at: During this COVID-19 pandemic, how will you design your ideal capacitor which is possible to solve on country's problem regarding the energy crisis? Draw it and write a description about your Own-Designed- Capacitor (ODC): Pandemic Edition.

at: During this COVID-19 pandemic, how will you design your ideal capacitor which is possible to solve on country's problem regarding the energy crisis? Draw it and write a description about your Own-Designed- Capacitor (ODC): Pandemic Edition.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 2PA: You are working in an industrial plant. You have been instructed to double the capacitance connected...

See similar textbooks

Related questions

Q: The Voltage across a capacitor s given Velt)='500teas0ot V. 2500€ as Find the eneray stored in the…

Q: A coaxial cable used in a transmission line responds as a distributed capacitance to the circuit…

Q: 4. Determine the effective resistance of a practical 3H inductor that has 6002 of impedance in a…

Q: Using the 0.68 kilo Ohms, 3.3mH inductance, and 5V source, compute for the theoretical voltages…

Q: 6. An inductive circuit of 50-2 resistance and 0.08-H inductance is connected in series with a…

A: The solution is given below

Q: Find the valves of Resistur, Inductor, and single capacitor.

Q: A series RLC circuit has a resistance of 20 ohms, a capacitance of 102 Farads, an inductance of 10…

A: In the question, A series RLC circuit, Resistance R= 20 ohm Inductance L= 10H Capacitance C= 10-2 F…

Q: Practice Problem 6.8 If the current through a l-mH inductor is i(f) - 20 cos 100r mA, find the…

A: VL=L diL/dt=0.001(-20sin(100t)x100)mv⇒VL=-2sin100t V

Q: Consider an LRC series circuit with a resistance of 2.5 ohms, capacitance of 0.1 farad, an…

A: Assuming, Electromotive force, E(t)=2cost+sint Volts.and, qp(t)=0.05cost+0.2sint

Q: Design a simple charging circuit using a 100 V source, a 1M resistor and a capacitor. The circuit…

A: The capacitor will not reach its final immediately after giving the input it will take five times…

Q: A 5-μF capacitor is charged to 1000 V. Determine the initial stored charge and energy. Ifthis…

A: Write the expression for the initial charge stored on the capacitor.

Q: Discuss pole mounted capacitor bank, enclosed fixed capacitor and enclosed switched capacitor bank.…

A: Pole mounted capacitor bank: Pole mounted capacitor banks are widely used in the distribution system…

Q: 24-μF capacitor has a stored energy equal to 18sin2(11t). What is the current in the capacitor?

Q: The capacitor voltage can be expressed as: vC=q/C, where q is the time-dependent charge in the…

Q: Q13 A variable capacitance and a resistance of 290 2 are connected in series across a 110-V; 60-Hz…

A: In this question, A resistance R= 290 ohm and capacitance C(6uF -32uF) are connected to the voltage…

Q: Directions: Describe the total and individual charge, capacitance, and voltage in a series and…

A: Given, A series and parallel network of capacitors, Where, C is capacitance Q is charge V is voltage

Q: A certain parallel-plate capacitor consists of two plates, each with area 200 cm2, separated by a…

A: If two metal plates are connected across a battery, then due to the charges of plates an electric…

Q: a) A variable capacitance and a resistance of 160 2 are connected in series across a 240-V; 50-Hz…

A: In this question, We need to draw the impedance curve and current locus. We know I= V/Z Z= R-jXc…

Q: 5. A resistance, a capacitor and a variable inductance are connected in series across a 200-V, 50-Hz…

A: We need to find out circuit elements for given circuit

Q: Given that four capacitors can be connected in series and in parallel, find the minimum and maximum…

A: Please refer the attached images for the complete answer..

Q: 33. Value of inductance is usually affected by the following physical dimensions and construction of…

A: As per the guidelines of Bartley we supposed to answer first three questions on in case of…

Q: mine the value of the capacitor C to be connected in parallel with the total load to he PF to unity.…

Q: A 0.68k2 В + 5V 220nF

Q: A design electronic circuit which has capacitor of capacitance 470µF is charged to 20V and connected…

Q: v(t) = -3e-3t V and i(t) = 4 + 2e-3t A fort >0

A: Designing a circuit can be done in multiple way. It is depend on the designer and their knowledge.…

Q: 0 A 4-μF capacitor, a 6-μF capacitor, and an 8-µF capacitor are in parallel across a 300-V source.…

Q: A pure inductance of L = 120 mH is connected to a V = 102 V, 50 Hz supply. The current taken by the…

A: Ohm's law is very important to find the current, voltage, or resistance of a circuit. According to…

Q: 4. A resistor and an inductor are connected in parallel across a 120 V, 60 Hz source. If the total…

Q: Consider a cylindrical transducer making a capacitance of 8 pF, as shown in the figure next. The…

A: Given L1=10 cm C1=8 pF When inner cylinder moves by distance 'X' new capacitance is C2= 5pF New…

Q: Find the energy (in microjoules) stored in the inductor at 5 ms. e.) Find the maximum energy 9in…

Q: Ina transmission line, to reduce the inductive coupling, one should Reduce the inductance None of…

A: In a transmission line inductive coupling depends on distance between the transmission line ,…

Q: ance R4 of ve variable resistance R Balane is obtained with C, = 2. Calculate the capacitance, pewer…

Q: A pure inductance of L = 158 mH is connected to a V = 116 V, 50 Hz supply. The %| current taken by…

A: In this question we need to find a current taken by inductor.

Q: A 0.8-F capacitor is connected in series with a 7-ohm resistor. If the connection is energized from…

A: find the voltage across capacitor at t = 2.5ms ?

Q: An inductor of 5H, a resistor of 20ohms, and a capacitor of 20mF are connected in series with a…

Q: A Capacitor is to be constructed so that its Capacitance is 0.4 μF and to take a PD of 4 KV across…

A: Given: C=0.4μF PD=4KV Safety factor=2 Dielectric strength =40MV/m εr=4

Q: A pure inductance of L = 144 mH is connected to a V = 102 V, 50 Hz supply. The current taken by the…

Q: For the circuit shown below, find an expression for the voltage drop across the inductor after the…

A: Find the current through the inductor for t < 0.

Q: For a resistor, what resistance corresponds to a short circuit? For an uncharged capacitor, what…

A: For short circuit, Resistor The expression of ohm's law is, V=IR, for short circuit V = 0…

Q: What are the minimum and maximum values of capacitance that can be obtained by connecting four 2-μF…

A: Given: The capacitors should be connected is shown as:

Q: Using a simple series circuit with an inductor with inductance L and a resistor, R connected across…

Q: What we are mean by the string efficiency and what you think its value for three insulator string if…

A: Given, for three insulator string The string efficiency is the ratio of the total voltage across the…

Q: Capacitance= 9uF Determine the time constant of the circuit for the capacities.

A: At time t=0, the switch gets closed and the source comes into effect. So the response of system is…

Q: Find the total capacitance. Show complete solution and include the figures used to generate

A: In this question we will find equivalent capacitance....

Q: The capacitor is discharged through a resistor with the resistance R = 10000 Ohm with a relaxation…

Q: 10. A resistor of 50-ohms, inductor of 2-henry and a 0.005-farad capacitor are connected in series…

Q: A capacitor is constructed with parallel metal plates, If the plate separation is 2 mm and the…

Q: 4. When a capacitor, charged to a p.d. of 300 V, is connected to a voltmeter having a resistance of…

Q: Suppose a battery is connected to a parallel-plate capacitor with (infinitely) large plates and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A battery with voltage of 10 V is connected in series with a 50-n resistor to the input of a 50-…

A: Given that, a 10 V battery in series with a 50 Ω is connected to a transmission line that is…

Q: 8.23 At t=0 s, a 100-V source is switched in series with a 1-k2 resistor and an uncharged 2-μF…

A: In this question we will find time required by capacitor to reach it's maximum value....

Q: A capacitor has a capacitance of 10 µF and a phase difference of 10°. It is inserted in series with…

A: Given,Capacitance (C)=10 μF=10×10-6 FPhase difference =10°Voltage =200 VFrequency = 50 HzR=100 Ω

Q: 3_ Google for any catalogue for a power factor correction control and mention the main components of…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

: During this COVID-19 pandemic, how will you design your ideal capacitor which is possible to solve
on country's problem regarding the energy crisis? Draw it and write a description about your Own-Designed-
Capacitor (ODC): Pandemic Edition.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Capacitors are connected, one at a time, to the terminals of a 60-Hz, 12-V power source. Calculate the current through capacitors of capacitance 10-pF.
Find the equivalent capacitance of given circuit between the point A and B) if the applied voltage across A-B, equal =5 VRMS , 1000 Hz. Note: Take the capacitance of each capacitor as C=680µF)
A coil of 20 ohms resistance has an inductance of 0.2 H and is connected in parallel with a 100 microfarad capacitor. Calculate the frequency at which the circuit will act as a non inductive resistance of R ohms. Find also the value of R.
Inductance, Capacitance, and Mutual Inductance d.) Find the energy (in microjoules) stored in the inductor at 5 ms.e.) Find the maximum energy 9in microjoules) stored in the inductor and the time(in milliseconds) when it occurs.D and E only. Thank youuu
A capacitor is rated at 1000uF of capacitance. Ifits minimum value is 850uF, what is its maximumallowable value assuming it has a 15% tolerance?
A 210-microfarad capacitor is connected in parallel with a coil of 25-ohm resistance and 220mH inductance having a supply voltage of 230V, 50Hz. Solve the following: a. Power Factor of the Circuit b. Total Current c. Active/Real Power d. Reactive Power
Capacitance= 4uF , Hence time constant is 5.33μs For the capacity value, calculate the estimated time to come to the final state.Plot capacitor current and voltage graphs and show if it works in harmony with the time constant you calculated. NOTE: if you want you can use falstad online circuit simulator.