i need the answer quickly b. Choose the suitable choice for nine of the following sentences.1. In order to tune a parallel resonant circuit to a lower frequency, the capacitor mustb. Be decrease.c. Be Zero.a. Be increase.di Remain the same.2. In a very low frequency a series resonance circuit behaves as almost purely.......... circuit.c. Inductive.a. Resistive.d. Inductive and capacitive.b. Capacitive.3. Real part of the total impedance at resonance for complicated AC circuit is..........a. Positive Value.b. Zero Value.c. Negative Value.d. Complex value.4. For admittance locus the maximum obtained power factor is depend on:c. Minimum power d. Minimum angleb. Maximum voltagea. Maximum current5. Any non-sinusoidal symmetrical waves are basically composite from fundamental wave plusharmonics waves.b. evenc. odd & evend. odd or evena. odd6.. If we append an inductance in series to an RL series circuit, the time constant will be........c. Increases and Decreases d. Increases or Decreasescircuit.7. The double energy transient occur in the.b. Decreasesa. Increasesa. Purely inductive.b. Resistance and inductance.c. Resistance and capacitance d. Resistance, inductance and capacitance.8. Which among the following is regarded as short circuit reverse transfer admittance?a. Y₁b. Y12c. Y21d. Y 229. The sign of the induced voltage could be determined by the ....... of current in the coil.a. amplitude b. directionc. phased. frequency10. For a 3-phase load balanced condition, each phase has the same value ofa. impedance. b. resistance. c. power factor. d. all of these.of

. In order to tune a parallel resonant circuit to a lower frequency, the capacitor must a. Be increase. b. Be decrease. Remain the same. c. Be Zero. 2. In a very low frequency a series resonance circuit behaves as almost purely........... circuit. d. Inductive and capacitive. a. Resistive. c. Inductive. b. Capacitive. 3. Real part of the total impedance at resonance for complicated AC circuit is........... b. Zero Value. a. Positive Value. c. Negative Value. d. Complex value.

. In order to tune a parallel resonant circuit to a lower frequency, the capacitor must a. Be increase. b. Be decrease. Remain the same. c. Be Zero. 2. In a very low frequency a series resonance circuit behaves as almost purely........... circuit. d. Inductive and capacitive. a. Resistive. c. Inductive. b. Capacitive. 3. Real part of the total impedance at resonance for complicated AC circuit is........... b. Zero Value. a. Positive Value. c. Negative Value. d. Complex value.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

H.W: A resistor of resistance R=1000 2is maintained at 17 °C and it shunted by 100 uH inductor. Determine the ms noise voltage across the inductor over a frequency bandwi dth of: Ans: 182 x10° volt Ans: 9.22 x10 volt Ans: 2.34 x10 volt i) 15.9 kHz ii) i) 159 kHz 1590 kHz
Identify the reason for a nonsinusoidal signal being distorted when it passes through a filter. -The distortion occurs because harmonics are removed or rejected, leaving a different waveshape. -The distortion occurs because harmonics are synchronized, leaving a different waveshape. -The distortion occurs because the signal is modulated, leaving a different waveshape. -The distortion occurs because harmonics are added in the filter, leaving a different waveshape.
H.W: A resistor of resistance R-1000 2 is maintained at 17 °C and it shunted by 100 uH inductor. Determine the rms noise voltage across the inductor over a frequency bandwidth of: i) 15.9 kHz Ans: 182 x109 volt ii) iii) Ans: 9.22 x10-8 volt Ans: 2.34 x10-6 volt 159 kHz 1590 kHz
Calculate the resonant frequency of the median resonator. The value of D2= 6.05 cm, D1= 1.72 cm,Lreal= 1.89 cm and the temperature is 25°. Also obtain the value in units of the frequency ofresonance.
(b) In a filter, explain what happens at the cut–off frequency.
Show the capacitors, whether it is effective at low or high frequencsies Draw low frequency small-signal-equivalent circuit. AND LOWER corner is 82Hz frequency. Design the circuit. Draw the high frequency small-signal-equivalent circuit. AND UP-CORNER İS 172Hz frequency. DESİGN THE CIRCUIT.
6. The response of a band rejected filter is characterized in — — — — —. 4 . c
In the circuit of Figure, the magnitudes of V₁ and V at the resonance are twice L C that of VD. The inductance of the coil for R* 50 Hz is 520⁰ VR www. 502 Vc ell V₁
The resonant converter having fixed value of resonant frequency 48 Hz and capacitance of 2 muF. Find the inductance of this resonant converter a. 2.64 H b. 5.49 H c. 33.12 H d. 34.51 H
The bandwidth of a composite signal is the difference between the highest and a. zero frequency b. lowest frequencies c. two Parallel frequencies d. None of Above
A parallel R-L-C circuit is fed by a constant current source of variable frequency. The circuit resonates at 100 kHz and the Q-factor measured at this frequency is 5. Find the frequencies at which the amplitude of the voltage across the circuit falls to (a) 70.7% (b) 50% of the resonant frequency amplitude.
Discuss the difference between resonant and nonresonant circuits