Assuming the magnetic permeability of the core as infinite in the magnetic circuit given in the figure, find each self- inductance and common inductance in terms of A1, A2, g1 and g2. 92 N2 iz t the area of the shaded area A1, the area of the other areas A2

Assuming the magnetic permeability of the core as infinite in the magnetic circuit given in the figure, find each self- inductance and common inductance in terms of A1, A2, g1 and g2. 92 N2 iz t the area of the shaded area A1, the area of the other areas A2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Q5) prove that for any adiabatic process (pv' = c) the work done is: W= (P1v1 – P2V2)/(1– ')

A: We have to prove that, W=p1v1-p2v21-γ

Q: The figure shows a coil with a sheet iron core with unlimited magnetic penetration and a rectangular…

A: The power input to the coil is given by, PL=12LI2----(1) where L is a self-inductance of the coil,…

Q: Q3) An infinitely long conductor is bent into an L shape as shown in Figure below. If a direct…

Q: The current in a coil with 200 turns required to establish a flux of 20Wb in the middle section of…

Q: A DC current I flows in a long solenoid with n coil-turns per unit length. The core is made of iron…

A: The solution can be achieved as follows.

Q: coils

Q: Explain the hysteresis that can be found in materials due to force, magnetic and electrical…

Q: A ferromagnetic core with a relative permeability of 2000 is shown in Figure Q1-7. The dimensions…

Q: A hollow conductor us at a potential V. The potential at any point inside the hollow is,

A: Solution: The conductor is hollow i.e no material is present inside the conductor. Therefore no…

Q: A DC current I flows in a long solenoid with n coil-turns per unit length. The core is made of iron…

A: Consider the virtual displacement of iron core is Consider the formula of magnetic energy.…

Q: (b) Figure Q3(b) shows a magnetic circuit with two different material, with a mean cross- sectional…

Q: A solenoid has 250 turns, Solve for the magnetomotive force when the current is 0.12 Amperes, a. in…

Q: QI- The magnetic circuit shown is made of a cast-steel and has a coil of 1000 turns on its center…

A: It is given that: N=1000 turnsthickness of core=5cmmean length of magnetic paths…

Q: The magnetic structure shown below can be considered to have infinite permeability. (a) Find the…

A: Given, the permeability of core is infinity. So, the reluctance offered by the core is zero.

Q: Figure 1 shows a ferromagnetic core with a relative permeability of 1850, the depth of the core is…

A: Fig: Given magnetic circuit Given that μr=1850t=10cmlg=0.2cmN=500effective…

Q: Mutual induction (will the induced current in the loop induce a current in the straight conductor?),…

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: A magnetic circuit with three airgap is given in the following figure. Assume that the core has…

Q: A solenoid similar to the figure below, has a core made of cast steel (refer to the figure on the…

A: A=4cm2=4×10-4 m2λ=20cm=0.2mN=100I=3.2Aa MMF=NI=100×3.2=32ATb H=NIl=320.2=160 AT/mcB=μH=μo μr…

Q: Q1- The magnetic circuit shown is made of a cast-steel and has a coil of 1000 turns on its 5cm and…

Q: The magnetic structure of Figure Q7 1 has a rerromagnetic core that can be treated as infinitely…

Q: A magnetic circuit shown in FIGURE Q2 has a core relative permeability, µs = 2000. The depth of the…

A: Ans a) Rc1=Rc2=Rc3=lμ0μrA=0.1+0.2+0.14π×10-7×2000×10×40×10-4Rc1=Rc2=Rc3=15.915 KΩ Ans b) Reluctance…

Q: A ferromagnetic core with a relative permeability of 1500 is shown in the given figure. The…

A: Marking the points A, B, C, D, E, F, G,H, I and J in the figure given,

Q: We consider a coil constituted of a conducting wire on a circular torus (see Figure below). The…

A: The toroid is a hollow circular ring carrying current-carrying conductors. A magnetic field…

Q: (b) Figure Q3(b) shows a magnetic circuit with two different material. with a mean cross- sectional…

Q: A 10, 120 V, 60 Hz supply is connected to the coil The coil has 200 turns. The parameters of the…

A: Given values are - E=120Vf=60HzAreaa=20cm2N=200

Q: The figure shows a coil with a sheet iron core with unlimited magnetic penetration and a rectangular…

A: (b) The power input to the coil can be written as, PL=12LI2 where L is a self-inductance of the…

Q: Two long, parallel wires are 6 m apart. T nts of 10 A each, in opposite directions. a third long…

A: The magnetic field created at a point due to a current carrying conductor is given as: B=μ0I2πR…

Q: 1- Find the mutual inductance between two coplanar rectangular loops with parallel sides as shown in…

Q: 13

A: Total inductance of transmission line is due to internal flux and external flux. Inductance due to…

Q: 8: 1- The magnetic circuit shown in the figure has two windings and two air gaps. The core can be…

Q: Consider the magnetic circuit shown below. The primary coil has N1=400 turns, and the secondary coil…

Q: A bar of iron is said to be saturated once most of its magnetic molecules are aligned, whereby,…

A: The explanation to all three subparts is as follows.

Q: 10 Given a common magnetic core whose length is 100 cm, its cross-sectional area is 25 cm square.…

Q: solenoid similar to the figure below, has a core made of cast steel (refer to the figure on the next…

Q: 3.20 Consider the magnetic core shown in Figure P3.20 and notice that three sides of the core are of…

A: This question belongs to electrical machine . It is based on the concept of magnetic core equivalent…

Q: A magnetic core with an air gap is shown below. For a relative permeability is 9500, and the space…

Q: A magnetic circuit with three airgap is given in the following figure. Assume that the core has…

Q: Problem 4 The magnetic circuit shown in the figure has two windings and two air gaps. The core can…

Q: Answer each of the following conceptual questions in one or a few complete sentences. It's…

A: We are authorized to answer three subpart question at a time, since you have not mentioned which…

Q: A ferromagnetic core with a relative permeability of 1500 is shown in the given figure. The…

A: Given,Relative permeability of the core=μr=1500Number of turns in the core=N=300Current in the…

Q: Problem 3. A magnetising force of 8000 A/m is applied to a circular magnetic circuit of mean…

A: Given data : Magnetising Force=8000 A/m Diameter of the circular circuit,d=30 cm =30×10-2m Number…

Q: The figure shows a ferromagnetic core. The core depth is 5 cm. The other dimensions of the core can…

A: Write the expression for the reluctance,

Q: Find the inductance per unit length of a very long solenoid with a unit length of N windings. The…

A: According to the question, we have to find the inductance per unit length.

Q: b. In the electromechanical system of the figure below, the iron portion has infinite permeability,…

A: Since the iron portion has infinite permeability, the reluctance of the iron portion will be zero.…

Q: (c) The simple magnetic circuit shown in fig 6. has a cross-sectional area of 50cm? and mean length…

Q: Q. 7: CLO4-(C3) Find force on the square loop shown in Figure below. Also, find the expression of…

Q: Consider the magnetic circuit shown below. The primary coil has N1=400 turns, and the secondary coil…

Q: A three-legged ferromagnetic magnetic core with the coil of 500 turns wrapped around the right leg.…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Solution

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the magnetic circuit shown in the figure, the iron core with N = 500 turns -Magnetic permeability is 200. its average length is 40 cm -The diameter of the cross-sectional area is 1 cm. Find the current that must pass through the winding to produce 0.5 mWb of flux in a 1mm air-gap magnetic circuit?
The magnetic circuit of Figure shown has current 10 A in the coil of 1800 turns. Assume that all branches have the same cross section of 2 cm^2 and that the material of the core is iron with μr = 1500. Calculate magnetomotive force for the core.
A DC current I flows in a long solenoidwith n coil-turns per unit length. Thecore is made of iron with permeability µ , and has a cross section area S.Determine the force acting on the coreif it is withdrawn to the position shownin figure.
A magnetomotive force is supplied by a current of 1 A through 100 turns. The magnetic circuit consists of a steel core of 1000 permeability, 10 cm long and 4 cm^2 area and an air gap 1 cm long. Find the field intensity at the air gap in Oersted.
Below you can find a ferromagnetic core and its magnetization curve. If i1=0.4 A and i2= 0.9A, find magnetic flux in the core and the relative permeability under these conditions.
The applied MMF to a simple magnetic circuit is 350AT. It was found that the resulting magnetic field denstiy is 0.7 Wb/m². The average length of this magnetic circuit is 1.64ft and its cross sectional area is 4cm². What is the reluctance (in AT/Wb) of the magnetic material of the core?
The reluctance of a non-magnetic path is 12 AT-Wb. Find the flux needed to be set up if surrounded by a coil 600 turns carrying a current of 3 A.
An iron-cored choke is designed to have an inductance of 12.5 H when operating at a flux density 3 T, the corresponding relative permeability of iron core is 1500. Determine the number of turns in the winding, given that the magnetic flux path has a mean length of 20 cm in the iron core and 2 mm in air-gap that its cross-section is 15 cm2. * ROUNDING OFF is ALLOWED only in the final answers expressed up to FIVE (5) DECIMALPLACES.
In the magnetic circuit in the figure, the relative with a magnetic permeability of 2000 the cross-sectional area of the core is constant and 1 [m2 ] is. middle arm (AB) Find the magnetic flux.
A ferromagnetic core with a relative permeability of 1500 is shown in the following figure. The depth of the core is 5 cm. Because of fringing effects, the effective area of the air gaps is 5 percent larger than their physical size. If there are 300 turns in the coil wrapped around the center leg of the core, and if the current in the coil is 1.25 A, find the magnetic flux and the field density in all three legs of the core, as well as the magnetic flux and flux density in the two air gaps.
A solenoid similar to the figure below, has a core made of caststeel (refer to the figure on the next slide). It has a cross-sectional area of 4cm2 and a mean length of 20cm. The coil has 100turns, and the coil current is 3.2A. Find the following:a)magnetomotive force, mmfb)magnetic field intensity, Hc)flux density, B (with graph)
An ideal core (assume relative permability is infinity) with a crossectional area of 12 cm2is excited via10A current flowing through coil with 200 turns. On the one side of the coil, a 1 cm long paramagneticmaterial (µr=1) is placed. Calculate the magnetic field on paramagnetic material