Assume that you were tasked to install a microwave oven using 12 AWG copper. When you look at the spec plate for the oven, you discover that the oven is rated for 240V, 60HZ, and takes a current of 25A. The location for the oven is 785.7 Ft, away from the breaker panel. Calculate the expected VD if any. Assume temperature to be 75 ̊ C what is the answer? VD?

Assume that you were tasked to install a microwave oven using 12 AWG copper. When you look at the spec plate for the oven, you discover that the oven is rated for 240V, 60HZ, and takes a current of 25A. The location for the oven is 785.7 Ft, away from the breaker panel. Calculate the expected VD if any. Assume temperature to be 75 ̊ C what is the answer? VD?

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter3: Determining The Required Number Of Branch Circuits, Lighting Outlets, And Receptacle Outlets

Section: Chapter Questions

Problem 17R: In a single-family dwelling, how is overcurrent protection for branch circuits required to be...

See similar textbooks

Similar questions

Voltage Drop! Assume that you were tasked to install a microwave oven using 12 AWG copper. When you look at the spec plate for the oven, you discover that the oven is rated for 240V, 60HZ, and takes a current of 25A. The location for the oven is 785.7 Ft, away from the breaker panel. Calculate the expected VD if any. Assume temperature to be 75 ̊ C. what is the Voltage Drop ? Answer?
(c) Sketch a circuit diagram of a complete power conversion circuit that would be used to connect a solar PV array to the grid. Briefly describe its operation, including mention of the types of power electronic switches that might be used along with their voltage/current ratings. Please solve this with in 1 hour
The following problems refer to grounding requirements. Give the source of yourresponses. 1. What is the minimum size copper grounding electrode conductor for a service withthree sets of parallel 350 kcmil conductors (three conductors per phase)?
Using NEC: What gauge of conductors is required to feed a 240 Volt single-phase air conditioning unit, whose compressor consumes 6000 VA and the condenser motor is 2 amps? Use copper THHN wire connected to 60°C terminals. What is the minimum and maximum allowable ampacity of the air short-circuit protection of the previous example?
In a single-family dwelling, how is overcurrent protection for branch circuits required to be provided? See NEC 210.20. __________
A power line is needed to connect a power station on the shore of a river to an island 4miles downstream and 1miles offshore. Find the minimum cost for such a line given that it costs $50 000 per mile to lay the wire under water and $30 000 pe mile to lay wire underground.
Use KCL and KVL Equations. Please answer within an hour, thank you!
Two persons are standing near a HV equipment and working on it, when an arc flash occurred. Person A was directly in front of the equipment and he managed to move out within 5 msec of arc flash, whereas Person B was standing at 30 deg from the equipment and moved out in 8 msec. Who do you think will be seriously affected and why?
Part 2: Analysis and selection of the Wind Turbine. The team decides at install a 30 MW wind farm. The turbine that has been selected by the local contractor is an Enercon wind turbine. The specifications of all the available Enercon wind turbine is shown in the attached datasheet. 1. Decide on the required number of wind turbines needed. 2. In your own words, explain what the Betz limit for wind turbines means.
Draw a simple electrical diagram of an interactive solar system for residential building.
(c) Draw a circuit diagram to represent a TN-C-S earthing system and briefly explain its advantages and disadvantages. (d) Briefly explain how to estimate the height of air termination of a lightning protection system network using the rolling sphere method and protection angle method. (e) Briefly explain what is meant by Ground Potential Rise (GPR) and explain why an animal like cow would not be adequately protected against GPR. Note : answer all or else dnt attempt the question
Take a look at the wire supplying your house, another residential house, commercial and industrial buildings in your locality, count how many wires are connected to the building (from the electric meter to the weather head OR the service drop itself)? Are the wires different from each other? If so, why?