Assume a deep deposit of normally consolidated clay. Which of the following processes or actions would lead to the soil becoming over consolidated (select all options that apply)? A.Construction of a road embankment B.Unprecedented water level drawdown extended over a long period of time C.Traffic loads induced by the presence of trucks on site at times D.Heavy rainfalls raising the original water table at the ground surface E.Deep compaction of the clay deposit

Assume a deep deposit of normally consolidated clay. Which of the following processes or actions would lead to the soil becoming over consolidated (select all options that apply)? A.Construction of a road embankment B.Unprecedented water level drawdown extended over a long period of time C.Traffic loads induced by the presence of trucks on site at times D.Heavy rainfalls raising the original water table at the ground surface E.Deep compaction of the clay deposit

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter2: Geotechnical Properties Of Soil

Section: Chapter Questions

Problem 2.4P

See similar textbooks

Similar questions

A 10-ft-thick clay layer is drained at the top and bottom. Its characteristics are Cvr = Cv (for vertical drainage) = 0.042 ft2/day, rw = 8 in., and de = 6 ft. Estimate the degree of consolidation of the clay layer caused by the combination of vertical and radial drainage at t = 0.2, 0.4, 0.8, and 1 year. Assume that the surcharge is applied instantaneously, and there is no smear.
What is the seepage equation for flow through the non-isotropic soil?
Assume that an area is underlain by a stratum of compressible soil 5.3 m thick. The weight of the proposed structure, say an earth embankment for a new highway, will result in an increase of 28.2 kPa pressure to the compressible soil. The settlement under this loading would be 0.30 m. The 385 compressible layer is doubly drained, and the soil has a cv value of 0.4 m2/month. Calculations indicate that it would take approximately 22 months for the settlement to occur under the weight of the proposed embankment. How long would be required for a surcharge imposing a pressure of 56.4 kPa to cause the 0.30 m of settlement?
Are flow nets to study subsurface flow appropriate only to coarse-grained soil with a high coefficient of permeability? Explain.
The hydraulic gradient for an occurrence where there is a vertically upward flow of water through a sand mass is 0.95. If the specific gravity of the soil particles is 2.75 and the void ratio is 0.65, determine if a quicksand or erosion condition could develop.
Answer the ff: a) What is the value of the hydraulic gradient b) The unit weight of the saturated soil layer is ? c) What is the rate and direction of seepage? d) The moisture content of the fully saturated soil layer is?
In a fill section of a construction site, 1500 m3 of moist compacted soils is required. The design water content of the fill is 15%, and the design unit weight of the compacted soil is 18.5 kN/m3. Necessary soil is brought from a borrow site, with the soil having 12% natural water content, 17.5 kN/m3 wet unit weight, and Gs = 2.65. How much (in cubic meters) of the borrow material is required to fill the construction fill section? And how heavy is it?
The hydraulic gradient for quicksand condition is equal to 1.25 with a void ratio of 0.42. The moist unit weight of soil is 19.50 KN/m3. Compute the dry unit weight of soil in N/m3 Please answer this asap. For upvote. Thank you very much
What is the typical saturated permeability values for sand, silt and clay?
Define the Hydraulic Conductivity of Cohesive Soil ?
A new construction site requires 1500 m3 of moist compacted soils. The design specification of the fill material specifies the following: Water Content 15% Unit weight of the compacted soil to be 18.5 kN/m3 Soil from borrow site has the following specification: Water Content 12% Unit weight of the borrow material: 17.5 kN/m3 Soil Specific Gravity: 2.6 How much (in cubic meters) of the borrow material is required to fill the construction fill section?
Describe Stress Path for Tests in Consolidated–Drained Conditions