As part of a stream restoration project, a design engineer would like to create a nice little area for fish to hide behind. She contracted a 50-foot-wide stream by adding a root wads on one side and a large rock on the other sideof the stream. Both the root wad and the large rock take up 10 feet on each side of the existing stream and can be assumed that they form a 90-degree vertical wall on either side of the stream.The total approaching flows in the stream are 380 cfs where the impeded flows normal to the root wad and the large rock are 20% of the total flow on each side. The average depth of the approach section is 2 feet. A surveywas completed, and the Kinetic Energy Coefficient was found to be 3.0.Determine the backwater due to the stream restoration efforts

According to given Data A 50-foot-wide stream by adding a root wads on one side and a large rock on…

As part of a stream restoration project, a design engineer would like to create a nice little area for fish to h of the stream. Both the root wad and the large rock take up 10 feet on each side of the existing stream ar The total approaching flows in the stream are 380 cfs where the impeded flows normal to the root wad an was completed, and the Kinetic Energy Coefficient was found to be 3.0.

As part of a stream restoration project, a design engineer would like to create a nice little area for fish to h of the stream. Both the root wad and the large rock take up 10 feet on each side of the existing stream ar The total approaching flows in the stream are 380 cfs where the impeded flows normal to the root wad an was completed, and the Kinetic Energy Coefficient was found to be 3.0.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

What do you think is the significant effect of the different water contents between each level and bore holes?
Problem 2 If you were to design a retaining wall for an embankment, would you consider cinder (or even flyash) as the fill material for the wall’s full height? Give reason(s) to support your answer. Hint: think abut sustainability as well.
Write short note on Water-Retaining Structures, dams.
3. How to determine the location of the horizontal moistureproof barrier? What are moisture-proof methords? When is a vertical moisture barrier required?
Define the term Rockfill Dams.
Explain Drainage methods to prevent development of water pressures behind retaining walls.
If the overall outside answer of the reinforced concrete pipe to be installed is 95 cm, and the top of the culvert is 30 cm below the subgrade, what will be the invert elevation at the center?
What are the Drainage methods to prevent development of water pressures behind retaining walls?
How does the Retaining walls and embankments have been built of earth reinforced?
Describe hydraulic fill in detail.
If an irrigation canal is forced to pass through a depression, what type of structure is needed?
An existing levee has a top width of 10ft, a top elevation of 10ft above the base, and 3:1(horizontal:vertical) slopes on both sides. If the levee is to be raised to an elevation of 15ft and must meet new standards requiring a 12ft top width, how much additional land space (in ft2) will be needed for the base of the levee per mile of levee length? Assume side slopes remain 3:1. Show all your work Note - I will downvote wrong answers oly attempt if you are 100 % sure , else skip and aloow others to do