b. Table 1 shows classification of blood pressure based on the systolic blood pressure (SBP) and diastolic blood pressure (DBP) level and recommendations for follow up defined by The Seventh Report of the Joint National Committee on Prevention, Detection, Evaluation and Treatment of High Blood Pressure. Based on Table 1, write C program to determine blood pressure. This program will read SBP and DBP and display the blood pressure category and recommendation as an output messages. Table 1: Classification of blood pressure and recommendations for follow up based on initial blood pressure measurements for adults. SBP DBP Blood Pressure Recommendation (mm Hg) (mm Hg) Category less than and less than 80 Normal Recheck in 2 years 120 120 – 139 or 80 – 89 Prehypertension Recheck in 1 year High Blood Pressure 90 – 99 Confirm within 2 months (Hypertension) Stage 1 High Blood Pressure 140 – 159 or 160 or 100 or higher Confirm within 1 month (Hypertension) Stage 2 or higher higher than higher than See physician immediately or Hypertensive Crisis 180 110 (Emergency care needed)

b. Table 1 shows classification of blood pressure based on the systolic blood pressure (SBP) and diastolic blood pressure (DBP) level and recommendations for follow up defined by The Seventh Report of the Joint National Committee on Prevention, Detection, Evaluation and Treatment of High Blood Pressure. Based on Table 1, write C program to determine blood pressure. This program will read SBP and DBP and display the blood pressure category and recommendation as an output messages. Table 1: Classification of blood pressure and recommendations for follow up based on initial blood pressure measurements for adults. SBP DBP Blood Pressure Recommendation (mm Hg) (mm Hg) Category less than and less than 80 Normal Recheck in 2 years 120 120 – 139 or 80 – 89 Prehypertension Recheck in 1 year High Blood Pressure 90 – 99 Confirm within 2 months (Hypertension) Stage 1 High Blood Pressure 140 – 159 or 160 or 100 or higher Confirm within 1 month (Hypertension) Stage 2 or higher higher than higher than See physician immediately or Hypertensive Crisis 180 110 (Emergency care needed)

C++ for Engineers and Scientists

4th Edition

ISBN:9781133187844

Author:Bronson, Gary J.

Publisher:Bronson, Gary J.

Chapter7: Arrays

Section: Chapter Questions

Problem 8PP: (Statistical) In many statistical analysis programs, data values considerably outside the range of...

See similar textbooks

Similar questions

(Statistical) In many statistical analysis programs, data values considerably outside the range of the majority of values are simply dropped from consideration. Using this information, write a C++ program that accepts up to 10 floating-point values from a user and determines and displays the average and standard deviation of the input values. All values more than four standard deviations away from the computed average are to be displayed and dropped from any further calculation, and a new average and standard deviation should be computed and displayed.
USE C++ Programming Language Test cases to run and test the program (user inputs are shown in highlight text) Cost-Benefit Analysis (CBA) Calculator) Targeted repayment duration (Year) : 2 Total development cost (Year 0): RM 6600 Accumulated cost (Year 1 until Year 2): RM 2900 Accumulated benefit (Year 1 until Year2) : RM 9700 CBA Result: Expected return/loss RM 6800 3 Profitability Index (PI) 1.0303 Recommendation Good Investment Do you want to continue? (y/n): Y
4754 QUESTION 3 A telco company needs a program that able to identify if the customer is eligible to get a rebate in the next bill cycle. Write a complete C program based on the below requirements: e) Then, read each record of the updated unifi_billFeb.txt from the beginning, then identify if the customer is eligible for a rebate based on the following condition. o If the day of payment for February bill is before 15 of the month, then the customer is entitled with a rebate in the next bill cycle. o Then, display the customer name, customer account no., and subscribed plan to the output screen. o Record the data into rebate_acct.txt. a) Create a structure called Account, and below are the structure members: :name (string) : plan (string) : day (integer) : acctNo (înteger) : billNo (integer) : payment (float) o Customer Name o Subscribed Plan o Day of payment o Account No o Bill No. o Payment amount unifi_billFeb.txt (After Execution) Janet 1023928182 12 0032919992 800-Mbps 369.94 Remy…
USE C++ programming language Besides the main() function, the program needs to define three other functions as described in Table . Use appropriate argument (if necessary) for each function The program needs to print out the following information. Figure shows the example, run of the successful program.i. The team ID.ii. The participant ID.iii. The scores for the five events, E1, E2, E3, E4 and E5 for each participant.iv. The total score for each participant.v. The total score for each team.vi. The winner for individual category (selected based on the highest total score that collected by the participants).vii. The winner for group category (selected based on the highest total score that collected by the teams).viii. Display all of these output in an output file name “output.txt” as well.
Problem 3 Rolling Two Dice (in c language) Write a program that simulates the rolling of two dice. The program should use rand twice to roll the first die and second die, respectively. The sum of the two values should then be calculated. [Note: Because each die can show an integer value from 1 to 6, then the sum of the two values will vary from 2 to 12, with 7 being the most frequent sum and 2 and 12 the least frequent sums.] Figure 6.24 shows the 36 possible combinations of the two dice. Your program should roll the two dice 36,000 times. Use a one-dimensional array to tally the numbers of times each possible sum appears. Print the results in a tabular format. Also, determine if the totals are reasonable; i.e., there are six ways to roll a 7, so approximately one-sixth of all the rolls should be 7.
Practice Question 1 (Using Python) Construct a FLOWCHART for a program that enables a primary school teacher to determine the marks of students who sit for a mathematics quiz. The quiz consists of three multiple-choice questions only. This program will require the student to key in his/her name and ID number. The student will be awarded 10 marks for each correct QI. answer. The program should display the results to the student. The program must use the most suitable data structure to set the questions and answers so that they are immutable. This program does not require the result to be saved in a text file. The printing ofthe result includes student name, student ID, answer for each question, correctness of answer for each question, and total marks for the quiz. The multiple- choice questions to be used for the quiz are shown in Table 1.1. Table 1.1 Question No. Multiple Choice Question Answer Place value ofthe digit '8' in 809 is a. 8 1 C b.80 c.800 d.0 Even number just after 211 is…
Q 4) Write a c# program to calculate and print the bill of a given customer. [2] The customer id., name and unit consumed by the user should be taken from the keyboard and display the total amount to pay to the customer. The charges are as follow: Unit Charge/unit upto 199 @1.20 200 and above but less than 400 @1.45 400 and above but less than 600 @1.70 600 and above @2.50 If bill exceeds Rs. 400 then a surcharge of 16% will be charged and the minimum bill should be of Rs. 150/=
b) Write a C++ program segment that determines the entrance fee for Muzium Negara based on the following table. Children Local RM5 Adult Category Citizenship Rate Foreigner RM13 Local RM10 Foreigner RM18 (6 marks)
1. create a scenario that you will use to design (using function tables and flowcharts) and write a Python application. Your scenario should be complex enough that it requires two to five functions. 2.Create an IPO chart to describe the solution to your posed problem. Be sure to break each part of the problem down as much as possible and use this area to assign function names. 3. Create a function table to include a row for each identified function. Note: the final two columns MUST include datatype and purpose for any values. 4. Create flowcharts for each function described in the function table 5. Provide the Python code that implements the IPO chart and flowcharts you have created. Include a screen shot of the file window AND of the IDLE window containing the output
Using C Code A. Write a program that contains a global structure variable that is initialized to hold your first name, your last name, your lucky non-whole number (e.g. 26.5), your major, and a listing (an array) of your six most favorite college courses you have ever taken or plan to take. Then your program should access and print the stored data. B. Print the data twice -Once using the structure variable and do-while loop -Second using a pointer variable and a while-do loop
University of Babylon College of Information Technology Department of Information Security Programing Fundamentals C++, First Stage Assignment (2) / Due Date March 1,2021: 12pm Q1. Write a program to read one mark of a student from keyboard and check whether the student is pass or fail, then print "pass" if the mark is greater than or equal to 50 and print "fail" if the mark is less than 50. Q2. Write a program to read three numbers from keyboard and find out the maximum out of these three numbers (using nested if-else). Q3. Write a program to read marks from keyboard display equivalent grade cording to the following table. (using if-else if leader). Iyour program should Grade Distinction Marks 100 - 80 60 - 79 First Class 35 - 59 Second Class 0- 34 Fail Q4. Write a program to read a number in the range from 1 to 7 and accordingly it should display MONDAY to SUNDAY (using if-else-if leader). Q5. Write a program to read number for keyboard and check whether the given number is positive,…
2. Create a C function type of double to process weekly employee time cards for all employees of an organization. Each employee will have three data items: an identification number, the hourly wage rate , and the number of hours worked during a given week .  Each employee is to be paid time and a half for all hours worked over 40.  A tax amount of 4% of gross salary will be deducted. The program output should show the employee’s number and net pay.