Apply thevenin's theorem, find the value of current flowing in the resistance of 15 ohm in the electric circuit.

Q: 3. Based on the figure below, calculate the following: a. electric current that flows in the circuit…

A: We need to find current and voltage for given circuit

Q: An electric heater having power rated 1000W connected to a 240V supply for 10minutes. a) Determine…

A: As per our company guidelines, we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: 2. If a dry cell has an internal resistance of 0.50ohm and an emf of 2V, find the power delivered in…

A: Given: Internal resistance of dry cell, r=0.50 Ω EMF of cell, E=2 V Load resistance, R=1 Ω

Q: 2. Apply Ohm's law to the following problems: a. A current of 0.0021 A flows to a resistor having a…

A:

Q: A carbon resistor dissipated 60 W of power from a 120 V source at 20°C. How much power will be…

A: In this answer we will use the resistor and temperature dependence relation as shown below to find…

Q: Twelve resistors form the edges of a cube as shown in the figure. If the potential difference…

A: Given circuit,

Q: An electric heater is constructed by applying a potential difference of 104 V across a wire with a…

A: Given: The applied potential difference is, V=104 V Resistance, R=5 Ω

Q: Find the resistance and peak current in a 1000 W heater connected to a 220V-AC line.

A:

Q: For the circuit shown bellow, calculate the voltage, v, the conductance G, and the power p. + 3 mA (…

A: The obstruction offered to the path of current is called resistance. The electrical component that…

Q: Using Kirchhoff's rules, calculate (a) the current through the 2 Ω resistor in the circuit shown,…

A: In this question we will find current through 2 ohm and voltage between a and b...

Q: How is this power being distributed in different places? Discuss the energy distribution system. Use…

A: Generating station The power is being generated at a specific voltage that is lower than the…

Q: If a barrel plating runs uses 180 A for exactly 6 hours for an electroplating application at 0.30V,…

A: Given V= 0.3 V I = 180A Time = 6 hours

Q: For the series-parallel network shown in the following figure, find: (a) the supply current, (b) the…

A: The required parameters can be calculated by using the ohms law and current division rule.

Q: Using Kirchhoff's Law, calculate the current through the 4 ohms resistor of the circuit shown. 15 V

A: The equivalent circuit with assumed direction of current each resistor is shown below: To calculate…

Q: The

A: Here it is asked to find the current value when oyher parameters are given. Here a proportionality…

Q: Given the circuit below, solve for the voltage drop at the resistor 5 ohms. 10 Ω 4Ω 5Ω + 10 V V1 10…

A: we need to deteremine the voltage across 5 ohm.

Q: An electrical engineer is analyzing an electroplating run and wants to calculate the charge that has…

A:

Q: Using Superposition theorem, find the value of current flowing in the resistance of 20 ohm in the…

A:

Q: Q1: By using any method for simplifying electric network , Find the current of 10 -: resistor V1 V2…

A:

Q: 2. Apply Ohm's law to the following problems: a. A current of 0.0021 A flows to a resistor having a…

A: By ohms law , Voltage across the resistor = current ×resistance.

Q: Find the impressed voltage at the source in the circuit shown, if current flowing through 5-ohm…

A:

Q: 6. Using this equation, determine the current if I connect a 12V battery to a 60 Ohm light bulb.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Motor Suppose the voltmeter in the circuit shows 20 V, and the conductance of the motor is 25 mS.…

A:

Q: Consider a case where an oven operated on a 20 A current from a 120 V source. How much energy will…

A: Given- Current I=20 AVoltage V=120 VTime t=2 hours To Find- Electrical Energy consumed.

Q: Given the circuit below where a battery with EMF 12 V and internal resistance 2 ohms is energizing a…

A: consider the given question;

Q: Determine the reference voltages provided by the network of the figure below. Find the level of…

A:

Q: Superposition Theorem is used to solve an electric network, how will the actual direction of…

A: In this question we will write about superposition theorem....

Q: Find the current flowing through the 10 Ohm resistor directly by simulation and verify the same…

A: To find the nortans equivalent resistance we have to open the 10 ohm resistance and short circuit…

Q: Find the equivalent resistance between and b, (i.e., Reg = Rab). a

A: The circuit is as shown below :

Q: For the circuit shown in Figure, find, using the superposition theorem, (a) the current flowing in…

A: Given:-

Q: Using thevenin's theorem, find the value of current flowing in the resistance of 6 ohm in the…

A:

Q: A light bulb has a 25 W rating, and it is plugged into a socket with terminals at a 220 V potential…

A: Current in light bulb is calculated as- power is given  P=25W V=220volt

Q: - Find the current through the ( I,,12 and I; ) ? – Calculate the power dissipat ed in (3 N) ?

A: To solve above problem one can use either nodal analysis or mesh analysis In nodal analysis we apply…

Q: By Thevenin's Theorem, calculate the current through the Galvanometer,having a resistance of 20…

A:

Q: For the circuit shown, calculate the voltage v, the conductance G, and the power p. Answer: 20 V,…

A: power is the multiplication of the voltage and current

Q: 4 kf 2 kf 36 kn 24 kn { 20 k 20 kfl E n 3 kf 50 mA

A:

Q: An electrical engineer is analyzing an electroplating run and wants to calculate the charge that has…

A: Given Data" I = 3 A E = 10.3 kWh  = 10.3 x 3.6 x 10^3 Joule V = 0.25 V

Q: 2. Determine the current flowing in R₁, R₂, R3, R4, Rs and V₁. (if Voltage drop across R,=20 V).…

A: The required parameters can be calculated by using the ohms law, kirchhoff's current law and voltage…

Q: In the circuit shown G, and the power p. calculate the current i, the conductance 30 v (+ 5 k2

A:

Q: 5. A dc motor draws a current of 40A at 220V. If 800 W is dissipated in the form of heat in the…

A: 5. Given, IL=40 AV=220 VPL=800 W

Q: In the shown circuit, you are given that ɛ =41 V. Find (in volts) the magnitude of the potential…

A: Given circuit is shown below. Apply KCL at node V V-5R+V-41R+VR=0 V3R=46RV=463=15.334v

Q: Find ix and the power developed in the dependent current source, 2vx-

A: In the given circuit, we have to find ix and power developed in dependent current source 2Vx.

Q: An iron bought in the Philippines is rated at 1200 W and is connected to a 110-V source in Japan.…

A: Brief description : Here they have mentioned an iron which is purchased in Philippines with having…

Q: Find the current flowing through the 10 Ohm resistor by using Norton's theorem.

A:

Q: Given the circuit below where a battery with EMF 12 V and internal resistance 2 ohms is energizing a…

A: If two resistors R1 and R2 are in series than equivalant resistance is R1+R2.  Current supplied by…

Q: Q1: By using any method for simplifying electric network , Find the current of 10 -: resistor Vi V2…

A: Find the current in the 1 ohm resistance.  This circuit is combination of series parallel…

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.