At what distance is the target located from a 4–20-mA ultrasonic sensor that produces 12 mA if the zero calibration setting is 2 feet and the span setting is 10 feet? 12mA translates to _____ feet

Q: 1- What does the air volume sensor mean? What are the electrical lines of this sensor, explain? 2-…

A: An air flow sensor is used to measure the flow rate of air entering the fuel injected combustion…

Q: Microwave Oven an open loop or closed loop system?

A: Open Loop System- A control system in which the input of the system does not depends on the output…

Q: 3. In which applications are IA commonly used?

A: An OPAMP(operational amplifier) is an integrated electronic circuit that is used to amplify weak…

Q: Sketch and compare the TNS, TNCS, and TNC earthing regulations as p wiring used to safe guard the…

A: 3)TNCS:- i)T- denotes that the Consumer is Solidly Earthed independently of the Source Earthing…

Q: answer

A:

Q: What happened to the led speed blinking when the delay was changed?

A: /* Blinking LEDs- Program to run that the LED is connected to pin 6 and the delay is one second…

Q: Is it practically possible to maintain | Vs | = | Vr | and | Is |= |Ir | in a transmission system?

A: Transmission line consists of combination of several components like resistance inductance and…

Q: Access to and egress from refer to the actual working space requirements about electrical equipment,…

A: Access to and egress from referring to the actual working space requirements about electrical…

Q: Choose the correct answer:

A:

Q: Draw the block diagram for the light pupil system using close loop system

A: The block diagram for the light pupil is drawn below:

Q: I. Controlling the rate of blinking two LEDS by using Push Button (four rates) Assumptions: 2 Push…

A: 1 controlling the rate of blinking two LEDs by using push button Blinking Two LED’s using arduino…

Q: Draw a simple block diagram of 'Open-Loop Control System' and 'Closed-Loop Control System' Not…

A:

Q: using word,develope a maintenance plan and operating procedure for primary coffee processing plant,…

A: The coffee huller machine is used to grind the coffee beans prevents dust formation and breaks into…

Q: A transfer switch shall be required for all fixed or portable optional standby systems for buildings…

A: According to article 702 - Optional Standby System A fixed or portable optional standby systems…

Q: Sub-Parts A,B and C, have been solved by a Bartleby expert earlier, and told me to post the question…

A: Solution (d)

Q: need

A:

Q: What makes the knowledge of how to read a blueprint so important?

A: Blueprint is the drawing explains ovarall details of the component. It is nothing but a plan A…

Q: Identify the mistakes in the pictures. Explain.

A: Every electrical equipment and devices are represented by the symbols for easy to understandable and…

Q: Explain the principle of the 3-zone directional distance protection. What type of distance replay…

A:

Q: Choose the correct answer. *Please answer it ASAP if you can*

A: Op- amp stands for operational amplifier .It is an electronic device which amplifies a signal .There…

Q: In a signal phase, pedestrians are allowed to cross the street walking in the same direction as…

A: It is given that: Crosswalk length=L=722 ft=36 ftWE=9 ftWE<10 ftδp=4 ft/secNpld=20

Q: Which statements are correct regarding the picture?

A: Image shows Airbus electrical system.

Q: Check the correct statements. * To fly ILS an aircraft must be equipped with an ILS receiver ILS is…

A: Correct statements are:- 1st statement &2nd statement and 4th statement.

Q: using! vision,

A:

Q: For each of the following instructions, indicate the flag condition necessary for each jump to…

A: The solution is provided in the following section.

Q: The minimum burial depth for a Type UF cable feeding a pole light in a residential application is…

A: Section 680.26 in article 680 of the NEC covers this requirement under the installation requirement…

Q: What is  the largest size circuit breaker or fuse permitted to protect this wire

A: Concept: The circuit which is used to electrically describe and model either continuous materials or…

Q: Question 3: why do we use the envelope detector ASK signal?

A: Envelope detector : envelope detector is a electronic circuit that takes a high-frequency amplitude…

Q: Choose correct answer

A: In this answer let us try to understand what is a Zener diode and its special design characteristics…

Q: 14. Severe burns, lung damage, eye damage, and hearing loss are all effects of what event? 8 am…

A: In this question we need to choose a correct option

Q: Which of the following is not a control system? Select the correct answer below: A. Home PC B.…

A: Control system- A control system is basically the interconnection or arrangement of various devices…

Q: What is proximity effect ?

A:

Q: Conclusion:

A:

Q: DISCUSSION

A:

Q: What megaphone is fit and can be installed on tello drone?

A: Megaphone is a device operated by the battery and used for hearing or sending voice on a far…

Q: Plans require the installation of surface-mounted fluorescent luminaires on the ceiling of a…

A: As per the NEC surface-mounted fluorescent luminaires that are to be installed on the low-density…

Q: How are occupants alerted to the presence of carbon monoxide and natural and propane gas

A:

Q: Identify the safety precautions in handling the following: printer, speaker and video doorbell.

A: A safety precaution is methodology of being the doing the work in a right manner  so there in no or…

Q: Do not copy paste from any damn website...I will directly downvote.

A: Using a quantum computer, we can solve this problem with 100% confidence after only one call to the…

Q: It is not uncommon for electrical designers to require an equipment grounding conductor to be…

A: True, Because for each and every equipment there is different grounding required according to the…

Q: Is it correct?

A:

Q: (c) Explain the principle of the 3-zone directional distance protection. What type of distance…

A: Solve the problem

Q: How do you manufacture a special wireless device for security What materials will it be? Use as an…

A: Please find your answer below Consumer and commercial equipment differ in a number of ways;…

Q: Select the best answer from multiple choices:

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 2- What are the conditions that must be met before using the electronic malfunction diagnostic…

A: The conditions that must be met before using the electronic malfunction diagnostic device are:…

Q: The way the avometer works

A: AVO METER-The word  "AVO" means A for ampere that is the measure of electrical current, V for the…

Q: 4. In what segment of the communication field are you interested in working, and why?

A: Communications-electronics (C-E) is a specialist field in telecommunications that deals with the use…

Q: Please provide Handwritten answer Question: NEC Reference  Answer   __________ __________ _____ is…

A: Although,  Patient equipment grounding point is used ,to the eliminate  the electromagnetic…

Wheatstone Bridge Method

A Wheatstone bridge is a circuit used to measure unknown resistance by measuring the ratios of the two branches of the circuit such that each branch has two resistance and out of four resistance one is unknown. The two branches are joined in between with the help of galvanometer which is used to determine the direction of the current. The main advantage of this circuit is that it can provide the most accurate measurement (different from a simple voltage separator).