Answered: b) Determine the bit-error probability…

b) Determine the bit-error probability for each the following two modulation schemes: Coherent 8-ary orthogonal FSK with E/N, = 10 dB And coherent 8-ary PSK with E/N,= 10 %3D dB

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

ChapterS: Safety, Basic Electricity And Ohm's Law

Section: Chapter Questions

Problem 8RQ: What is an MSDS?

See similar textbooks

Related questions

Q: Two M-QAM modulation schemes, 16-QAM and 64-QAM, having equal error performance (I.e same value of…

A: According to question we have to, (a). Calculate the E/N, in 64-QAM system. Compare the results.…

Q: Briefly, write the advantages and disadvantages of Delta Modulation ? .Note( Don't copy and paste…

A: Given, Question related to Delta modulation. Please find the below attachment for the clear…

Q: There exist several methods to perform AM demodulation, consider a requirement where we intend to…

A: Synchronous AM demodulation provides some significant improvements over the simple diode detector.…

Q: Q4. a) Consider a bandlimited message signal of 6kHz bandwidth. It is sampled at the rate of 55%…

Q: In a baseband communications link, frequencies upto 3500 Hz are used for signalling. Using a raised…

A: Given a base-band communication link, Frequency used for signalling, W = 3500 Hz The excess…

Q: For over modulation, the value of modulation index m is

A: The correct option along with the explanation is provided in the following section.

Q: B-frames provide obvious coding advantages, such as increase in SNR at low bitrates and bandwidth…

A: B-frames: These are a type of partial frame in compressed video that is generated by referencing…

Q: . Calculate the minimum bilateral Nyquist bandwidth, FN, and baud, for a modulator 8-PSK with 20…

Q: A binary data stream needs to be transmitted at 4 Mbit/s by means of binary signaling. To reduce ISl…

A: The pulse rate for this system is given by, 1T=2fB1+r where, fB=bandwidth1T=Data Rater=roll-off…

Q: List THREE (3) features of baseband transmission.

A: Given: Brief description: In communication system mainly we have two types of communication system…

Q: B) Show how the data rate can be increased from 8 bps/Hz to 32 bps/Hz without increasing the…

A: Data rate- The data rate is define as the quantity of data which is transferred within the…

Q: 7.3-1 Data at a rate of 6 kbit/s is to be transmitted over a leased line of bandwidth 4 kHz by using…

A: The solution can be achieved as follows.

Q: Consider sinusoidal modulation in an AM system. Assuming no overmodulation, what will be the…

Q: What is the ideal percentage of modulation for maxi- mum amplitude of information trans mission?

Q: 5. The frequency range of a BPSK signal extends from 800HZ to 3200HZ. (a) Detemine the Baud rate of…

A: Given frequency range of a BPSK signal is: fmin=800 Hz, fmax3200 Hz Bit rate = 1000 bits/sec;…

Q: Foll owing- CH and m are used to geherate an A Signal the modulation index of the geh AM signal is…

Q: In a binary pulse code modulation system, if the frequency of the baseband signal is 12.5 kHz, then…

A: The given problem is of binary pulse code modulation, firstly the codeword length needs to be…

Q: Q5: An analog signal is first encoded in binary PCM before being transformed to a multilevel signal…

A: It is given that: fm=2700 HzL=7Accuracy=p=1 %=0.01

Q: The bit rate of a digital communication system is R kbit/s and the modulation used is 32-QAM. What…

A: ISI stands for intersymbol interference. It a distortion which takes place during data transmission…

Q: over the sampling (Nyquist) rate. Suppose it used 0.5% as a maximum quantization level error with…

Q: The constellation diagram for a modem that is used for transmission via an analogue channel is shown…

A: The constellation diagram for a MODEM that is used for transmission through an analog channel is…

Q: Show that minimum spacing for non-coherent orthogonal fsk is double than the minimum spacing for…

Q: If the Modulation index is 1, which one is correct O a Since Modulation index is 1, both, Coherent…

A: Given modulation index =1

Q: When the number of bits in a PCM mode, n, is 3, what is the dynamic range in dB?

Q: 1. Which of the linear digital modulation configurations below is spectrally more efficient in terms…

Q: For a 16-QAM modulator with input bit rate fb = 10 Mbps and carrier frequency fc = 60 MHz, calculate…

Q: Draw and show the BFSK modulation waveform for the given binary data sequence “1,0,0,1”, and also…

A: Binary frequency shift keying modulation (BFSK) is a type of frequency shift keying modulation. In…

Q: A PCM binary stream is produced using an 8,000 samples/s rate and 7-bit encoding. 32 synchronization…

A: “Since you have posted a question with multiple sub-parts, we can solve three subparts for you. To…

Q: Exxplain the rellation between BER and E/N_0, where E is the energy per bit, N_0 is the noise…

A: In the digital communication, the normalized signal to noise ratio per bit is given as:

Q: We need to send data 15bits at a time at a bit rate of 9Mbps. The carrier frequency is…

Q: A voice-grade telephone line with bandwidth of 4 kHz (0 – 4kHz) is to be used in full-duplex…

A: Since you have posted multiple questions, we will solve the first question for you. If you require…

Q: In an orthogonal frequency division multiplexing (OFDM) system, if the number of points for IFFT is…

A: In OFDM, multiple closely spaced orthogonal subcarrier signals with overlapping spectra are…

Q: Done El + @ Estimate the percentage change of power for a DSB-SC AM system when the value of the…

A: Given information: For a DSB-SC AM system, the modulation index changes from 0.6 to 0.9. The…

Q: Calculate channel capacity, in bits per second, of a 10-MHz channel with an S/N ratio of 50 dB

A: Here, the given is, B=10 MHzB=10×106 HzSN=50 dB

Q: What is the minimum bandwidth of the PSK modulated signal? and then compare the bit-error…

Q: Consider a bandlimited message signal of 6kHz bandwidth. It is sampled at the rate of 55% higher…

Q: 01: (A): What are the functional elements of the communication system, draw the block diagram and…

A: 1 (A) Communication system: Basically, it is the process of exchanging information between the two…

Q: A carrier signal given by 10cos27Tx108t volt is FM modulated by single tone message 4cos27Tx103t…

Q: What are the Advantages and Disadvantages (Regarding to complexity of implementation , ease of…

A: Disadvantages of DSB FC :- larger bandwidth is required. AM is affected due to noise. Power wastage…

Q: Q1// A carrier signal given by 10cos10000xt volt is AM/DSB-LC modulated by the message signal…

A: 1. It is given that: ct=10 cos10000πt mt=4 cos100πt

Q: 1. What is the B.W of AM? 2. Give the significance of modulation index? 3. What is mean by over…

Q: For 16-PSK and a transmission system with a 10kHz bandwidth, determine the maximum bit rate.

Q: Develop the output equation for the modulation scheme for the 2nd discrete level, if the total…

A: According to the question, we need to develop the output equation for the modulation scheme for the…

Q: For an unmodulated carrier amplitude of 16Vp and a modulation coefficient of m 0.4, determine the…

A: The modulation index is the ratio of amplitude of message signal to amplitude of carrier signal.

Q: NOTES: Answers are QI/ A binary channel with bit rate = 36000 bits per second is available for PCM…

A: The sampling rate must obey the following equation:fs ≥ 2fMfs ≥ 2×3.2×103fs ≥ 6400 Hz ............…

Q: In multiamplitude scheme with M = 16 a) Determine the minimum transmission bandwidth required to…

Q: number of bits if frequencies of A=0.15 and B=0.23 ?

Concept explainers

Fiber Optics

Fiber optics is a technology used to transmit the facts such as light or pulses with fiber or plastic over long distances. Visual fibers are about the width of a human hair strand and, when tied directly to a fiber-optic cable, can transmit multiple long-distance records and faster in different ways.

Question

Digital communications 2

b) Determine the bit-error probability for each
the following two modulation schemes: Coherent
8-ary orthogonal FSK with EN, = 10 dB
And coherent 8-ary PSK with EN,= 10
%3D
dB

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

When the number of bits in a PCM mode, n, is 3, what is the dynamic range in dB?
For the FSK modulation Develop the output equation for the modulation scheme for the 2nd discrete level, if the total number of discrete levels are 6, and the frequency of the modulated signal is given as 3.55 MHz,and power per signal is given as 35 Kilo watt
Exxplain the rellation between BER and E/N_0, where E is the energy per bit,N_0 is the noise spectral density, BER is the bit error rate. What is the reason for usign channel coding?
Fora standard SSBSC carrier AM, the peak unmodulated carrier peak voltage is 10 V for a load resistance of 10 ohms and modulation index of 1. What will be the total transmitted power?
The bit rate of a digital communication system is R kbit/s and the modulation used is 32-QAM. What will be the minimum bandwidth required for ISI free transmission?
A. If the probability of error of BPSK is 0.85 then Pe of BFSK is? B. What happens to the radio wave propagation when the rouefractive index of ionospheric layer becomes low or high? C. If the number of quantization levels are multiplied by four time them how many numbers of bits are added to the actual number? D. What is the disadvantage of wave tilt? E. What is a bipolar line coding technique with phase encoding, and explain why it is named as phase encoding method? F. What is oblique communication circuit? G. What are the differences between DPCM and Delta Modulation? H. What is the change in bandwidth when channel capacity is doubled and two number of bits are increased?
Assume that a voice channel occupies a bandwidth of 4 kHz. We need to combine three voice channels into a link with a bandwidth of 12 kHz, from 20 to 32 kHz. Show the configuration, using the frequency domain. Assume there are no guard bands in computer communication and network?
Consider a bandlimited message signal of 6kHz bandwidth. It is sampled at the rate of 55% higher than the Nyquist rate. The maximum quantization error of the sample amplitude is 0.5% of the peak amplitude? . Assume binary encoding. Calculate the minimum bandwidth ? of the channel to transmit the encoded binary signal.
Given the following binary bit stream, draw the corresponding signal after applying the following encoding scheme: i) MLT-3, ii) B8ZS. 1 0 1 0 0 1 0 1 1 0 0 0 0 0 0 0 0 0 0 1 0 1
Two M-QAM modulation schemes, 16-QAM and 64-QAM, having equal error performance (i.e same value of Pbe). SNR=10 dB in 16-QAM system. (a) Calculate the Eb/No in 64-QAM system. Compare the results. (b) What are the maximum transmission rate (free from ISI problem) in both modulation schemes? Assume B=20 kHz.
Type your question here A carrier signal given by 10 cos 10000 ?? ???? is AM/DSB-LC modulated by single-tone signal 4 cos 100 ?? ????. 1- Calculate the modulation index. 2- Sketch the spectrum of the modulated signal. 3- Calculate transmission bandwidth.
A data of 240 kbps is to be transmitted over a channel of 5 kHz bandwidth. The transmission should be free from the ISI problem. What should be the minimum value of the SNR (in dB unit) if the channel is noisy?