A frequency inverter is an electrical device that accepts…

Q: Find the F.T. of the fall wing Signals (functions) f(t) = 3 Sgh (st) - - 1+jt aus: F(W) = {w-ze чпеш…

Q: A parallel resonance circuit has a resistance of 4 kohms and half-power frequencies of 16.6 kHz and…

Q: Find the F.T. of the fall wing Signals (functions) * (t) = 1 + cos (6πt + T ) ans = F(W) = 2π…

Q: Calculate the maximum aperture of a microwave antenna which has a directivity of 200

Q: 10 Ω 2002 is 20 lb va 12 3 Va E ≤502 13 10 V

Q: deduce the equivalent circuit of the coil

A: If the supply is applied to coil with iron core, then the power is observed for meet the core…

Q: Discuss the economic advantages of electric drive

A: Given: Electric drives

Q: 5 R. 8 R₂ Is 20R3≤ 1

Q: 8. Which characteristic of IC in Digital Circuits represents a function of the switching time of a…

A: The solution is provided in the following section.

Q: 4. Assume an ideal op-amp model and determine vo/Vin +0 Vin Hli R₂ M 9+ $1 R

A: Given: Let gain op the op-amp is 'A'.

Q: day, (1) The total current taken from the supply at a voltage of 230 volts (2) The energy consumed…

Q: a) Let f(t) represents the output of an industrial system in time domain, and F(s) be its Laplace…

A: Note : Since both the sub parts are not interlinked to each other hence according to the guidelines…

Q: Derive the expression for the average load voltage of a 3 phase full converter operating with an…

Q: 10.30 Use mesh analysis to find u, in the circuit of Fig. 10.78. Let u,₁ = 120 cos(100r +90°) V, V2…

A: Given that,Vs1=120 cos100t+90°=120∠90° VVs2=80 cos100t=80∠0° VImpedances-300 mH→ jωL=j100300×10-3=j…

Q: Indicate a way to increase the electron concentration and hole concentration in Si crystal.

A: To increase the electron concentration and hole concentration in Si crystal, the crystal is doped…

Q: Discuss the suitability of dielectric heating for a particular application.

A: Dielectric Heating:- Dielectric Heating is an electric heating process that raises the temperature…

Q: Find the F.T. of the fall wing Signals (functions) * (t) = 1 + cos (6π t + T ) ans =F(W) = 2T 8(W) +…

Q: During a lab session, the lab instructor presented the class with an alternating voltage which has…

Q: Discuss the advantage of electric vehicles

A: For the above given question we need to list advantages of the electric vehicles.

Q: 1. Determine the following for the network shown below: gm, ZiAMP, ZOAMP, AVAMP Rsig Vs C1 = Given…

A: The circuit diagram is shown below, IDSS=15mAVP=-6Vyos=50μSC1=0.02μFC2=1μFCs=2.2μF

Q: In a common base connection, a = 0.95. The voltage drop across 2 k resistance which is connected in…

A: Give, The circuit is Here, V2kΩ=2 Vα=0.95

Q: Apply Laplace transform to find the transfer function H(s). y' (t)- y' (t) - 2y(t) = x'(t)-x(t)…

A: Laplace of few Standard DE y'' ⇔s2y(s)y' ⇔s y(s)y⇔y(s)

Q: Consider the amplifier shown. Assume that VdsQ = 2.5V and that the transistor is described as…

Q: An inductor produces an inductive resistance of 50 Ω at 10 kHz. What value of capacitance will be…

Q: 3 The simplified form of Boolean expression (XYZ + M) (XM + YZ) XM+YZM XM + YZ M (X + M) (YZ + M) XM…

A: Given, Boolean expression is Y=X¯YZ+MX¯M+Y¯ Z¯

Q: Message signal m(t) = t²,0 < t < 4 sec, delta modulated with step size of 2 mV. What is the minimum…

A: Given signal graph, mt=t20<t<4 sec Delta modulated with step size, ∆= 2 mV.

Q: A taxi company uses a central dispatcher, with an antenna at the top of a 15 m tower, to communicate…

A: (a) For the communication between the dispatcher and the taxi, the radio horizon is considered. The…

Q: 1. System state equation are: [x = Ax+ Bu y = Cx+ Du (1) Drawing its block diagram. (2) Mark…

Q: The magnetic structure shown in the figure is built with a material whose magnetization curve is…

Q: A 3 HWCR has a supply of 110V / phase. Find out the value of mean voltage for a delay angle of 150°…

Q: 3.41 The input-output relationship of a system is giv by (a) r(t) = (c) where r(t) and c(t) are…

A: Given, The input output relationship of a system, rt=d2ctdt2+3dctdt+2ct Where rt is input and ct is…

Q: An electric circuit consists of an inductance of 0.1 henry, a resistance of 20 ohms and a condenser…

A: It is given that: L=0.1 HR=20 ΩC=25 μFq=0.05 CI=0 At=0

Q: Two positive point charges, 1 µC and 5 µC are separated by a distance of 3 m. Calculate the…

A: Given data, Q1=1 μCQ2=5 μCr=3 m

Question

A)Perform the N=5 point circular convolution of x and h using DFT. B)Perform the N=5 point circular convolution of x and h in time-domain.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

s ( s+1 ) ( s+2) (s+3)+k =0 Draw the root-locus curves of the characteristic equation . (Note: Find the equation that gives the separation points of the root locus curves, but without solving the equation, give roughly the location of these points on the axis)
given that vc=q/C. derive the expression for q in terms of time t.
a) get the equation of motion by drawing the free body diagram of the given system.b) get the transfer function of the system. Ɵ(s)/T (s) = ?Show all decals in detail.
A system has the following characteristic equation: s + s + 3 + 2s + 2 = 0 Using the Routh-Hurwitz method, check
Make the equation s(s+1)(s+2)+K=0 in the form of 1+KF(s) and explain the drawing of root-locus curves. (Note: Indicate the splitting points, centers and angles of the asymptotes)
Given that the maximum velocity of signal propagation on a Transmission line is the velocity of light in free space : 3×108m/s3×108m/s. Find the minimum inductance a transmission line can have if the capacitance is 19pF/m (a) 300 μH/m (b) 100 μH/m (c) 300 MH/m (d) 33.33 μH/m
a) Y(ω) = 1/(5+jω) The expression above defines the frequency domain signal Y(ω) from a time domain signal y(t) i) Determine the imaginary & real parts of Y(ω). ii.Determine the signal y(t) that produced the signal Y(ω). b)What are the 3 areas of application of i.Signals ii.Systems c) Briefly summarise with explanation the difference between discrete & continuous time signal and also write an expression that describes each signal type.
The mathematical models of some continuous time systems are given above. x(t) is the input signal of the system, and y(t) is the output signal of the system. Which of the following systems is linear and which is nonlinear? For linear systems, write "linear" in the space next to the option. For non-linear systems, write "non-linear" in the space next to the option.
1. Determine ?(?) ??? ? > 0.2.For the circuit below, determine: ?. ? (0^-), ? the time constant of the circuit at t > 0, and (?) ?(?) ??? ? > 0.
Examine the stability of the system given by the characteristic polynomial Δ(s)=2s^3+4s^2+ s+1 using the Routh-Hurwitz criterion.
GIven the difference equation:y(n)=0.0899x(n)+0.0257x(n−1)−0.0257x(n−2)−0.0899x(n−3)+1.6148y(n−1)−1.9395y(n−2)+1.2807y(n−3)−0.5852y(n−4)Solve the following:1.) The system function, H(z)2.) Poles and zeros
1-)Examine the graphs of the DSB (t) and VSB (t) signals in the time space. What are the differences?2-)How many sine waves does the resulting VSB signal contain? What are the frequencies of these signals?