BA certain op-amp has an open-loop gain of 80,000. The maximum saturated output levels of this particular device are + 12 when the de supply voltages are +15. If a differential voltage of 0.15 mV rms is applied between the inputs, what is the peak-to-peak value of the output?

BA certain op-amp has an open-loop gain of 80,000. The maximum saturated output levels of this particular device are + 12 when the de supply voltages are +15. If a differential voltage of 0.15 mV rms is applied between the inputs, what is the peak-to-peak value of the output?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.3P

See similar textbooks

Related questions

Q: 3F roblem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

Q: A differential amplifier has a differential gain of 500 and negligible common-mode gain. The input…

Q: For the op-amp shown, all transistors have B= 100, VBE = 0.7 V, and VA= 60 V. The %3D output…

A: Given:β=100, VBE=0.7V, VA=60VRo=∞, RL=1.2kΩa Total gainVQ1=VBEVAVBE+VA V1 =0.76060.7 V1VQ1=…

Q: Note: Consider ideal OP Amps I. ww 260KSL Vi ww ww 4mv by Volvi DETERMINE Auf. vo%v:

A: In this question, Find the voltage gain if all op amplifier is ideal. Av=Vo/Vi

Q: 1) a. A is a special case of the non-inverting amplifier in which the feedback resistance is 0 and…

Q: 4. (a). (b). Operational amplifiers (op-amps) are used in integrated circuits for signal…

A: Given a circuit of an operational amplifier as shown below. Find State characteristic of the ideal…

Q: QI/Explan the method to compensation of bias current, offset voltage,0ffset current and maximum…

A: OPERATIONAL AMPLIFIER (OP-AMP) : Operational amplifiers are linear devices with all of the…

Q: Draw the circuit of a V-I converter and derive an expression for the output current in terms of…

A: V-I CONVERTER : A voltage to current converter (V to I converter) is an electrical circuit that…

Q: 1. The op-amp in the circuit is ideal, except for non-zero input bias currents. Further, R1 =10K and…

A: In this question we will find R3 value for given opamp....

Q: 2.23 Show that for the inverting amplifier if the op-amp gain is A, the input resistance is given by…

A: The derivation for Rin is as follows.

Q: Q1 / Find the range of the output voltage for an inverting op - amp if the implication factor is…

A: Given, Implification factor A=0.85 Input voltage ranges from (1-6) V

Q: Show the connection of two op-amp stages using an LM358 IC to provide outputs that are -25 and 40…

A: The required circuit can be designed by cascading inverting and non-inverting amplifiers. The…

Q: An op-amp has a slew rate of 0.8 V/us. What is the maximum amplitude of undistorted sine wave that…

Q: An inverting op amp has Rf= 500kohm and R1= 5kohm. Determine the op amp circuit voltage gain, input…

Q: An OP-AMP has a slew rate of 1 V/u sec with a gain of 40 decibel. If this amplifier has to…

Q: SPECIFICATION IDEAL OP AMP HA 741 Input Resistance (Typical) Output Resistance (Typical) Voltage…

Q: Draw a circuit diagram of a 311 op-amp showing an input of 10 V as with f= 1KHZ, applied to the…

A: Given data : Vin=10Vf=1KHzRefrence voltage applied to 2Vref

Q: A single-pole op amp has an open-loop gain of 95 dB and a unity-gain frequency of 2 MHz. (a) The op…

A: Given f=2 MHz Calculating angular frequency ωT=2πfωT=2π2 MHzωT=4×106 π

Q: A noninverting ampliﬁer is designed with R1 = 1kΩ, R2 = 39 kΩ, and an op amp with an open-loop gain…

A: Given R1=1 kΩR2=39 kΩA=80 dB The feedback factor for the non-inverting amplifier is given by…

Q: List the imperfections of real op amps in their linear range of operation

A: The imperfections of real op-amps are listed below, The input impedance of real op-amp is not…

Q: In the experiment (Differential amplifier) answer the following: Theoretical Calculations: 3. What…

Q: Considering the amplifier gain 13 and the number 2 as N, design a Wien Bridge oscillator circuit…

Q: When 100 V and 20 V are applied to the non inverting and the inverting terminal of open loop an…

A: For an open-loop operational amplifier, if Ad and Ac represents the differential gain and…

Q: A measurement of open loop gain of op-amp at very low frequency shows it to be 86 dB; and at 100…

Q: In inverting amplifier, if the input signal is .9 1000mVpp, output signal is 4Vpp, and feedback…

Q: Here is a single op-amp, shown under two different conditions (different input voltages). Determine…

Q: A noninverting ampliﬁer is built with 0.01 percent precision resistors and designed with R2 = 99R1.…

A: For an ideal op-amp, the voltage gain is, Av=1+R2R1 The nominal value of voltage gain is given by…

Q: Assuming ideal op amps, find the voltage gain of each of the circuit

Q: For an operational amplifier, the differential gain and the common mode gain is 5555 and 5…

A: An operational amplifier is basically a differential amplifier. This means that the differential…

Q: In an inverting op-amp, has the following. Rf=20K, R1=5K and Vin=3 volts. What is the gain of this…

Q: A certain op-amp has an open-loop gain of 80,000. The maximum saturated output levels of this…

A: Op-amps are used in a good kind of applications in physical science. a number of the additional…

Q: TRUE OR FALSE 1. Due to the infinite open-loop volatge gain of an ideal op-amp, its diferrential…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: A If an op-amp has a slew-rate of 5 V/us, find the Maximum bandwidth for a peak outpu voltage of:…

A: Given Data" Slew rate = 5 V / uS slew rate determines the limit for large signal bandwidth

Q: Draw the diagram of a 741 op-amp operated from {15-V supplies with Vi(-) = 0 V andVi(+) = +5V.…

A: Amplifier is an electronic device whose output is amplified version of the input signal. The…

Q: In the voltage regulator circuit shown in the figure, the op-amp is ideal. The BJT has VBE=0.7 V and…

A: The given problem is from voltage regulator. The calculation is shown in the next step

Q: An op-amp is connected to power supplies so that its Vcc value is 15V. It has an open-loop gain of 8…

A: From the basics of OP - AMP

Q: 1. The op-amp in the circuit is ideal, except for non-zero input bias currents. Further, R1 =10Kand…

Q: for the Operational Amplifier shown below, given that the input signal is a sine wave, if the…

A: The solution is given below

Q: 3F roblem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

Q: Calculate the time taken by the output to swing from +14v to -14v for a 741C op-amp having a slew…

A: Slew rate can be defined as the change in the output voltage when there is an abrupt or sudden…

Q: draw the block diagram of op-Amp

A: The general Op-amp has four stage and the all the four stages in order are given below: Dual input…

Q: Find the gain of op-amp:

Q: Assuming ideal op amps, find the voltage gain vo/vi

Q: Draw the diagram of a 741 op-amp operated from {15-V supplies with Vi(-) = 0 V and Vi(+) = +5 V.…

A: Given, V_ = 0 V+ = 5 V Power supply is 15 V

Q: Q4: Consider the uA741C-based op-amp amplifier circuit shown below; The input voltage, Vi, is 2.5…

A: Given data R1=1000 R2=5000 Vi=2.5

Q: An inverting op amp has Rf= 600kohm and R1= 6kohm. Determine the op amp circuit voltage gain, input…

A: From the above question given data is as follows:

Q: 6. A. Make a sketch of the output voltage, vo, verses time in the circuit below assuming that the op…

Q: Select true or false for 1 and 2 1 Op amp component is temperature limited due to maximum output…

A: Op-amp is an operational amplifier that performs arithmetical operations like addition, subtraction,…

Concept explainers

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.

Question

BA certain op-amp has an open-loop gain of 80,000. The maximum saturated output levels of this particular
device are + 12 when the de supply voltages are ±15. If a differential voltage of 0.15 mV rms is applied between
the inputs, what is the peak-to-peak value of the output?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For an op-amp having a slew rate of SR=3.6 V/us. What is the maximum voltage gain that is used when the input signal varies by 4.4 v in 9 us?
Don't copy from internet What are the functional differences between an inverting and non-inverting op-amp?
What is the maximum peak-to-peak output voltage for a 741 op-amp with ±15 V power supplies? How small a load resistance will this amplifier drive with its output at the maximum level? ANSWER: Rmin = 560 ohms
In an inverting op-amp, has the following. Rf=20K, R1=5K and Vin=3 volts. What is the gain of this Amplifier?
Given a non inverting op – amp below, If the normalize gain is 34, calculate the (AVH) igh frequency gain in dB.
For the circuit shown below, if the differential gain (?? ) of the op-amp is (50000) and the CMRR in (db) is (34). Find the output voltage (v_out).
Based on the simulation’s results, explain the function of a differential amplifier. (Hints: comment on the shape of Vo1 and Vo2, explain what would happen if V1 and V2 were the same, reflect on why it is important that an ideal op-amp has infinite input impedance).
İf we have inverting op-amp, find the value of Vin, Iin, I1 and If. Assume R1 = 10 K, Rin = Rf = 1M, Av=250000 and Vo= -5 V
A differential amplifier has a differential gain of 500 and negligible common-mode gain. The input terminals are tied to ground through 1-kΩ resistors having tolerances of ±5 percent. What are the extreme values of the output voltage caused by a bias current of 100 nA? What is the output voltage if the resistors are exactly equal?
For the ideal op-amp shown, what should be the value of resistor Rf (in kilo Ohms) to obtain a gain of 55? No need for a solution. Just write your numeric answer (without the unit) in the space provided. Round off your answer to 2 decimal places.
the output of an op amp is affected by the input offset voltage,input offset current, input biassing current , the power supply,input frequency?? ( true or false) and why ?
The common-mode gain, ACM, of an op-amp with AOL = 196,848 and a CMRR of 73 dB is?