As shown, what is the maximum moment in lb-ft? v (lb) K-2 2514.29 32*2* 514.29 -685.71 -2685.71 MATHalino.com 600 x (ft)

Q: An undisturbed soil sample, 100 mm in diameter and 200 mm high, was tested in a triaxial machine.…

A:

Q: 5.C.b. Is (4.3^3)=(2^2 27). Yes O No 5.C.C. What is the first and second element of (3, 9)? First…

A: 4.33=22.27 4.33=2(2.27×3/3) 4.33=(22.27/3)3 4.33=(20.7567)3 4.33=1.6893 Powers are same but base…

Q: Determine the prestressing steel area required for the precast concrete T-bear Use the following…

A:

Q: Suspended and non-suspended slab can both be designed as flooring system in building structure. List…

A: Suspended slabs are slabs that are not in direct contact with the ground. They form roofs or floors…

Q: P Bearing plate Let the allowable stresses in the post be ost=120MPaand oco=6MPA. Compute the…

A: Solution-The given data ,σst=120MPaσco=6MpaModulus of elasticity=200GPa and For concrete 14GPaCross…

Q: A canal is 80 km long and has an average surface width of 15 m. If the evaporation measured in a…

A: Given data: Stretch of evaporation, L = 80 km = 80000 m Average surface width, B = 15 m Evaporation,…

Q: A two-dimensional analysis on the flight of FL FN an airfoil is shown in the figure. The airfoil…

A:

Q: A catchment has six rainguage stations. In a year, the annual rainfall record by the gauges are as…

A:

Q: 3 ft 2 ft8 2 ft 12 kips The figure shows a homogeneous, rigid block weighing 12 kips that is…

A:

Q: QUESTION 13 F, 10 B, 14 E, 6 H, 2 A, 8 C, 10 D, 8 G, 12 For the network diagram shown above, what is…

A: The activities duration and their interrelationships are given.

Q: ow does climate change effect the use of such materials (concrete, steel and timber) in the future…

A: Concrete  Water in the concrete is evaporated at the high temperature it leads to the formation of…

Q: Two tangents intersecting at V which is inaccessible has an angle of intersection of 30 degree . Two…

A:

Q: POINT A AND DRAW THE SHEAR AND ΜΟΜΕΝT DIAGRAM FOR THE

A:

Q: DETERMINE THE SHEAR AND MOMENT FOR EVERY 8-FT STRIP INTERVAL STARTING AT ΡOINT Α ΑD DRAW THE SHEAR…

A: ∑MB=0RA×10 + 60 - 2×10×5 = 0RA=4 k ↑∑ME=04×32 + 60 +RC×12 - 2×10×27 - 5×16 - 12×3×12×6 = 0RC=45 k…

Q: Hwk 2-1.2: solve for bar forces using method of joints. Name: 7k 4k A 6k B 30° 4' C * X 4 E 4' G F…

A:

Q: Data and Results for Direct Shear Test: Normal Stress (kPa):  100; 200; 300 Shear Stress (kPa):…

A:

Q: Q1 /A W21 x 68 of A992 steel is used as a simply supported beam with a span Tength of 50 feet. The…

A:

Q: Consider the mechanism shown. Members PQ and QR are joined by a hinge at Q. End P of member PQ is…

A: Using relative velocity analysis or IC method the velocity of point Q can be calculated.

Q: consolidated drained triaxial test was conducted on a granular soil. At failure (σ1^')/(σ3^' ) =…

A:

Q: The oil-mercury differential reading 25 cm. Calculate the volume flow rate (in liter/ second) of oil…

A:

Q: A four-lane freeway, with a lane capacity of 2,000 vph, carries a peak hour volume of 4,000 vph in…

A: Traffic Speed =1/TTR a) During Peak hour  V= 4000 vph C= 2000 vph TTR=1+1.1*VC4=…

Q: EXAMPLE 1 A perfect gas has molecular weight of 26 and a value of y = 1.26, ?Calculate the heat…

A:

Q: What is the depth of the flow (m) in a circular channel of diameter 2.0 m for the maximum velocity?

A:

Q: How accurate is a certain method when it comes to calculating how much an engineering project will…

A: In estimating project cost, we have the several methods. Out of all them, Detailed Estimate  will be…

Q: A state of stress is specified in the figure shown below. Determine the Normal stress oy (mPa) on…

A: Asked: To compute the normal stress (σy) on the principal plane.   Given: Normal stress (σx) on…

Q: The initial economic analyses for the need for a transfer station are as follows (based on costs to…

A: Cost of for 100 min= $8/ton  Cost to transfer the station = $8.5/ton  Break even time to transfer a…

Q: A state of stress is specified in the figure shown. Determine the principal stress oy (mPa) if P…

A: This question is from solid mechanics Normal stress is 20 Mpa She is stress applied is 15 Mpa And we…

Q: Convert a flowrate of 2029 gal/min to ft/S. Answer to two decimal places.

A:

Q: can't understand it when its just typed out

A:

Q: Find the optimal Solution of following transportation system

A: Given: Solve by using Simplex method

Q: Determine the positive moment in the direction of the short side for deck 6. Take the design load to…

A:

Q: Using 3 Methods, Moment Area Method, Conjugate Beam and Superposition Principle. EI = 100,000 kN-m²…

A: Given data:- Above diagram is given EI = 100000 kN-m2

Q: = 92 mPa and oy = -40 mPa. Determine ox on the plane whose normal are +23° and 23+90°

A:

Q: Calculate the discharge (in cubicmeter/ second) if Cd = 0.63 4 m 4.5 m -2 m- 0.5 m- AV NIN. Fig.…

A:

Q: what is the difference between confined and unconfined aquifer?

A: Aquifer:- Aquifer is a water bearing formation of the earth. It holds the water as well as yields it…

Q: At a given sectiona shaft is subjected to a bending stress of 30 MN/m2 and a shear stress of 60…

A:

Q: 2. The long chord of a compound curve is equal to 250 meters. The PC this curve is at STA 10+000 the…

A:

Q: ind the discharge for this area. Before and after converting the industrial area If the rainfall…

A:

Q: What is the head that must be supplied by the pump to the water to pump 0.4 m/s from the lower to…

A: To Determine the head that must be supplied by the pump to the water to pump 0.4 m ^ 3 / s from the…

Q: deflection by

A:

Q: I. Solve for the reactions and draw the shear and moment diagram. 49 kN/m (c) 4 m 6 m

A:

Q: a) A closed traverse survey involved measurements of angels and distances between (5) stations A, B,…

A:

Q: The 'frog' of the brick in a brick masonry is kept on : (a) bottom face (c) outer side of the wall…

A: Frog is the depression in the top face of the bricks, which is given to provide shearing resistance…

Q: D 14-mm-thick gusset plate F - 13-mm-thic angle 6 m E G H A C 4 m 4 m 4 m 4 m P BE 96 kN 200 kN 96…

A:

Q: Problem 2) Determine the reactions at A and G, and then determine the force in each member. State…

A:

Q: (c) A horizontal curve is designed for a two-lane road in mountainous terrain. The following data…

A:

Q: 2. An existing waterworks system serves 12,500 people with 3.75 MLD water consumption, in 10 years'…

A: hjjhjbjk

Q: The oil-mercury differential reading 25 cm. Calculate the volume flow rate (in liter/ second) of oil…

A:

Q: ameter of the jet, the actual velocity of the jet, and Liquid surface the discharge. 3. The liquid…

A: Given data:- Gas pressure PA =+5 lb/in2 Outside pressure PB = -2 lb/in2 Height of discharge h = 4…

Q: What errors can occur when the grading curve is extrapolated into the clay zone?

A: Brief concept introduction- Error- It is the difference between the measured and the actual value.…

System of Forces

A force is an external influence or agent that changes the state of a system. According to Newton's second law, the force applied to a body is proportional to the change in momentum of a body. Hence, whenever a force is applied to a body, its momentum changes. If the body is at rest, under the action of force, its state of rest changes to motion. In other words, the magnitude of the momentum of the body changes from zero to a measurable value. Similarly, if the body possesses some initial velocity, it has some associated momentum, the effect of force can cause the body to halt or come to rest, that is, the momentum reduces to zero.