Assume that, in a Stop-and-Wait system, the bandwidth of the line is 3 Mbps, and 1 bit takes 30 milliseconds to make a round trip. If the system data packets are 9,000 bits in length, what is the utilization percentage of the link? a. 10 percent O b. 1 percent O. 20 percent O d. 100 percent e. None of the above

Assume that, in a Stop-and-Wait system, the bandwidth of the line is 3 Mbps, and 1 bit takes 30 milliseconds to make a round trip. If the system data packets are 9,000 bits in length, what is the utilization percentage of the link? a. 10 percent O b. 1 percent O. 20 percent O d. 100 percent e. None of the above

Computer Networking: A Top-Down Approach (7th Edition)

7th Edition

ISBN:9780133594140

Author:James Kurose, Keith Ross

Publisher:James Kurose, Keith Ross

Chapter1: Computer Networks And The Internet

Section: Chapter Questions

Problem R1RQ: What is the difference between a host and an end system? List several different types of end...

See similar textbooks

Related questions

Q: Suppose that R = 1 Gbps and Rc is 300 Mbps and Rs is 200 Mbps. Assuming that the servers are…

A: EXPLANATION: As per the information given in the question, it can be said that: R = 1GBPS = 1024…

Q: Q 1. (a) Data are transmitted over a particular Ethernet network in blocks of 1500 bytes. How many…

A: Actually, 1 byte = 8 bits.

Q: 9. Suppose that the TCP congestion window is set to 18 KB and a timeout occurs. How big will the…

A: The Transmission control protocol congestion window is defined as the amount of data that is being…

Q: d. A particular service provider desire to transfer a 20 MB file across network with Signal to Noise…

A: Solution is :

Q: eering Computer EngineeringQ&A Library2.1 Mbps. Assume that packets are of length 2.0 Kb (Kilobits)…

A: It is defined as the way in which data is transmitted from one device to another device is known as…

Q: If the bandwidth of the network is 10Mbps, which is used to transmit the data between two nodes…

A: Data given- Bandwidth of network = 10 Mbps = 106 bits / s Distance between two nodes d = 200 m…

Q: Supposing you have a packet whose length is 1500 bytes,calculate the transmission delay for the…

A: In given question, we have to first check maximum transmission rate(i.e., Bandwidth) and then find…

Q: Suppose two hosts, A and B, are separated by 30,000 kilometers and are connected by a direct link of…

A: The answer given as below:

Q: A packet of length 1,500 bytes propagates over a link of distance 3,000 km, propag speed 3.0x10°…

A: Propagation delay=distance/propagation speed =3000*1000/3*10^8sec convert into millisecond multiply…

Q: Suppose that an 11-Mbps 802.11b LAN is transmitting 64-byte frames back-to-back over a radio channel…

Q: Compute the latency for a data packet of size 1596 bytes. The network has bandwidth of 12 Mbps, the…

A: Given : Packet size = 1596 bytes Bandwidth = 12 Mbps Distance = 1900 km Speed of copper cable =…

Q: Nodes A and B are on the same 10 Mbps Ethernet segment, and the propagation delay between two nodes…

A: The Answer is in Below Steps

Q: 17. A 1 KM 1long CSMA/CD with a propagation 10Mbps delay 5usec has bandwidth. Repeaters are not…

A: Here is the solution with an explanation:-

Q: A 1-km long, 10 Mbps CSMA/CD LAN (not 802.3) has a propagation speed of 200 m/u sec. Repeaters are…

A: Answer: Solution:

Q: A.10.What is the total delay (latency) for a frame of size 10 million bits that is being sent on a…

A: Frame Size: 10 million bits = 107 bits Length of the link = 2000 Km = 2000 * 103 m Speed of the…

Q: Question: Suppose two nodes, A and B, are attached to opposite ends of a 1200 meter cable, and that…

A: Below is the answer to the above question of both parts. I hope this will be helpful for you..

Q: A 1 Mbps satellite link connects two ground stations. The altitude of the satellite is 36,504 km and…

A: Introduction :Given , 2 stations .Link speed = 1 Mbps altitude of the satellite = 36,504 km speed of…

Q: A 1-km-long, 10-Mbps CSMA/CD LAN (not 802.3) has a propagation speed of 200 m/sec. Repeaters are not…

A: Introduction

Q: Determine the maximum length of the cable (in km) for transmitting data at a rate of 500 Mbps in an…

A: Given : Transmission Rate = 500 Mbps Frame Size = 10000 bits Signal speed = 2,00,000 km/s Here…

Q: Ethernet frames must be at least 64 bytes long to ensure that the transmitter is still going in the…

A: Maintenance of minimum frame size of 64 bytes in fast Ethernet: The maximum wire length in Fast…

Q: Host A and Host B are connected by a single 2 Mbps (Megabits per second) link that has a propagation…

A: The answer is..

Q: What is the delay of sending a data file from a source station to a destination station? Suppose…

A: Here the total delay for sending file from source to destination => Transmission delay +…

Q: If the bandwidth of the network is 10Mbps, which is used to transmit the data between two nodes…

A: Given: Bandwidth= 10MbpsDistance= 200mVelocity= 2x108 m/s

Q: We have a 4 km down CSMA / CD channel with a capacity of 10 Mbps. Assume the average negotiable…

A: Answer: Given: R be data rate is 10 Mbpsd be link distance of 4kmV be propagation velocity (m/s) is…

Q: If the bandwidth of the network is 10Mbps, which is used to transmit the data between two nodes…

A: Given Bandwidth B=10Mbps=10*106bps=107bps Distance L=200m Propagation speed P=2*108m/sec

Q: A 100 Mbps half-duplex link between two stations is established. If the distance between the two…

A: With half-duplex mode, each transmitted character is immediately displayed on a monitor. If a…

Q: Consider a channel with spectrum from 3 to 7MHHZ and SNR(dB) = 20dB. What is the maximum theoretical…

A: Channel is noisy as SNR( Signal to Noise Ratio ) is given. Maximum theoretical data (C) is given by:…

Q: Compare and contrast three different kinds of Medium Access Protocols (MACs) by offering an example…

A: GIVEN: Compare and contrast three different kinds of Medium Access Protocols (MACs) by offering an…

Q: Calculate the nodal delay in millisecond for a 1000-byte packet when the node bit rate is 1 Mbps,…

A: The question is to find the nodal delay for the given problem.

Q: 2.1 Mbps. Assume that packets are of length 2.0 Kb (Kilobits) and the length of the link is 100Km.…

A: Given Distance = 100KM velocity =? Bandwidth = 2.1Mbps Length of message = 2Kbits = 2*10^3…

Q: A 64 Kb packet message is to be transmitted from the source to the destination with 2000 m apart.…

A: The Answer is

Q: If the bandwidth of the network is 10Mbps, which is used to transmit the data between two nodes…

A: Given: Bandwidth= 10MbpsDistance= 200mVelocity= 2x10^8 m/s

Q: a.) Why have the standards makers chosen to specify that requests for Delivery Status Notifications…

A: Answer a. The primary reason for sending requests for Delivery Status Notification via SMTP is…

Q: a.) Why have the standards makers chosen to specify that requests for Delivery Status Notifications…

A: a) There are multiple reasons for this: Notification is easily correlated to recipients Separate…

Q: 16. Calculate the total transfer time of a 1000byte packet sent between a client and a server…

A: 1 Byte = 8 bits 1 Mbps = 106 bps Packet Size = PS = 1000 bytes BandWIdth = BW = 1 Mbps…

Q: Use a diagram to illustrate the four-way handshake protocol for channel reservation in IEEE 802.11…

A: the answer is

Q: Use a diagram to illustrate the four-way handshake protocol for channel reservation in IEEE 802.11…

A: Use a diagram to illustrate the four-way handshake protocol for channel reservation in IEEE 802.11…

Q: what the total time required to send 5000 bytes across a 3000 kilometers link at 1 Mbps?use a signal…

A: The transmission time (Tt) = L/B = Length of the data / Bandwidth The propagation time (Tp) = d /…

Q: If a data is steadily flowing at the rate of 1 Mbps with a sudden peak in data rate of 2 Mbps, then…

A: Given that if a data is steadily flowing at the rate of 1 Mbps with a sudden peak in data rate of 2…

Q: Question 3:Consider a message that is 10 Mbits long that is to be sent from source to destination in…

A: As per our guidelines we are supposed to answer?️ only one question. Kindly repost other questions…

Q: QUESTION 9: Assume the usage of Go-Back-7 (N = 7) ARQ sliding window protocol for flow and error…

A: Here in this multiple question we have given a sliding window (GB7) .and we have asked to find no of…

Q: QUESTION 16 Select the correct statement(s) regarding Frame Relay (FR). a. FR is a connectionless…

A: Frame Relay is a highly efficient WAN protocol that operates on physical and data interface layers…

Q: For the following problems, you are given a network address and asked to add subnet bits to produce…

A: 192.168.110.0/24 Number of Subnet required=7.

Q: If there is a computer with the address 4A: 30: 10: 21: 10: 1A sending frame data to your computer,…

A: In the Ethernet, the source address is 6 bytes and destination address is also 6 bytes. The source…

Q: Suppose there are 4 nodes sharing a broadcast channel using TDMA protocol. Suppose at time t=0: Node…

A: Suppose there are 4 nodes sharing a broadcast channel using TDMA protocol. Suppose at time t=0:Node…

Q: Suppose there are 4 nodes sharing a broadcast channel using TDMA protocol. Suppose at time t=0:…

A: Suppose there are 4 nodes sharing a broadcast channel using TDMA protocol. Suppose at time t=0: Node…

Q: Question 2: An end system sends 50 packets per second using the User Datagram Protocol (UDP) over a…

A: An end system sends 50 packets per second using the User Datagram Protocol (UDP) over a full duplex…

Q: The main advantages of packet switched networks ----- Showing the path of the sent message.…

A: Packet Switching: Packet-based networks break down a message into smaller data packets which then…

Q: Consider the following IP address and subnet mask. 131.0.10.11 255.255.128.0 What is the Network ID…

A: Network ID- 131.0. Broadcast ID-131.0.10.255 Number of Bits- 255-11= 244

Question

6*)

This MCQ QUESTION FROM DATA COMPUTER NETWORKS course.

Assume that, in a Stop-and-Wait system, the bandwidth of the line is 3 Mbps, and 1 bit takes 30
milliseconds to make a round trip. If the system data packets are 9,000 bits in length, what is the
utilization percentage of the link?
O a. 10 percent
оь. 1рercent
O c.
20 percent
O d. 100 percent
O e.
None of the above

System that digitally connects two or more computers for the purposes of communication and/or sharing resources. These networks may be composed of general or specialized hosts, PCs, servers, or networking hardware.

Expert Solution