b) Compute the weight fraction with the data show in Table Q3(b). Table Q3 (b): Compositions of natural gas. Mole Fraction 0.915 0.066 Component Methane Ethane CO₂ H₂S 0.011 0.008 Molecular Weight 16.043 30.070 44.010 34.100

Q: 6. Diffusivity. the diffusivity of volatile solvents is frequently measured using an Arnold cell.…

A:

Q: Air compressor Steam turbine

A: Answer. Data given below:-

Q: 22. Use Hess's law and standard enthalpies of formation to determine the AH for the reaction…

A: The standard enthalpy of reaction using Hess law and standard enthalpy of formation is to be…

Q: Pressures up to 2000 atm are measured with a dead-weight gauge. The piston diameter is 4 mm. What is…

A:

Q: Show that the fugacity coefficient of a real gas in a Multicomponent gas mixture can be expressed as…

A:

Q: In the following reaction, identify the Lewis acid. 3+ Fe³+ (aq) + 6CN¯ (aq) ⇒ Fe(CN)6³- (aq) 3-

A: Lewis acid is the element which accept the electron pair.  Lewis base is an element that donate the…

Q: A fluid whose apparent viscosity increases with shear rate is termed as the fluid. Viscous…

A: Viscosity is a fluid [property. This property studies liquid motion behavior. The measure of the…

Q: In a movie theater in winter, 500 people are watching a movie. The heat losses through the walls,…

A: Given that- Number of persons in theater= 500  Total heat lost in theater, QT= 150,000 Btu/h Since,…

Q: A flue gas is cooled from 950°C to 150°C, and the heat is used to generate saturated steam at 100°C…

A: Given, The heat capacity of the flue gas is, CpR = 3.83 + 0.000551T K-1 The initial temperature of…

Q: centrifuge

A:

Q: Q3: Air at 15°C and 1.05 bar occupies 0.02 m³. The air is heated at constant volume until the…

A:

Q: A 14-m-long settling chamber with a height of 2.5 m operates at a horizontal gas velocity of 1 m/s.…

A: Given data: Height of settling chamber = 2.5 m Length of settling chamber = 14 m Gas velocity = 1…

Q: 1. A bubble of pure CO₂ (0.8cm diameter) is injected into a pool of excess liquid at 25°C. The…

A: Given Bubble of CO2 ,d=0.8cm T=25C P=1atm Diameter of the shrunk bubble=0.2cm after 80 sec…

Q: Three large tanks Contain brine, as shown in the following. Pure water 4 gel Zmin 200 gel 150 gal…

A: Three large tanks contains brine as Develop  a mathematical model for pounds of salt x1(t),x2(t)…

Q: Consider an organism that follows the Monod equation where μmax = 0.5/hr and Ks = 2 g/L. In a…

A:

Q: EXERCISE PROBLEM Pipe Dia=0.25m P=112 KPA Pipe Dia=0.320m P=68% of P@discharge side Flow Rate =…

A: Let's assume fluid is water  Density = 1000 kg/m³ Volumetric Flow rate = 15800 L/min = 0.263 m³/sec…

Q: isothermal CSTR.

A:

Q: The ff. data were collected for the reaction, H₂ (g) + 12 (g) → 2HI (g). Calculate the equilibrium…

A: Write the reaction as follows: H2g + I2g → 2HIg   One mole of H2 reacts with one mole of I2 and…

Q: Propene is burned to form carbon dioxide and water in a batch reactor: 2C3H6+9026CO2 + 6H₂0 The feed…

A: As per bartleby multiple question or subpart question guidelines, we are supposed to answer only…

Q: Consider a reactor (combustor) in which fuel (CO) and oxidizer (H₂O) flow steadily. Both streams are…

A: Write the reaction as follows: CO + H2O → CO2 + H2   One mole of CO reacts with one mole of H2O…

Q: Explain the flow Explain regime in poot boiling?

A: Flow regime in pool boiling is depends on △T  On Heat Flux Q (W/m2) Vs △T  Graph of pool boiling we…

Q: Steam in a piston-cylinder assembly undergoes a polytropic process. Data for the initial and final…

A: Steam undergoes a polytrophic process in a piston-assembly arrangement. The properties at the…

Q: A liquid phase rxn A → 2.5 B occurred in a one-hundred liter constant temperature Continuously…

A: Given data: Volumetric flow rate = 2 L/min Initial concentration of A = 1.75 mM Operating…

Q: composition of the overflow V₁ Schuah

A:

Q: A copper wire is stretched with a stress of 80 MPa at 20°C. If the length is held constant, to what…

A: Given data: Stress at 20 0C = 80 MPa αl for copper = 17×10-6 0C-1 Modulus of elasticity = 110 GPa

Q: expression of the rate law

A:

Q: (b) Use the Routh array to test the stability of a system having the characteristic equation:…

A: Given Data  To check the stability of the following data using the Routh stability Criterion. The…

Q: An equimolar solution of n-heptane and n-octane was subjected to Rayleigh distillation (single…

A: A mixture of n-heptane and n-octane is separated in a differential distillation column.

Q: expression for the overall rate

A: Given, A + B↔ C Rate limiting Step - Desorption Step

Q: bimelecular Rxn

A:

Q: 5. In the following table are listed various aqueous solutions. For one or more of the solutions…

A: As per our guidelines , we are supposed to answer only three sub parts.

Q: Distinguish between ideal gas and liquid phase molecular diffusion. Indicate the cause of such…

A: Diffusion is explained as the process in which the molecules from region of higher concentration…

Q: Use the appropriate property table to fill in the values (letters a to x) in the following table:

A:

Q: Laplace transform to find T (t)

A:

Q: temperature-enthalpy diagram

A:

Q: Calculate the mass of Pb(OH)2 needed to prepare 1.5 L of saturated solution of Pb(OH)2 at 25°C.…

A: Write the reaction for the dissociation of PbOH2 as follows: PbOH2 → Pb2+ + 2OH-      ......1 One…

Q: heat transferred from water to propane

A:

Q: A mixture of gold (p= 19,320 kg/m³), pyrite (p= 5,010 kg/m³), and silica (p=2650 kg/m³) having a…

A: Stoke's law is found to be valid for the given case. Therefore, the terminal settling velocity of…

Q: D: What is the capillary effect? What is its cause? How is it affected by the contact angle?

A: Acc to Bartlebey Guidelines, I have solve only one from the two different Question. Please Send…

Q: A cylindrical tube connects two large gas tanks (Tank-1 and 2). Both tanks contain mixture of carbon…

A: Given Data  The cylindrical tube connects two large tanks (Tank 1 and 2). The tanks contain CO2 and…

Q: The following reaction occurs in a constant - volume batch reactor as follows: A+B=C A → D The…

A:

Q: equilibrium constant of the reaction

A:

Q: 1. What is the work of drying process? a) Decreases the moisture content b) Vaporizes water c)…

A: Answer:1) Drying is a mass switch system consisting of the removal of water or some other solvent by…

Q: calculations to determine the values of (using the data provided for a heat exchanger): a. energy…

A: Given: Heat energy input (Qin) (J) = 600  Temperature (K) Cold = 273, Hot = 450  Exchanger Volume…

Q: Find AS (in J/K) for a reversible isothermal expansion of 0.771 mol of an ideal gas when it expands…

A:

Q: (a) A 66-kg researcher absorbs 5 × 10³ neutrons in a workday. The kinetic energy of each neutron is…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Figure 1 shows a schematic diagram of a flash drum. Steam in the steam coil is used to vaporize part…

A: To control the pressure of the vessel, Control valve 4 can be manipulated. The suitable manipulated…

Q: Calculate the fugacity of propylene at 1250C and 100 atm using Redlich-Kwong equation of state. For…

A: Given T=125C P=100atm TC=365.6 K PC=46.65 bar Find Fugacity of propylene using Redlich-Kwong…

Q: 1. A plunger 250mm in diameter is being pushed at 125mm/sec into a tank filled with oil having S.G.…

A: Given Plunger diameter,d1=250mm Pushed rate,V1=125 mm/s Oil in a tank have SG=0.8 Fluid is…

Q: (b) Figure Q1(b) shows a flowchart of a combustion-condensation process. Each stream contains two…

A: Given, The feed flow rate of unit -1, f= 100 kg/h There are two outlets for unit-1. They are steam-a…