(b) For the network shown in Figure Q1 (b), (i) Identify if the presence of wye or delta network in the circuit. (ii) Determine the total resistance from the terminal a-b. 60Ω 50Ω 20Ω 10Ω 30 Ω 40 Ω 80Ω Figure Q1 (b)

Q: 1000 a 750 500 10A 40V 250 Note that there is no electrical connection at the middle intersection.…

A:

Q: 8 Ω VI www Figure Link 292 W 10 V (+ 4Ω V2 A Calculate V (in volts) in the circuit above using nodal…

A: Given circuit, Ammeter reads, A = 58 A

Q: 6. referring to the circuit below, calculate the effective resistance of this circuit. 70 2 E= 12V =…

A: If two or more resistors (R1, R2, R3, ...) are in series, then the effective resistance (Req) is…

Q: The value of voltage (Vs) in Circuit-B after source transformation from Circuit-A is equal to A A I)…

A:

Q: 1- Calculate the voltage across the dependent source. 20 2420° V VO 2v.

A: Circuit diagram is given as,

Q: Q1 Answer by True or False the following statement 1- Kirchhoff's current law states that the…

A:

Q: The value of voltage (Vs) in Circuit-B after source transformation from Circuit-A is equal to A A 3n…

A: In this question we will do source transformations....

Q: Ql: Calculate the mesh currents i, and i, in circuit below. 3Ω 6Ω + v, 12 V (+ ij 8Ql iz

A: In the given question we note that  Two-loop form in which i1 current flow in the one circuit and…

Q: Use nodal analysis to compute for the voltage across each current source. 20 10 3Ω 5Ω. (1)7A 3 A…

A: Use nodal analysis to find voltage across 3A current source and 7A current source ?

Q: Given the circuit shown, answer the following questions 1 20 ww 8 Ia ww Vs 24/50 V -j40 12 in Ampere…

A: In the circuit,  Find the current I2  voltage V2  The equivalent impedance in ohm.

Q: (B)Using KCL ,find the values of the currents ( I,, I, and dependent current source) in the circuit…

A: The solution can be achieved as follows.

Q: Zvi Reg

A: According to the question we have to find the value of the equivalent Resistance and V1.

Q: Question 3 For the circuit given below a) Determine r, b) Determine Z, and Z, c) Calculate A, and A,…

A:

Q: 3. Determine the value of Vx. 2Vx 12Ω 122 2A Vx 152 ,10Ω 50V

A: We will name the upper two nodes VX and VY while the bottom two nodes will be grounded. We will…

Q: Analyze the circuit diagram shown in Figure 1. 80 A IT Req. 12 82 2Ω 6Ω 3Ω 42 13 Figure 1 [Rajah 1]…

A:

Q: At 315 °K temperature, the voltage equivalent of temperature of

A: Boltzmann's constant is- 8.62×10-5eV/°K=8.62×10-5×1.6×10-19V/°K…

Q: Find Vo using nodal analysis in the circuit shown in Figure 1 2 kn 1 kn 2 kn 1 kn 12 V 3 mA 4 ksa…

A: Redrawing the circuit with labeling all the nodes as shown in the figure below:

Q: - Part A How many 75-W lightbubs, connected to 120 V as in the figure, can be used without blowing a…

A: Given: Voltage = 120 V Maximum current that can flow = 16A Power consumed by single bulb = 75W

Q: Q.2 Answer all the question using Ohm's law, Current divider rule or Voltage divider rule and KVL or…

A: First of all we should simplify the given complex connection of resistances .   For that by solving…

Q: 1. Find the nodal voltages of the circuit shown in Figure 1. 2 Ohms 10!g V, 5 Ohms 15 Ohms 5 A 20…

A:

Q: (c) Determine the equivalent resistance Ray of circuit. 2 ΚΩ 3 ΚΩ Rea 6ΚΩ 3 ΚΩ

A: Given circuit:

Q: Table 1, complete the table below No. Source/ Supply Voltages (V) Vi | Resistor Individual…

A: Note: As per our company guidelines we are supposed to answer ?️only the first 3️⃣ sub-parts. Kindly…

Q: 1002 40e 102 I 5Y, 0.2

A:

Q: 1. Determine the equivalent resistance between the terminals A and B 42 22 6.552 8.66N 132 ww

A:

Q: a) If input voltage = 235Cose of the following figure.2, then draw the voltage curve across the Ri…

A: A Half-wave rectifier is an AC to DC converter. single-phase HWR converts AC voltage into pulsating…

Q: Q.I: A- For circuit of figure 1, determine ky and Vn, and Va B-Sketch the de load line. 22 ka 18 ka…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Q) For the circuit shown, Use Nodal voltage method: 1) Calculate the voltage across 152 resistance.…

A:

Q: 9.2- write 1. The equalization current given circuit- 2. Equalization of voltages for Part 1 of the…

A: In this question, we have to equalize voltage and current...

Q: Determine the equivalent resistance, Req if X=9 b) Determine current i, if "R" is 20 ohms.

A: The solution can be achieved as follows.

Q: Two batteries A and B are connected in parallel; to supply a current of 160 amperes to a load…

A: We need to calculate voltage and power for given circuit .

Q: b) Calculate the following parameters according to the circuit which is given in Figure 2: current…

A: To find the current through R1, R6 and voltage across R3

Q: Q) For the circuit shown, Use Nodal voltage method: 1) Calculate the voltage across 152 resistance.…

A: In this question, we have to calculate voltage across 15 ohm resistance , current through 2 ohm…

Q: 2. Analyse the circuit given in figure 2. Denote every assumption and theorem you use. (B=100) +15 V…

A: We assume that base current very Very Small  So we assume no current flow through the base First we…

Q: the circuit in the figure, the apparent power (S) of the second arm is given as 1490 VA.…

A: Given circuit shown                The apparent power of the second arm is S2=1460 VA

Q: 1. Determine the equivalent resistance between the terminals A and B 452 ww 6.5 8.6612 13 9 13

A:

Q: 1. Calculate for the value of the resistor Rand the voltage Vs. R 20 30 1 A 1 A +1) Vs

A:

Q: In the circuit given below, it is known as ix = 2 A. Calculate the V1 voltage value.

A: Given:-

Q: 1- Calculate the voltage across the dependent source. 20 2420° V VO 2v.

A:

Q: Ql: For the network shown in figure (1), determine the power dissipated by R3 and current passing…

A: In the circuit, independent voltage and current sources are consist.  Find the current in the…

Q: For the circuit of figure 3, make use of the test source method as solution method. 3.1) Calculate…

A:

Q: Q.1: A- For circuit of figure 1, determine Ico and Veno, and Va B- Sketch the de load line. 2.2 k2…

A: We can redraw the circuit as Here emitter current will be IE=-0.7+82.2kIE=3.32mA Since the value of…

Q: In the circuit in the figure, the apparent power (S) of the second arm is given as 1490 VA.…

A:

Q: 2. Use nodal analysis to find the voltage between terminals a,b, current in the 12 ohm resistor and…

A:

Q: 19/ The Impedance in a Circuit determines the amount of Current flowing in the Circuit for any…

A:

Q: . Calculate the short circuit resistor of figure 3 if the load current of 1A . 0.30 3. 0.50 C. 1.40…

A:

Q: b) Calculate the following parameters according to the circuit which is given in Figure 2: current…

A: Given circuit-

Q: Q.1: A- For circuit of figure 1, determine ley and Veso, and Va B- Sketch the de load line. 2.2 k2…

A: For the first step let us apply the KVL in base to Emitter loop ... That's from base TERMINAL to…

Q: Q.1: A- For circuit of figure I, determine ley and Veso, and Va B- Sketch the de load line. 2.2 ka)…

A: Solution : Here we made the DC equivalent of the circut  Then with the help of KVL in base to…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.